一种基于二进小波变换的自适应滤波方法

根据信号和噪声经小波变换后在不同尺度上有不同的特征，将相邻尺度二进小波变换值的相关量进行归一化处理并与小波变换值比较来判断信号与噪声，以噪声在各尺度的方差作为终止迭代的标准，提出了一种基于二进小波变换小波域选择噪声的自适应滤波方法。研究了模拟信号的去噪过程、半峰宽和信噪比对去噪结果的影响，并对模拟含噪信号和含噪毛细管电泳信号去噪前后的结果进行了比较。实验结果表明：由于该方法具有良好的自适应性和显著的滤波效果，必将得到广泛的应用。     

Effect of water-soluble cross-linker on the growth and properties of ethyl acrylate–methacrylic acid emulsion opolymer particles

Model ethyl acrylate–methacrylic acid copolymer latices and latices of particles cross-linked by copolymerizing small amounts of water-soluble N,N′-methylenebisacrylamide were prepared by nonseeded semicontinuous emulsion copolymerization. Dynamic and static light scattering measurements indicated a slightly higher degree of polydispersity in the case of cross-linked particles, especially in the initial stages of polymerization. The hydrodynamic volume of the alkalinized particles controlling the viscosity properties of the dispersions decreased with the time of polymerization and in the case of cross-linked copolymer almost reached a constant value at about 1 h. The different character of the particle structure was confirmed by differences in particle disintegration after alkali addition or in the presence of methanol. Received: 2 February 1999/Accepted: 28 June 2000     

卡尔曼滤波析相光度法同时测定锰铁铜锌镉的研究——5-Br-PADAP—Triton X-100体系

运用卡尔曼滤波递推法,以2-(5-溴-2-吡啶偶氮)—5-二乙氨基苯酚(5-Br-PADAP)为显色剂,建立了同时测定锰、铁、铜、锌、镉析相光度法.在pH9.0硼酸-氢氧化钠介质中,胶束溶液在95℃加热1h,配合物被Triton X-100相完全富集,最大吸收峰分别为锰566nm、铁556nm、铜560nm、锌562nm、镉557nm,工作曲线范围除镉为0～8μg/5ml外,其余均为0～10μg/5ml.应用于大米中锰铁铜锌镉的同时测定,结果满意.     

PREPARATION OF PARTICLE SIZE NARROWLY DISTRIBUTED LOW-DENSITY STYRENE DIVINYLBENZENE COPOLYMER MICROBEADS

In view of the importance of dispersion agent, the amount of the crosslinking monomer andthe diluent in suspension polymerization for the production of particle size narrowly distributedIow-density styrene divinylbenzene copolymer microbeads (LDPS), their actions are preliminarilyinvestigated in this paper. Experimental results indicate that when both the gelatine and polyvinylalcohol (PVA) are used as dispersion agents, the better effect is achieved. DVB is helpful to theformation of the lower density fine particles, the proportion of the DVB/St should be between1:1～1.5:1. Compared with toluene, gasoline is the more effective diluent for the above target.     

Preparation and Characterization of Nanotitanium Dioxide Coating Film Doped with Fe^3＋ Ions on Porous Ceramic

The nanotitanium dioxide （TiO2） photocatalytic and porous ceramic filtering technique is one of the advanced methods to effectively treat organic wastewater. The TiO2 sol doped with Fe^3＋ ions was prepared by sol-gel processing. The influences of the process conditions of coating nanophotocatalytic material- Fe^3＋-TiO2 film on the surface of porous ceramic filter by dipping-lift method on the performance of porous ceramic filter were studied. The porous ceramic filters have two functions at the same time, filtration and photocatalytic degradation. The results of this study showed that the pH and viscosity of the sol, amount of Fe^3＋ ions doped as well as the coating times greatly affect the quality of coating film, the performance parameters and the photocatalytic activity of the porous ceramic filter. When the pH of the sol is 3-4, the viscosity is about 6 mPa.S, the amount of doped Fe^3＋ ions is about 2.0 g/L, the porous ceramic filter has been shown to have the best filtering performance and photocatalytic activity. In this condition, the porosity of porous ceramic is about 42.5%, the pore diameter is 8-10μm. The degradation of methyl-orange is 74.76% under lighting for 120 rain.     

