Scalar Perturbations in Inflationary Models Based on the Non-Linear Sigma Model

The inflationary models based on the non-linear sigma model with the self-coupling potential are considered. The slow-roll solutions for long-wavelength inhomogeneities in general two-component chiral models and diagonal three-component chiral model of a special case are obtained. Scalar perturbations are calculated for two examples.     

广义线性模型(六)

本讲座是广义线性模型这个题目的一个比较系统的介绍。主要分 3部分 :建模、统计分析与模型选择和诊断。写作时依据的主要参考资料是L .Fahrmeir等人的 :《MultivariateStatisticalModel ingBasedonGeneralizedLinearModles》。     

Carbonyl allylations by 3-halopropenes or 2-propenyl mesylate with tin(IV) chloride and tetrabutylammonium iodide

2-Propenyl tin species, prepared from 3-halopropenes or 2-propenyl mesylate with tin(IV) chloride and tetrabutylammonium iodide in dichloromethane, causes nucleophilic addition to aldehydes to produce the corresponding homoallylic alcohols.     

Formulation for XPS spectral change of oxides by ion bombardment as a function of sputtering time

XPS measurement revealed that the original state of TiO₂ was changed to Ti₂O₃ and TiO by ion bombardment. TiO₂ decreased and Ti₂O₃ increased at the initial stage. TiO increased at a later stage than Ti₂O₃. Each of them saturated after enough sputtering time.A formulation was proposed in order to explain the change of XPS spectra for oxides as a function of ion sputtering time. This formulation was based on reaction equations that contain two reduction processes (from TiO₂ to Ti₂O₃ and from Ti₂O₃ to TiO), and sputtering effects. Using four fitting parameters (two reduction coefficients, sputtering yield and information depth), the present formula was fitted to the experimental results. The fitting results agree satisfactorily with the experimental results. The calculation shows that the reduction coefficient from TiO₂ to Ti₂O₃ is about ten times larger than that from Ti₂O₃ to TiO. This calculation predicts that surface composition of an oxide that is changed by ion bombardment will reach a different value depending on its bulk composition. Moreover, the present formulation can determine the chemical states of compounds changed by ion bombardment.     

Modeling hyperelastic behavior of rubber: A novel invariant‐based and a review of constitutive models

A constitutive phenomenological model completing the Gent‐Thomas concept is carried out to formulate laws governing the hyperelastic behavior of incompressible rubber materials. It is shown that the phenomenological Gent‐Thomas model (1958) and the constrained chain model (1992) give similar precise results at small to moderate deformation. On the other hand, comparisons of the outcome of the proposed model with that of the molecular model from the combined concepts of Flory‐Erman and Boyce‐Arruda (2000), and with those of the phenomenological models of Ogden (1982), Yeoh‐Fleming (1997), Pucci‐Saccomandi (2002) and Beda (2005) are made. Residual inconveniences raised by attractive continuum models in rubber elasticity literature have been successfully overcome. Results from both the statistical and phenomenological mechanics concepts are compared with the data of some useful classical materials (rubbers of Treloar, Rivlin‐Saunders, Pak‐Flory and Yeoh‐Fleming). The results permit one to see salient equivalence of the two theories for a more reliable prediction of stress‐stretch response for all states of any mode of deformation. A complete and exhaustive analysis of the Mooney plot that combines small and very large extension‐compression has been quite essential in assessing the validity of models. A method of identification of material parameters is presented and data of the simple tension suffice for the determination of the parameter values. It is shown that the ordinary identification procedures, such as the usual least squares, a very much used numerical method in materials investigation, can be unsuitable in some cases of hyperelastic modeling. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 1713–1732, 2007     

Zur Synthese von Bor-Schwefel(IV)-Stickstoff-Heterocyclen

Synthesis of Boron-Sulfur(IV)-Nitrogen Heterocycles The reaction of bis(lithio.tert.-butylamino)phenylborane with tert.-butyldichlorosulfimide and bischlorodimethylsilylsulfodiimide respectively leads to four- or eight-membered heterocycles. The disulfanebridge of one dithiazadiborolidine can be replaced by the ? N?S?N-sequence to yield a Thiatriazadiborine. ¹H, ¹¹B, ¹³C-NMR, mass spectra, and analytical data are reported and discussed.     

Pt(IV)-catalyzed cyclization of arene-alkyne substrates via C-H bond functionalization

We herein report that PtCl₄ has proven to be a hydroarylation catalyst with an efficiency and substrate scope superior to previously known methods. This catalyst demonstrated consistent performance with arene-yne substrates of diverse structural features, including propargyl ethers, propargylamines, and alkynoate esters, providing good to excellent yields of the 6-endo products (chromenes, dihydroquinolines, and coumarins). In contrast, Pt(II), Pd(II), and Ga(III) salts were shown to be sensitive to the substitution on the alkyne moiety. PtCl₄ is compatible with both terminal and disubstituted alkynes, as well as with various functionalities on the arene ring, including methyl, methoxyl, hydroxyl, protected amine, and halide.     

Identification of micro-scale calorimetric devices II

The miniaturized calorimetric devices furnish a reduced working flat surface and permits measurements with extremely low-mass quantities. The experimental sensitivity shows relevant position dependence with x-y surface coordinates and with z-distance. The device identification is realized via a 2-D model based in Fourier general equation. Using the Marquardt method the experimental flat surface device can be identified and the fitted parameters used to simulate the behavior of the experimental system. From the model, the effects of several dissipation configurations can be evaluated. Also, via the RC-analogy, a way to 3-D experimental devices is roughly described. This revised version was published online in July 2006 with corrections to the Cover Date.     

Corner spontaneous magnetization

Details are given of a new method allowing an exact calculation of the spontaneous magnetization in the corner as well as along the edge at an arbitrary distance of the corner for a rectangular planar Ising ferromagnet.     

Turbulence modelling of the shear layers in the trailing edge region of a modern rear-loaded airfoil at incidence

After carefull analysis in a turbulent zero-pressure gradient flow, various simple algebraic turbulence models were applied to the almost separated flow on the upperside of an airfoil at incidence. The Johnson-King and Horton non-equilibrium (or rate equation) models give clearly improved results.