溶剂热法制备纳米氧化镍及其表征

以乙酰丙酮镍、油酸、油胺为原料，十八烯为溶剂，聚乙烯吡咯烷酮为表面活性剂，采用溶剂热法，在不同反应条件制备了纳米级氧化镍材料.通过X射线衍射（X-ray diffraction，XRD）、透射电子显微镜（Transmission electron microscope，TEM）、紫外-可见光吸收光谱（Ultraviolet-visible spectroscopy，UV-Vis）光谱分析以及塔菲尔（Tafel）测试考察了反应物比例、保温时间、表面活性剂（PVP）、油胺的量对产物微结构、粒径、形貌、光学以及电化学活性性能的影响.实验结果表明：在反应物n[Ni（acac）₂]∶n（OA）=1∶2、添加剂PVP质量分数为1.66%、油胺物质的量为30 mmol、200℃下保温8 h时，可获得粒径约为30～40 nm纯相氧化镍，具有最佳电化学活性，交换电流密度为J₀=1.23×10^-2 mA·cm^-2.     

Synthesis of porous vinylnaphthalene/divinylnaphthalene copolymers and their sorptive properties towards phenol and its derivatives

Four porous vinylnaphthalene/divinylnaphthalene (VN/DVN) polymers having three different nominal crosslinking degrees (60, 80 and 100 wt.%) have been synthesized using the suspension polymerization method in the presence of toluene and decane.The use of various crosslinking levels and inert diluents was aimed at changing the extent of polymeric network-diluent interactions. The resultant polymers have specific surface area in the range 450-700 m²/g depending on the DVN content. Two sets of pores were detected in all resins: one with the diameter of ≈2 nm and the second one in the range of 30-40 nm. Their sorptive properties have been studied using dilute (0.5 mmol/l) solutions of phenol and its derivatives (o-chlorophenol, 2-methylphenol, o-nitrophenol, m-nitrophenol and p-nitrophenol). It has been found that sorption, at low equilibrium concentration, follows the order: o-nitrophenol > o-chlorophenol > m-nitrophenol > o-methylphenol > p-nitrophenol > phenol. Full characteristics of the porous structure of resultant polymers was obtained by nitrogen adsorption at 77 K and their surface properties analyzed using Inverse Gas Chromatography.     

超声波处理对球形β-Ni(OH)2结构及电化学性能的影响

A method of ultrasonic treatment （UST） was first used to modify the structure and electrochemical performance of nickel hydroxide for the active material of nickel series alkaline batteries. The experimental results showed that UST was an effective method to improve the electrochemical performance of β-Ni（OH）2 such as specific discharge capacity, discharge potential, electrochemical reversibility and oxygen evolution over-potential. The results of electrochemical impedance spectroscopy, powder X-ray diffraction and particle size distribution indicated that the improvement of the performance of β-Ni（OH）2 through UST was attributed to the reduction of the charge-transfer resistance （Rt） and the diffusion impedance （Zw）, which resulted from the decrease of the crystallite and particle size and the increase of interlayer spacing. Diffusion coefficient of proton DH of ultrasonic treated β-Ni（OH）2 gained by CV tests was 1.13 × 10^-11 cm^2/s, and the average discharge specific capacity of ultrasonic treated β-Ni（OH）2 electrode was 301 mAh/g.     

尼龙6与半芳香性非晶尼龙原位共混物的结构与性能

一种半芳香的非晶尼龙共聚物溶解于熔融的己内酰胺中,引发后者负离子开环聚合原位制备尼龙6与非晶尼龙的共混物.与纯尼龙6相比较,此原位共混物的强度与模量显著提高.非晶区呈现单一的玻璃化转变,表明共混物为均相体系,其组分的相容性源于负离子聚合过程中链交换反应引起的共聚.与纯尼龙6相比较,此共混物的熔点与结晶度显著降低.此外,与纯尼龙6只存在α晶不同,共混物中伴生有大量的γ晶.当非晶尼龙含量为20 wt%时,绝大部分晶体为γ晶.然而,共混物中球晶仅有一定程度细化.共混物强度和模量的提高被认为主要源于非晶区分子活动能力降低以及γ晶相对含量的提高.     

The Electrochemical Behavior of α‐Ketoglutarate at the Hanging Mercury Drop Electrode in Acidic Aqueous Solution and Its Practical Application in Environmental and Biological Samples

The voltammetric behavior of α‐ketoglutarate (α‐KG) at the hanging mercury drop electrode (HMDE) has been investigated in acetate buffer solution. Under the optimum experimental conditions (pH 4.5, 0.2 M NaAc‐HAc buffer solution), a sensitive reductive wave of α‐KG was obtained by linear scan voltammetry (LSV) and the peak potential was ?1.18 V (vs. SCE), which was an irreversible adsorption wave. The kinetic parameters of the electrode process were α=0.3 and k_s=0.72 1/s. There was a linear relationship between peak current i_{p, α‐KG} and α‐KG concentration in the range of 2×10^?6–8×10^?4 M α‐KG. The detection limit was 8×10^?7 M and the relative standard deviation was 2.0% (C_α‐KG=8×10^?4 M, n=10). Applications of the reductive wave of α‐KG for practical analysis were addressed as follows: (1) It can be used for the quantitative analysis of α‐KG in biological samples and the results agree well with those obtained from the established ultraviolet spectrophotometric method. (2) Utilizing the complexing effect between α‐KG and aluminum, a linear relationship holds between the decrease of peak current of α‐KG Δi_p and the added Al concentration Cequation/tex2gif-inf-5.gif in the range of 5.0×10^?6–2.5×10^?4 M. The detection limit was 2.2×10^?6 M and the relative standard deviation was 3.1% (Cequation/tex2gif-inf-6.gif=4×10^?5 M, n=10). It was successfully applied to the detection of aluminum in water and synthetic biological samples with satisfactory results, which were consistent with those of ICP‐AES. (3) It was also applied to study the effect of Al^III on the glutamate dehydrogenase (GDH) activity in the catalytically reaction of α‐KG+NH +NADH?L ‐glutamate+NAD⁺+H₂O by differential pulse polarography (DPP) technique. By monitoring DPP reductive currents of NAD⁺ and α‐KG, an elementary important result was found that Al could greatly affect the activity of GDH. This study could be attributed to intrinsic understanding of the aluminum's toxicity in enzyme reaction processes.     

