Distribution behavior of some drug enantiomers in an aqueous two-phase system using counter-current extraction with protein

Summary The partial resolution of some drug enantiomers by counter-current extraction in an aqueous two-phase system using bovine serum albumin (BSA) or ovomucoid (OVM) as chiral discriminator is described. The phase system was prepared with dextran 40, polyethylene glycol and a protein. Ofloxacin (OFLX) enantiomer was well recognized by the BSA system, whereas the enantiomers of carvedilol (-blocker) and DG-5128 (a new oral hypoglycaemic drug) were hardly recognized by the OVM system. The distribution coefficients of (S)-, (R)- and rac-OFLX varied with pH. Good enantioselectivity for OFLX was obtained at relatively high pH ( pH 9). The crude optically enriched OFLX enantiomers were extracted from the aqueous fractions and finally purified by thin-layer chromatography.     

Infrared investigation of aluminum- and chromium-substituted magnetites and of the lacunar spinels resulting from their oxidation

When Fe³⁺ ions are substituted by aluminum or chromium on magnetite octahedral sites, the ir spectrum shows the conversion of an inverse spinel to a normal spinel. Both broad bands of magnetite are gradually replaced by the four characteristic bands of normal spinels II–III. They are also observed for solid solutions, FeCr₂O₄FeAl₂O₄, with, however, a further band at 780 cm^?1 which may be assigned to Al³⁺ ions on tetrahedral sites. Low-temperature (<400°C) oxidation of these compounds whose sizes are less than 2000 Å results in lacunar spinels III–III. The ir spectrum of these solids is characterized by two absorption bands (as for inverse spinels II–III) except for compounds close to pure γFe₂O₃ in which an order of vacancies could be put in evidence.     

2-[6-Alkyl-3-hetaryl-4-oxo-9,10-dihydro-4H,8H-chromeno-[8,7-<Emphasis Type="Italic">e</Emphasis>][1,3]oxazin-9-yl]acetic acids

The interaction has been studied of a series of substituted 3-hetaryl-7-hydroxychromones with amino acids and formaldehyde (reactants ratio 1: 1: 2 respectively). In the case of glycine and Het = 3-isoxazolyl the product of aminomethylation at position 8 of the chromone was obtained, and with other Het (including Het = 4-phenyl-1,2,4-triazol-3-yl) 2-[6-alkyl-3-hetaryl-4-oxo-9,10-dihydro-4H,8H-chromeno[8,7-e][1,3]-oxazin-9-yl]acetic acids were formed. With β-alanine and Het = 4-phenyl-1,2,4-triazol-3-yl the corresponding β-substituted propionic acid was synthesized, but proline did not participate in the reaction, leading to bis(6-ethyl-3-hetaryl-7-hydroxychromon-8-yl)methane. __________ Translated from Khimiya Geterotsiklicheskikh Soedinenii, No. 5, pp. 683–689, May, 2007.     

AES investigations on starting powders for high performance ceramics

AES depth profiles on ceramic powders (untreated/hydrolyzed/oxidized/ (Al, Y)₂O₃ coated Si₃N₄, [BaO, SiO₂] coated Al₂O₃) are feasible on thin, homogeneous layers or m sized agglomerations prepared on an Au foil. By means of the depth profiles one can qualitatively characterize the coating around the particles. Factor analysis of the depth profiles on the differently treated Si₃N₄ powders suggests the existence of an Si₂N₂O phase on the oxidized sample.Dedicated to Professor Günther Tölg on the occasion of his 60th birthday     

The reaction of phenylarsenazo with chromium(III)

The conditions for the reaction between phenylarsenazo (PAA) (2-[(2-arsonophenyl)azoj-7-(phenylazo)-1, 8-dihydroxynaphthalene-3,6-disulphonic acid) and chromium(III) have been studied. A blue 1:1 complex is formed at pH 2.2 on heating the reactants at 100 degrees for 15 min. It has maximum absorption at 635 nm and is stable for at least 24 hr. The molar absorptivity is 3.3 x 10(4) 1.mole(-1).cm(-1). Beer's law is obeyed in the chromium concentration range 0-1.4 mug ml . The reaction has been successfully applied to determination of chromium in alloy steel.     

Quo Vadis total reflection X-ray fluorescence?

