Similarities and Differences of the Active Sites in Basic and Advanced MgCl2‐Supported Ziegler‐Natta Propylene Polymerization Catalysts

Though preparation procedures of heterogeneous Ziegler‐Natta catalysts for propylene polymerization are sophisticated, it is uncertain whether the nature of the active sites is similar or different for different preparation procedures. In this study, the effects of preparation procedures on the nature of the active sites were investigated by stopped‐flow polymerization in combination with microstructure analysis of polymers. Both basic and advanced types of catalysts showed the same two kinds of isospecific active site, which indicated little influence of the preparation method on the active site structure. On the contrary, the ratios of the two kinds of isospecific sites were not the same, resulting in variation of average polymer properties.

     

载气流速对高场不对称波形离子迁移谱的影响

载气流速是影响高场不对称波形离子迁移谱(FAIMS)的重要参数.以自制的高场不对称波形离子迁移谱仪为实验平台,在射频电场幅值3 kV/cm,频率500 kHz,占空比0.36的条件下,研究了载气流速对苯离子迁移谱谱峰强度和半峰宽的影响.实验结果表明: 载气流速为3.7 L/min时,苯样品的谱峰强度最大,仪器的灵敏度最高.随着载气流速的增加,谱峰半峰宽变宽,仪器的分辨率下降.载气流速为3 .0～3.7 L/min时仪器综合性能最佳.此结果对于控制迁移谱仪载气流速有重要的参考意义.     

Analysis of trace degradation products (decarboxylated diastereoisomers) of S-adenosylmethionine by electrophoresis in capillaries with cationic coatings (N-methylpolyvinylpyridinium or divalent barium)

Commercial preparations of S‐adenosylmethionine (SAM) when analyzed in uncoated capillaries show a minute impurity believed to be decarboxylated (dc) SAM. By using two types of cationic coatings, thus reducing the electro‐endo‐osmotic flow (EOF), it was possible to separate this impurity into two diastereoisomers of dcSAM. The coatings evaluated for this purpose were: (i) N‐methylpolyvinylpyridinium, used under reversed EOF at acidic conditions (pH 4.0) and (ii) deposition of divalent barium at alkaline pH values (pH 9.4), providing reduced EOF. Under these conditions, it was possible to separate this impurity into two diastereoisomers, which by chemical synthesis were indeed proven to be dcSAM. It was further demonstrated that, in the alkylation of 5′‐methylthioadenosine by 3‐bromopropylamine in bromidric acid to dcSAM, another minute impurity was present, proven, via mass spectrometry, to consist of S‐(5′‐adenosyl)‐3‐thiopropylamine (decarboxylated and demethylated (dc‐SAH)). The LOD for the two dcSAM diastereoisomers was assessed as 17.5 μg/mL and their LOQ as 25.5 μg/mL. By the barium‐based protocol it was possible to quantify the dcSAM, present in a commercial sample of SAM, as a 0.1% impurity.     

Profiling of phospholipids in lipoproteins by multiplexed hollow fiber flow field-flow fractionation and nanoflow liquid chromatography–tandem mass spectrometry

This study describes a coupled analytical method to carry out the systematic profiling of phospholipids (PLs) in high-density lipoproteins (HDL) and low-density lipoproteins (LDL) from human blood plasma. HDL and LDL of healthy human plasma samples were separated by size and collected on a semi-preparative scale using multiplexed hollow fiber flow field-flow fractionation (MxHF5). Phospholipid mixtures contained in the resulting HDL and LDL fractions were analyzed by shotgun nanoflow liquid chromatography–tandem mass spectrometry (nLC–ESI-MS–MS). We utilized a dual scan method for the separation and simultaneous characterization of complicated PL mixtures by nLC–ESI-MS–MS, such that phosphatidylcholine (PC) and phosphatidylethanolamine (PE) molecules were detected in positive ion mode in a first LC run. In a second LC run, phosphatidylinositol (PI), phosphatidylglycerol (PG), and phosphatidic acid (PA) were detected in negative ion mode. In this study, a total of 56 PLs from HDL and 52 PLs from LDL particles were characterized by their molecular structures from data dependent collision-induced dissociation (CID) experiments, and their relative abundances were compared.     

Capillary electrophoresis-mass spectrometry of intact basic proteins using Polybrene-dextran sulfate-Polybrene-coated capillaries: System optimization and performance

A capillary electrophoresis-mass spectrometry (CE-MS) method using sheath liquid electrospray ionization interfacing was studied and optimized for the analysis of intact basic proteins. To prevent protein adsorption, capillaries with a noncovalent positively charged coating were utilized. Capillaries were coated by subsequent rinsing with solutions of Polybrene, dextran sulfate and Polybrene. The coating proved to be fully compatible with MS detection, causing no background signals and ionization suppression. The composition of the sheath liquid and BGE was optimized using the model proteins α-chymotrypsinogen A, ribonuclease A, lysozyme and cytochrome c. A sheath liquid of isopropanol-water-acetic acid (75:25:0.1, v/v/v) at 2 μL min⁻¹ resulted in optimal signal intensities for most proteins, but caused dissociation of the heme group of cytochrome c. Optimum protein responses were obtained with a BGE of 50 mM acetic acid (pH 3.0), which allowed a baseline separation of the test protein mixture. Several minor impurities present in the mixture could be detected and provisionally identified using accurate mass and a protein modification database. The selectivity of the CE-MS system was investigated by the analysis of acetylated lysozyme. Eight highly related species, identified as non-acetylated lysozyme and lysozyme acetylated in various degrees, could be distinguished. The CE-MS system showed good reproducibility yielding interday (three weeks period) RSDs for migration time and peak area within 2% and 10%, respectively. With the CE-MS system, determination coefficients (R²) for protein concentration and peak area were higher than 0.996, whereas detection limits were between 11 and 19 nM.     

