阴极支撑型固体氧化物燃料电池的制备与测试

采用固相反应法合成A缺位的(La_0.8Sr_0.2)_0.95MnO₃(LSM95)作为阴极材料,Zr_0.9Sc_0.1SO_1.95(SSZ)商业粉体作为电解质材料,溶胶-凝胶法合成的La_0.8Sr_0.2Cr_0.5Mn_0.5O₃-(LSCrM)作为阳极电催化材料,利用流延、共烧结及浸渍法得到结构为LSCrM-CeO₂|SSZ|3YSZ-LSM95的阴极支撑型固体氧化物燃料电池,分别在氢气气氛和甲烷气氛中进行电化学性能测试. 结果表明,浸渍0.11 g·cm ^-2 CeO₂的LSCrM-CeO₂|SSZ|3YSZ-LSM95单电池在以CH₄为燃料时,600、650、700、750和800 ^oC下的功率密度分别为1.68、4.70、12.40、28.08和54.78 mW·cm ^-2,表现出一定的电化学性能和较好的稳定性.     

Temperature programmed reduction of silica supported nickel catalysts

Nickel oxide promoted catalysts are prepared by simple precipitation, precipitation from homogeneous solution and impregnation methods and their reduction behavior is monitored with temperature programmed reduction (TPR) technique. The effect of different parameters such as metal loading, method of preparation and heat treatment temperature are also observed on the reducibility of the catalysts. It is observed that reduction temperature increases with the increase of calcination temperature. Results indicate that the interactions between nickel oxide and silica begin with the increase of calcination temperature which leads to the formation of nickel hydrosilicates and are responsible for high temperature reduction peaks.     

Complete Oxidation of Methane over Palladium Supported on Alumina Modified with Calcium,Lanthanum,and Cerium Ions

The activity and thermal stability of Pd/Al_2O_3 and Pd/(Al_2O_3 MO_x)(M=Ca,La,Ce) palladium catalysts in the reaction of complete oxidation of methane are presented in this study.The catalyst supports were prepared by sol-gel method and they were dried either conventionally or with supercritical carbon dioxide.Then they were impregnated with palladium nitrate solution.The catalysts with unmodified alumina had a high surface area.The activity and thermal stability of the alumina- supported catalyst was also very high.The introduction of calcium,lanthanum,or cerium oxide into alumina support caused a decrease of the surface area in the way dependent on the support precursor drying method.These modifiers decreased the activity of palladium catalysts,and they required higher temperatures for the complete oxidation of methane than unmodified Pd/Al_2O_3.The improvement of the palladium activity by lanthanum and cerium support modifier was observed only at low temperatures of the reaction.     

在涂层TiO2改性铜催化剂上甲醇脱氢制甲酸甲酯

在常压和２５０℃下，考察了涂层ＴｉＯ２改性铜催化剂上甲醇脱氢生成甲酸甲酯的活性和选择性以及催化剂的稳定性。结果表明，涂层ＴｉＯ２明显提高了铜催化剂的活性和稳定性。在所考察的铜催化剂中，以Ｃｕ／ＴｉＯ２／ＡｌＯ３的催化活性最高，甚至高于离子交换法制备的Ｃｕ（ｅｘ）／ＳｉＯ２催化剂。ＸＰＳ分析表明，Ｃｕ／ＴｉＯ２／ＡｌＯ３中存在着两种化学环境不同的ＣＵ（０），即负载在ｒ－ＡＬＯ３和ＴｉＯ２－Ａｌ２Ｏ３     

以有机镍配合物为前体制备担载镍催化剂的研究

描述了以镍单核配合物ＮｉＣｐ２和簇合物Ｎｉ３Ｃｐ３Ｎ－ｔ－Ｃ４Ｈ９为前体的ＳｉＯ２载镍催化剂的制备，通过元素分析、ＴＲＲ、ＴＰＤＥ、ＸＰＳ，ＣＯ吸附和苯加氢反应对以镍配合物和簇合物为前体制备的催化剂的性能及其制备过程了研究和表征。结果表明，镍与合物和簇合物在担载过程中同载体ＳｉＯ２表面发生了相互作用，其化学组成发生了变化，在苯加氢反应中，此催化剂的活性比以Ｎｉ（ＮＯ３）２为前体制备的催化剂高得多，     