Determination of selenium, zinc and cadmium in antidandruff shampoos by atomic spectrometry after microwave assisted sample digestion

Microwave assisted pre-treatments for atomic spectrometric determination (inductive coupled plasma-optical emission spectrometry, ICP-OES or flame atomic absorption spectrometry, FAAS) of metallic elements, usually present in antidandruff shampoos, are proposed. They are based on the digestion of the sample with HNO₃ into a closed reactor, which is irradiated at 800 W for a few minutes. Selenium was determined by ICP-OES. The limit of detection was 0.11 mg l⁻¹; the relative standard deviation (R.S.D.) for the selenium content in the samples was in the 0.6–3.6% range. The results obtained were in agreement with the label contents and the recovery of the proposed method was in the 100–106% range. Zinc and cadmium were determined by FAAS. The limit of detection for zinc determination was 0.078 mg l⁻¹; the R.S.D. for zinc contents was in the 0.8–8.6% range. A limit of detection of 0.09 mg l⁻¹ was obtained for cadmium determination; the R.S.D. for cadmium contents was in the 0.7–2.7% range. The determinations were performed after two different sample mineralization pre-treatments — dry ashing (in an electric furnace) and wet mineralization (in a microwave oven). Both methodologies provided comparable results for zinc and cadmium determination in shampoos. The proposed microwave assisted digestion procedures allow a precise and accurate determination of selenium, zinc and cadmium in commercial antidandruff shampoos, and the sample pre-treatment is less time-consuming than the classic methods.     

Comparison of purge and trap GC/MS and spectrophotometry for monitoring petroleum hydrocarbon degradation in oilfield produced waters

Results of using a field spectrophotometer and its appropriate protocols as a surrogate method for an oilfield produced water treatment process is presented. Methylene chloride extractions of the produced water before and after treatment maintained a yellow color pigment that was directly proportional to the hydrocarbon concentration. From this, an absorption spectrum and standard curve were developed. A resultant linear plot of the standard curve indicated that there is an excellent correlation (r²=0.9847) between the varying concentrations and the associated absorbance values at a wavelength of 400 nm. Total n-alkane concentration comparisons between the laboratory GC/MS analysis and the spectrophotometry analysis generated data of similar accuracy and precision at concentrations ranging from 1 to 137 mg/l (alpha=0.05). Linear comparisons between GC/MS and spectrophotometric coefficients were near unity, with the constant being near zero, with a correlation coefficient (r²) of 0.99. Based on this study, spectrophotometry is a complimentary method to GC/MS for determining total n-alkane concentrations in oilfield produced water samples.     

High throughput screening of O-glycosylation conditions

We report a novel methodology for rapid and quantitative screening of O-glycosylation reactions of application to the analysis of parallel reaction systems. Our system exploits perdeuterated benzyl (Bn-d₇) ether, and stereoselectivity and yield are evaluated by ¹H NMR and MALDI-TOF MS, respectively. This paper summarizes over 240 screenings of 1 → 3 linkage formation between glucose residues targeting the α-isomer in high yield.     

吡咯和呋喃气相质子化过程的密度泛函理论研究

Density functional theory and ab initio calculations have been used to determine structures and stabilities of the protonated aromatics species AH^＋ and AH2^2＋ （A=pyrrole, furan）. Possible mechanisms and relative energetics for protonation of pyrrole and furan by H3O^＋ and AH^＋ in the gas phase have been explored. Calculations show that the Cα-protonated species was the most stable structure for AH^＋, and the protonated AH^＋ might accommodate the second proton to yield AH2^2＋ if the free proton was available. The gas-phase H3O^＋ could protonate pyrrole and furan with significant exothermiCity and almost without barrier. The proton transfer from AH4^＋ to pyrrole and furan has a barrier ranging from 33.5 to 39.3 kJ/mol in the gas phase.     

The structure of fullerene films and their metallocene doping

Hexagonal close-packed (HCP) C₆₀ and C₇₀ films have been prepared by the Langmuir method and examined by electron microscopy and electron-diffraction analysis. It has been shown that the vacuum deposition of a C₆₀+C₇₀ mixture results in the formation of a film with small sized grains and a distorted C₆₀-HCP structure. The simultaneous deposition of C₆₀ and ferrocene results in the formation of a film with a changed morphology and an electron-diffraction pattern that contains a variable amount of ferrocene depending on the experimental conditions. The electron-diffraction pattern corresponds to the presence of the known molecular complex C₆₀[(C₅H₅)₂Fe]₂. The analogous simultaneous deposition of fullerene C₆₀ and cobaltocene results in the formation of a C₆₀ film stable in air and water, which contains carbon and cobalt (from the data of X-ray fluorescence, electron microscopy and microdiffraction). It has a different morphology and different diffraction patterns than pure C₆₀ films and, depending on the cobaltocene content (relative to that of fullerene), appears to be a fullerite film doped with various amounts of cobaltocenium fullende, which is an ionic compound.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1379–1383, August, 1994.The work was financially supported by the Russian Foundation for Basic Research (Projects 93-03-4676 and 93-03-18368).