改进的单纯形优化法用于混合稀土的同时测定

本文应用改进的单纯形优化法较好地弥补了目前在分析化学计量学中得到广泛应用的卡尔曼滤波法所存在的不足，交法应用于混合稀土的同时测定中，获得了满意的结果，结果准确度较卡尔滤波法的有显著的提高。     

Determination of trace elements in ambient aerosol samples

A microwave-assisted digestion procedure using HNO₃, HF, and H₂O₂ has been developed for analysis of elements in ambient particulate matter (PM). The samples are collected on cellulose filters and analyzed by inductively coupled plasma mass spectrometry (ICP-MS). The ICP-MS is calibrated with external standards, and recovery of analytes is tested with NIST SRM 1648 Urban Dust. This method has been used to quantify the airborne concentrations of a large number of elements, including Ag, As, Ba, Be, Ca, Cd, Ce, Co, Cr, Cs, Cu, Fe, Ga, K, Li, Mg, Mn, Mo, Ni, Pb, Rb, Se, Sb, Sr, Ti, Tl, V, and Zn. For the majority of these elements, recovery of the NIST SRM is within 15% of the certified values.     

Production of poly(methyl methacrylate) particles by dispersion polymerization with mercaptopropyl terminated poly(dimethylsiloxane) stabilizer in supercritical carbon dioxide

Poly(methyl methacrylate) (PMMA) particles were produced by dispersion polymerization of methyl methacrylate in the presence of mercaptopropyl terminated poly(dimethylsiloxane) (MP-PDMS) in supercritical carbon dioxide at about 30 MPa for 24 h at 65 °C. The particle diameter could be controlled in a size range of submicron to micron by varying MP-PDMS concentration. The MP-PDMS worked as not only a chain transfer agent but also a colloidal stabilizer, which was named tran stab.Part CCLI of the series Studies on suspension and emulsion     

Particle circulation and oxygen mass transfer in an immobilized cell bioreactor

Two important considerations in the design of an aerobic particulate immobilized cell bioreactor are the provision of sufficient oxygen to maintain the desired metabolism of the immobilized organism, and the biomass holdup (which is proportional to the number of immobilized cell particles in the reactor). The Circulating Bed Reactor, a reactor developed for use with those forms of immobilization that result in particles of essentially neutral buoyancy, operates with an expanded bed of circulating particles. The particle number density attainable in such a reactor has been found to be dependent upon the circulation cell aspect ratio, the individual particle properties, the static bed voidage of the particles, and the superficial gas velocity. The oxygen mass transfer characteristics have been found to be dependent upon the circulatory nature of the system, the particle (solids) holdup, the particle porosity, and the superficial gas velocity.     

Self-organization of polymer particles on hydrophobic solid substrates in aqueous media. I. Self-organization of cationic polymer particles on alkylated glass plates

Monodisperse, cationic polymer particles bearing quaternary ammonium groups effectively self-organized on hydrophobic solid substrates such as alkylated glass plates and polymer films to form particle monolayers. With an increase of the particle surface charge density, the surface coverage decreased and the morphology of particle monolayers changed from aggregated type to dispersed type. The dispersed type of particle monolayers having a relatively regular particle distance was formed at higher temperature. The self-organization behaviors on alkylated glass plates were different from those on unmodified glass plates through electrostatic interaction. The formation of particle monolayers on alkylated glass plates occurred only over a certain latex concentration range in contrast with that on unmodified glass plate. The adhesive strength of particle monolayers was enhanced by annealing at temperatures above the glass transition temperature (T _g) of the particles. Lens-shaped particle monolayers were fabricated by annealing the dispersed type of particle monolayers.