窄间隙室探测器性能测试

山东大学承担ATLAS实验T9型窄隙室TGC探测器的研制任务,本工作测量了TGC探测器在32?0?0V工作电压下的稳定性、漏电流和坪曲线,同时在相同工作条件下、相同时间间隔内测量各信号道的计数率的一致性.初步测量结果表明,由山东大学研制的T9型TGC探测器的各项性能指标达到实验设计要求.     

基于模糊PID的助行机器人调速系统的研究

助行机器人对系统的动态特性要求较高,而且在其爬楼的过程中有诸多不确定的因素,基于传统控制策略的单闭环负反馈控制系统调速效果难以令人满意。在这种情况下建立了系统的数学模型,设计了基于模糊PID的双闭环调速控制系统,并和传统的PID控制进行了对比。为了保证助行机器人爬楼过程的平稳性和乘坐者的舒适性,参考电梯运行的速度曲线,设计了正弦速度给定曲线。仿真结果表明：在助行机器人调速系统中,模糊PID控制比传统PID控制启动和制动过程更平稳,舒适性更高,误差更小,精度更高。     

Multi-reference calculations of the photodissociation of HSCH3 molecule

This paper performs multi-reference second-order perturbation theory calculations on the ground state and a number of low-lying excited states of HSCH3 molecule, and calculates the vertical excitation energies and low-energy potential-energy curves, based on which the photodissociation channels of HSCH3 at 193,222,248 nm are clarified.     

两种烷基碘化物分子C—I键解离的从头计算

分别采用多组态自洽场方法和二阶多组态准简并微扰论方法,计算了烷基碘化物分子CF₃I和C₂H₂F₃I沿C—I键的绝热势能曲线和垂直激发能. 结果发现,这两种分子的低激发态均为排斥态;基态的解离能分别为2.473eV和2.835eV,其中前者与实验结果符合较好. 关键词： 烷基碘化物分子 解离能 势能曲线     

DOUBLESLICING: a non-iterative single profile multi-exponential curve resolution procedure. Application to time-domain NMR transverse relaxation data

A new non-iterative curve resolution technique for resolving single decay profiles is proposed. The new technique, called DoubleSlicing, is based on the Decra (Direct Exponential Curve Resolution Algorithm) principle. While the original Decra was designed to resolve several decay curves simultaneously and thus fitting common pure exponentials, DoubleSlicing can resolve single decay profiles by a simple double data transformation followed by an analytical and unique three-way decomposition. The new approach is successfully demonstrated on experimental NMR CPMG relaxation data, measured on combinations of unmixed paramagnetic CuSO(4) solutions. Decay signals of the water component were acquired following an innovative experimental design that ensured no interaction between the components present in each sample under observation. DoubleSlicing proved to be accurate in estimating relaxation times differing in one order of magnitude (range: 19.6-159.4ms). Its performance was comparable to discrete exponential fitting with the advantage of being much faster - in terms of computation time, DoubleSlicing outperformed exponential fitting by a factor of four.     

面心立方金属声子色散曲线的数值模拟

把分析型嵌入原子法（AEAM）和晶格动力学理论相结合,在三维布喇菲晶格振动模型的基础上模拟了面心立方金属Au、Ag、Pt、Cu和Ni沿[00ζ]、[0ζζ]、[ζζζ]和[0ζ1]4个对称方向的声子色散曲线.结果表明：模拟曲线与实验点线符合的较好,特别在低频附近二者几乎一致,而在纵波模（L）q=（001）2π/a,q=...     

A≈110质量区奇A核形状演化研究

应用E-GOS（E-Gamma Over Spin）曲线方法研究了A≈110质量区奇A核结构随角动量增加的演化, 发现随着角动量的增加原子核的激发特性从振动逐渐演化为转动。 The E-GOS（E-Gamma Over Spin）curves were used to investigate the structure evolution in the odd A nuclei around A≈110 as a function of spin. The result shows that there is a clear transition from vibration to rotation while increasing spin.     

Synthesis and characterization of thermoluminescent Li2B4O7 nanophosphor

Lithium borate (Li₂B₄O₇) is a low Z_eff, tissue equivalent material that is commonly used for medical dosimetry using the thermoluminescence (TL) technique. Nanocrystals of lithium borate were synthesized by the combustion method for the first time in the laboratory. TL characteristics of the synthesized material were studied and compared with those of commercially available microcrystalline Li₂B₄O₇. The optimum pre-irradiation annealing condition was found to be 300 °C for 10 min and that of post-irradiation annealing was 300 °C for 30 min. The synthesized Li₂B₄O₇ nanophosphor has very poor sensitivity for low doses of gamma up to 10¹ Gy whereas from 10¹ to 4.5×10² Gy this phosphor exhibits a linear response and then from 4.5×10² to 10³ Gy it shows supralinearity. Thermoluminescence properties of Li₂B₄O₇ nanophosphor doped with Cu has also been investigated in this paper. It shows low fading and a linear response over a wide range of gamma radiation from 1×10² to 5×10³ Gy. Therefore the synthesized lithium borate nanophosphor doped with Cu may be used for high dose measurements of gamma radiations.     

土壤重金属铬元素的激光诱导击穿光谱定量分析研究

利用Nd ∶YAG脉冲激光器(波长:1064 nm)作为光源,在实验室自然大气环境下诱导产生土壤激光等离子体,通过等离子体原子发射光谱法定量分析了国家标准土壤样品中元素Cr的含量.实验上研究了在最佳实验条件下土壤中Cr的LIBS分析谱线,测定了Cr元素的定标曲线.实验结果表明,Cr元素浓度在(60—400)×10^-6范围内,元素含量与光谱线强度之间有较好的线性关系;元素Cr浓度分析测量的相对标准偏差(RSD)为7.89%,定量分析结果与标准值的相对偏差为5.3%,Cr元素的检测限为1 关键词： 土壤污染 定量分析 激光诱导击穿光谱 定标曲线     

用等值宽度法测量fs脉冲宽度

本文提出利用等值宽度测量fs光脉冲持续时间的方法.给出了脉冲形状为sech~2 (t/T)、exp(-2t~2/T~2)和exp(-2|t|/T)的干涉相关曲线上包络与相应二阶强度相关曲线半宽度等值的位置,它们分别是3.984、4.875和4.928.定义了两种相关测量的临界延迟速度.理论分析与实验结果符合得很好.所得结果表明,该测量方法可将常规超短脉冲相关测量的时间分辨率提高几倍至几十倍.