还原态钼铝催化剂上NO的吸附研究

通过对红外光谱及同位素交换反应后的分析 ,证明吸附在还原态钼铝催化剂上的NO是以双亚硝酰基形式存在的     

“绪论”第一课应给学生以好的印记

物理“绪论”课是同学之间、师生之间都是第一次接触，老师能给学生设置一个欢愉轻松的境界，给学生开辟一片理想的春光，就能帮学生清除中学时期物理学习的阴霾放下包袱，焕发学习物理的自信心，后续物理教学活动中就能发挥学生的主动性．     

强碱性阴离子交换纤维结构和性能的关系

制备了不同紧密程度结构的强碱性阴离子交换纤维。研究了他们在水、乙醇中的膨胀性,用含水量、乙醇吸附量来表征。测定了吸附动力学曲线。结果表明,含水量52～68%,乙醇吸附量和含水量相近,结构紧密的纤维含水量、乙醇吸附量低于结构松散的纤维,前者的吸附平衡时间大于400s后者小于200s。     

墨水溶剂对低铂含量质子交换膜燃料电池性能的影响

Owing to the scarcity of platinum, it is of high importance to develop electrodes with low platinum metal loading and to thereby improve the utilization of Pt for the commercialization of proton-exchange membrane fuel cells (PEMFCs). In comparison to conventional high-platinum electrodes, the thickness of the catalyst layer (CL) is thinner and the interatomic Pt spacing is larger for the low-Pt loading electrodes. The distribution of electrolyte ionomer and the electrode morphology, which are strongly influenced by the solvents used in the fabrication process, are therefore increasingly important factors for achieving high performance in the membrane electrode assembly (MEA). In this work, different solvents with various dielectric constants and evaporation rates were used to prepare the inks for low-Pt loading cathode (0.1 mg·cm^-2) fabrication. First, the inks were fabricated by dispersing the catalyst and ionomer in different solvents which were then coated onto carbon paper to prepare the gas diffusion electrodes. The anode and cathode electrodes were then hot-pressed together with the Nafion membrane to produce the MEAs. The results showed a mixture of isopropanol-water (4:1) yielded the best-performing MEA during the single-cell tests compared to the other solvents tested. In order to elucidate the relationship between the performance of MEAs and the solvents, the structure and the surface morphology of the CL and the distribution of Nafion ionomer in the CL was characterized using scanning electron microscopy (SEM) and transmission electron microscopy (TEM). A comparison of the SEM and TEM images of representative samples indicated that the best performing electrode had a much improved homogeneity in the surface morphology as well as the dispersion of catalyst and ionomer. This was because of the moderate evaporation rate and better dispersion, caused by the increased hydrogen bonding and high dielectric constant, respectively. The results from dynamic light scattering (DLS) showed that the size of the catalyst and ionomer aggregates are influenced by the solvents. It is suggested that larger aggregates might help the formation of holes in the CL for gas diffusion and water removal, with the optimum size found to be around 400–800 nm. In conclusion, the MEA fabricated from the isopropanol-water solvent exhibited a significantly increased power density (1.79 W·cm^-2), and the utilization of Pt was increased to approximately 0.047 mg·W^-1, which is among the best-performing fuel cells reported to date.     