The multielement trace analytical method ‘total reflection X-ray fluorescence’ (TXRF) has become a successfully established method in the semiconductor industry, particularly, in the ultra trace element analysis of silicon wafer surfaces. TXRF applications can fulfill general industrial requirements on daily routine of monitoring wafer cleanliness up to 300 mm diameter under cleanroom conditions. Nowadays, TXRF and hyphenated TXRF methods such as ‘vapor phase decomposition (VPD)-TXRF’, i.e. TXRF with a preceding surface and acid digestion and preconcentration procedure, are automated routine techniques (‘wafer surface preparation system’, WSPS). A linear range from 10⁸ to 10¹⁴ [atoms/cm²] for some elements is regularly controlled. Instrument uptime is higher than 90%. The method is not tedious and can automatically be operated for 24 h/7 days. Elements such as S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Co, Ni, Cu, Zn, As, Br, Sn, Sb, Ba and Pb are included in the software for standard peak search. The detection limits of recovered elements are between 1×10¹¹ and 1×10⁷ [atoms/cm²] depending upon X-ray excitation energy and the element of interest. For the determination of low Z elements, i.e. Na, Al and Mg, TXRF has also been extended but its implementation for routine analysis needs further research. At present, VPD-TXRF determination of light elements is viable in a range of 10⁹ [atoms/cm²]. Novel detectors such as silicon drift detectors (SDD) with an active area of 5 mm², 10 mm² or 20 mm², respectively, and multi-array detectors forming up to 70 mm² are commercially available. The first SDD with 100 mm² (!) area and integrated backside FET is working under laboratory conditions. Applications of and comparison with ICP-MS, HR-ICP-MS and SR-TXRF, an extension of TXRF capabilities with an extremely powerful energy source, are also reported.     

Effect of 1,1,2,2-tetrachloroethane on IR spectra of HCl complexes withN,N-dimethylformamide and 1-methyl-2-pyrrolidone formed by a strong quasi-symmetric hydrogen bond

The effect of 1,1,2,2-tetrachloroethane (TCE) on the IR spectra of HCl complexes withN,N-dimethylformamide (DMF) and 1-methyl-2-pyrrolidone (N-MP) with strong quasisymmetric hydrogen bonds was studied using Multiple Attenuated Total Reflection (MATR) IR spectroscopy. The addition of TCE does not change the background absorption spectra, but results in a change in the extinction coefficients of some bands of these complexes. The analysis of the spectra shows that the HCl−DMF complexes interact only with one molecule of TCE, and the HCl−N-MP complexes interact with two molecules of TCE. It is shown that the neutral component of the system (TCE) has no effect on the parameters of the strong quasi-symmetric H-bond in the complexes studied. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 956–960, May, 1997.     

The electronic structure of molecules by a many-body approach

The vertical valence ionization potentials of cyclopropane, ethylene oxide and ethylene imine are calculated by a many-body Green's function method. For C₃H₆ the ordering of the ionization potentials is 2e(), 1e(), 2a₁(), 1a₂(), 1e(). The assignment of the 2a₁ and the 1a₂ ionization potentials which has been controversial is thus clarified. The ordering is in agreement with the result obtained via Koopmans' theorem. For ethylene oxide and ethylene imine Koopmans' theorem fails in predicting the correct order of ionic states. For C₂H₄O the ordering of the ionization potentials is 2b ₁(), 4a ₁, 1a ₂(), 2b ₂,3a ₁, 1b ₁(), 1b ₂, 2a ₁ and for C₂H₅N 6a, 5a, 3a, 2a, 4a, 3a, 1a, 2a. The agreement of the computed ionization potentials with the experimental values is very satisfactory.     

Note on the ab initio PUHF treatment of open-shell systems

Ab initio projected-unrestricted Hartree-Fock calculations have been carried out on a number of excited and ionic states of the water molecule. Results have been compared with large-scale CI calculations, with IVO calculations, and with those of Mrozek and Golebiewski obtained by the 2 × 2 rotation method applied to orbitals. It is concluded that the PUHF method may provide the most useful alternative to large-scale CI for calculating properties of open-shell systems. But it will not be generally useful for calculating spectral transition energies.     

AlSiP3, a compound with a novel wurtzite-pyrite intergrowth structure

AlSiP₃ is formed by heating aluminum and silicon powder with red phosphorus and adding small amounts of iodine or AlCl₃. Small, black crystals with metallic lustre grow at 1200°K. The compound crystallizes in the orthorhombic space group Pmnb (No. 62) with a = 987.2 pm, b = 586.1 pm, c = 608.8 pm and four formula units. In the structure isolated P atoms as well as P₂ pairs are present (PP = 218.2 pm). Silicon is tetrahedrally bonded (SiP = 224.2 ? 228.2 pm) whereas aluminum has octahedral coordination (AlP = 244.2 – 260.8 pm). The structure can be described as an intergrowth structure of wurtzite and pyrite type.