CO2部分氧化乙烷制乙烯Pd—Cu／MoO3—SiO2催化剂的研究

用化学吸附－红外光谱、化学吸附－程序升温脱附（ＴＰＤ）和微型反应技术研究了Ｐｄ－Ｃｕ／ＭｏＯ３－ＳｉＯ２（ＭｏＳＯ）催化剂对ＣＯ２和乙烷的吸附活化和部分氧化反应性能．结果表明，乙烷以Ｃ—Ｈ键中的Ｈ吸附于ＭｏＳＯ载体表面ＭｏＯ键的端基氧上；Ｐｄ－Ｃｕ／ＭｏＳＯ催化剂对ＣＯ２有良好的化学吸附活化性能，ＣＯ２的吸附除有线式吸附态和剪式吸附态外，还有一种新的卧式吸附态；Ｐｄ－Ｃｕ／ＭｏＳＯ催化剂的晶格氧参与了化学反应．探讨了在Ｐｄ－Ｃｕ／ＭｏＳＯ催化剂上ＣＯ２的部分氧化乙烷反应机理     

Oxidation of allylic alcohols, amines, and sulfides mediated by assembled triphase catalyst of phosphotungstate and non-cross-linked amphiphilic copolymer

A novel catalyst PWAA, an assembled complex of phosphotungstic acid (H₃PW₁₂O₄₀) and a non-cross-linked copolymer of N-isopropylacrylamide with an ammonium, was developed. It is an amphiphilic, cross-linked, and supramolecular insoluble complex and showed catalytic activity on oxidation with aqueous hydrogen peroxide. PWAA, used in 2.7×10⁻⁵-2.0×10⁻³ mol equiv., catalyzed oxidation of allylic alcohols, amines, and sulfides efficiently. The turnover number (TON) of PWAA reached up to 35,000. PWAA showed a good stability in organic/aqueous media and was reused three to five times.     

PROPERTIES OF POLYMER SUPPORTED Ni-Cu BIMETALLIC CATALYSTS PREPARED BY SOLVATED METAL ATOM IMPREGNATION

D-72 resin supported nickel-copper catalysts prepared by solvated metal atom impreg-nation (SMAI) were studied by magnetic measurements and X-ray photoelectron spectro-scopy (XPS). The Ni particles on the catalysts are very highly dispersed and displaysuperparamagnetic behaviour. Ni-Cu alloy clusters were found to be formed. The sur-face compositions are different from the bulk concentrations. In contrast with the surfaceenrichment in copper generally observed on conventional Ni-Cu catalysts, the surfaces ofthese catalysts are enriched in nickel. The nickel is in both zero and valent states, whilecopper is mainly in metallic state. Catalytic data show that the formation of Ni-Cu alloyclusters has a profound effect on the catalytic activities of the catalysts in the hydrogena-tion of furfural. The activity of the Ni:Cu ratio of one bimetallic catalysts is much higherthan that of the Ni or Cu monometallic catalyst.     

STUDIES ON THE PREPARATION OF ZINC-CONTAINING ACTIVATED CARBON FIBERS AND THEIR ANTIBACTERIAL ACTIVITY

1. INTRODUCTION Microbial pollution will bring about various problems in industry and other vital fields, such as causing decomposing of materials, harming people抯 health. In order to reduce these problems, new antibacterial materials have been demanded. Recently, much attention has been paid to inorganic materials including zinc oxide [1~4]. These inorganic antibacterial materials are now substituting for organic materials to avoid releasing noxious organic molecules harmful to humans;…     

液化石油气水蒸气重整镍催化剂新型载体研究

以共沉淀法合成了硅铝系载体（AS和SA），并采用改性天然高铝石为原料合成了矿物质载体（MC-1和MC-2）,采用浸渍法合成了镍负载型催化剂。用常压固定床管式反应器，考察了液化石油气水蒸气重整反应活性，通过XRD、物理吸附等手段对催化剂进行了表征。结果表明，以MC-1、MC-2和SA、AS为载体的催化剂的水蒸气重整活性明显高于目前普遍使用的Ni/α-Al2O3催化剂。以SA为载体，负载5%镍的催化剂具有最好的水蒸气重整活性。在750 ℃，水碳比为2.0的条件下转化率达100％，C1选择性达94.46％。XRD分析结果表明1 300 ℃焙烧后的SA载体中存在α-Al2O3晶型和莫来石结构。硅、铝添加次序对水蒸气重整活性影响较大，硅-铝添加次序的催化剂样品的活性高于铝-硅添加次序的样品，C1选择性提高12.7％。