聚砜阴离子交换膜的制备及结构与性能研究

以1,4-二氯甲氧基丁烷(BCMB)为氯甲基化试剂,使聚砜(PSF)发生氯甲基化反应,制得了氯甲基化聚砜(CMPSF),考察了主要因素对聚砜氯甲基化反应的影响,并使用FTIR及1H-NMR等法对CMPSF的化学结构进行了表征.采用三乙胺(TEA)、三丙胺(TPA)及三丁胺(TBA)等3种叔胺对CMPSF进行了季铵化反应,并以4,4′-联吡啶为交联剂实施了交联反应,制备了聚砜阴离子交换膜(PSFAEM).测定了交换膜PSFAEM的主要性能,包括离子交换容量(IEC)、含水量(WC)及膜电阻(Rm).实验结果表明,使用BCMB,聚砜的氯甲基化反应可顺利进行,以氯仿为溶剂,以SnCl4为Lewis酸催化剂,可制得氯甲基化程度为1.75mmol/g的CMPSF.交换膜PSFAEM的IEC、WC及Rm与季铵化反应时间及叔胺的种类密切相关.季铵化反应时间相同时,采用烷基中碳原子数少的叔胺TEA所制备的交换膜具有高的IEC与WC,低的Rm;使用同一种叔胺时,随季铵化反应时间的增长,交换膜的IEC与WC增大,Rm减小.     

以氯代酰氯为试剂的聚砜膜材料的付-克酰基化反应

采用氯乙酰氯和氯丁酰氯两种ω-氯代酰氯化试剂,在Lewis酸催化剂存在下,于室温下分别对聚砜（PSF）材料实施了Friedel-Crafts酰基化反应,制备了氯代酰基化（CA）聚砜材料CAPSF。用FT-IR、1H-NMR与佛尔哈德分析法表征了该产物的化学结构与组成。结果表明：在室温（25°C）下,以CH2Cl2为溶剂...     

非理想界面弹性层/压电柱结构中SH波的传播特性

研究了各向同性弹性层与压电柱之间非理想连接时沿周向传播的SH波的频散特性.弹性层表面力学自由;弹性层与压电柱之间应力连续、位移间断.通过求解控制方程,将问题的解用Bessel函数表示,利用界面条件和边界条件得到频散方程,然后对其进行数值求解,分析了界面性态、材料常数和几何尺寸对SH波传播特性的影响.     

关于偏序集相关联图的色数

对于每一个含有最小元素0的偏序集（P,≤）可以得到一个与其关联的图G（P）.本文主要通过代数的方法研究了所得关联图G（P）的性质,证明了如果G（P）的色数和团数是有限的,那么色数和团数都仅比P的极小素理想的个数大1.     

Entanglement swapping between atom and cavity and generation of entangled state of cavity fields

This paper proposes a scheme where entanglement swapping between atom and cavity can be realized. \Lambda -type three-level atoms interacting resonantly with cavity field are considered. By detecting atom and cavity field, it realizes entanglement swapping between atom and cavity. It uses the technique of entanglement swapping to generate an entangled state of two cavity fields by measuring on atoms. It discusses the experimental feasibility of the proposed scheme and application of entangled state of cavity fields.     

磺化侧苯基杂萘联苯聚醚酮酮的合成与性能

以4-(3-苯基-4-羟基苯基)-2,3-二氮杂萘-1-酮(DHPZ-P)、 4-(4-羟基苯基)-2,3-二氮杂萘-1-酮(DHPZ)和1,4-二(4'-氟苯甲酰基)苯(BFBB)为原料, 经溶液亲核取代缩聚反应, 通过调节DHPZ-P和DHPZ的比例, 合成了一系列侧苯基杂萘联苯聚醚酮酮(PPEKK-P), 然后以浓硫酸为磺化剂, 制备出一系列磺化侧苯基杂萘联苯聚醚酮酮(SPPEKK-P). 利用傅里叶变换红外光谱(FTIR)和氢核磁共振谱(¹H NMR)对聚合物结构进行表征, 结果表明, 磺酸基团引入到聚合物链的侧苯基上. 采用溶液浇铸法制备SPPEKK-P质子交换膜. SPPEKK-P膜的吸水率、 溶胀率和质子传导率均随离子交换容量(IEC)的增加而增加, 且具有较好的耐氧化性. IEC最高的SPPEKK-P-100膜的质子传导率在95℃能达到7.44×10^-2 S/cm, 且甲醇渗透系数为5.57×10^-8 cm²/s, 阻醇性能优于Nafion117膜.