Efficient access to new chemical space through flow--construction of druglike macrocycles through copper-surface-catalyzed azide-alkyne cycloaddition reactions

A series of 12‐ to 22‐membered macrocycles, with druglike functionality and properties, have been generated by using a simple and efficient copper‐catalyzed azide–acetylene cycloaddition reaction, conducted in flow in high‐temperature copper tubing, under environmentally friendly conditions. The triazole‐containing macrocycles have been generated in up to 90 % yield in a 5 min reaction, without resorting to the high‐dilution conditions typical of macrocyclization reactions. This approach represents a very efficient method for constructing this important class of molecules, in terms of yield, concentration, and environmental considerations.     

Chemical markers’ fishing and knockout for holistic activity and interaction evaluation of the components in herbal medicines

A strategy based on chemical markers’ fishing and knockout has been proposed for holistic activity and interaction evaluation of the bioactive components in herbal medicines (HMs). It was devised to screen bioactive-compound group that represents the efficacy of HM, estimate the bioactivity contribution of each component and elucidate the interactions of multi-components. This strategy was accomplished through the following steps: (1) screen out the chemical markers (target peaks) in a HM fingerprint using online two-dimensional turbulent flow chromatography/liquid chromatography–mass spectrometry technique, (2) fish target peaks and knockout any interested peak, and (3) evaluate the bioactivities of fishing and knockout portions. After comparison of the bioactivities of samples containing different target peaks, the efficacy of target-peak group, bioactivity contribution of each compound, and the interactions of multi-components are elucidated. Using Acetylcholinesterase (AChE) and Bulbs of Lycoris radiata (L. Herit.) Herb. (BLR) as the experimental materials, four target peaks were screened out as the AChE binders. By target peaks’ fishing and knockout, combined with activity evaluation, we observed that the bioactivity of the four-peak mixture is similar with the global bioactivity of BLR extract, and there are significant suppressive actions among these four target peaks. These results indicate that this proposed strategy is a useful approach for holistic screening of bioactive-compound group and elucidation of the multi-component interactions in HM.     

反相流动注射化学发光法测定黄芩苷

在碱性介质中,K3Fe(CN)6氧化鲁米诺产生化学发光,黄芩苷对该体系化学发光具有强烈的抑制作用。利用该化学发光的抑制体系,结合反相流动注射技术,建立了测定黄酮类药物黄芩苷含量的新方法。在优化的条件下,黄芩苷浓度在1.0×10-8～1.0×10-7和3.0×10-7～4.0×10-6mol/L范围内与化学发光抑制强度ΔI呈良好的线性关系,检出限为1.0×10-9mol/L,对3.0×10-7mol/L的黄芩苷进行平行测定10次,得相对标准偏差(RSD)为1.7%。该方法可应用于银黄口服液中黄芩提取物(黄芩苷计)的含量测定。     

空气污染组分H2O和CO2对乙烯燃烧性能的影响(II)——反应机理和动力学模拟

超燃冲压发动机在高空工作时, 以高温高速纯净空气作氧化剂使燃料燃烧. 但在地面实验中, 高温空气往往通过燃烧加热方式获得, 会使空气中含有H2O和CO2等污染组分. 本文用活塞流反应器进行动力学模拟, 研究在不同初温、压强和燃气比的条件下, H2O和CO2污染组分对乙烯燃烧的温度、压强和点火延迟时间等特性的影响. 模拟结果表明: 乙烯在含有H2O/CO2污染物的空气中燃烧, 相比纯净的空气而言, H2O对乙烯的点火有一定的促进作用, 而CO2有一定的抑制作用; 空气中含H2O和CO2污染物使乙烯燃烧的平衡温度和压强降低, 在污染物浓度相同时, CO2引起的下降幅度比H2O的大. 模拟结果能较好地解释现有的实验现象.     

Heterogeneous versus bulk nucleation of lysozyme crystals

Heterogeneous (on‐glass) protein crystal nucleation was separated from the bulk one in systems of thin protein solution layers, confined between two glass plates of custom made quasi two‐dimensional all‐glass cells, as well as by applying forced protein solution flow. Two commercial samples of hen‐egg‐white lysozyme, Seikagaku and Sigma were used as model proteins. Applying the classical technique of separation in time of nucleation and growth stages with protein solution layers of thickness 0.05 cm we found that the on‐glass crystal nucleation prevailed highly with Seikagaku HEWL, while on the opposite, bulk nucleated crystals represented the main crystal fraction in Sigma solution. Also using 0.05 cm solution layers nucleation rates were measured separately for the on‐glass and bulk protein crystals. The process was investigated by varying solution layer thicknesses as well, from 0.05 down to 0.01, 0.0065 and 0.002 cm. Studying the influence of the forced protein solution flow on HEWL crystal nucleation the classical double‐pulse technique was modified by separating the nucleation and growth stages not only in time, but simultaneously also in place. In this case we found that the ratio of on‐glass formed crystal nuclei to bulk nuclei depended on the flow velocity, but in different manner with Seikagaku HEWL and Sigma HEWL. A plausible explanation of our experimental results is that the bulk crystal nucleation occurs on foreign surfaces as well, e.g. on rests of source biomaterial, which are always present in the protein solutions. Moreover, biomaterial seems to be more active nucleant than glass. (© 2010 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)