Noncompetitive enzyme immunoassay for α-fetroprotein using flow injection chemiluminescence

A novel, direct noncompetitive flow injection enzyme immunoassay for α-fetoprotein (AFP) was developed by enhanced chemiluminescence detection. The method was based on off-line incubation of AFP and horseradish peroxidase (HRP)-labeled anti-AFP, and then trapping of the unbound enzyme conjugate by an immunoaffinity column filled with AFP-modified Sepharose. The immunocomplex formed in incubation passed through the column and then was directly detected by a postcolumn chemiluminescence technique. The optimal conditions for the immunoassay procedure and chemiluminescence detection were established. At a 1:10 dilution of enzyme conjugate solution, the linear range for chemiluminescence detection of AFP was from 2.0 to 75 ng/mL with a correlation coefficient of 0.993 and a coefficient of variation of 2.67% at 30 ng/mL. The detection limit was 0.5 ng/mL. This method was flexible, sensitive, and rapid. The immunoaffinity column of 200 μL could be repeatedly used 100 times without a single decrease. The whole assay time including the preincubation step was only 30 min for one sample.     

Flow injection analysis of gallic acid with inhibited electrochemiluminescence detection

A flow injection (FI)–electrochemiluminescent (ECL) method has been developed for the determination of gallic acid, based on an inhibition effect on the Ru(bpy)₃²⁺/tri-n-propylamine (TPrA) ECL system in pH 8.0 phosphate buffer solution. The method is simple and convenient with a determination limit of 9.0×10^–9 mol/L and a dynamic concentration range of 2×10^–8–2×10^–5 mol/L. The relative standard deviation (RSD) was 1.0% for 1.0×10^–6 mol/L gallic acid (n=11). It was successfully applied to the determination of gallic acid in Chinese proprietary medicine—Jianming Yanhou Pian. The inhibition mechanism proposed for the quenching effect of the gallic acid on the Ru(bpy)₃²⁺/TPrA ECL system was the interaction of electrogenerated Ru(bpy)₃^2+* and o-benzoquinone derivative at the electrode surface. The ECL emission spectra and UV-visible absorption spectra were applied to confirm the mechanism.     

On-line derivatization coupled to flow injection permanganate chemiluminescence detection of total carbonyl compounds in natural waters and drinking water

This work describes the development of a fast assay for the determination of low molecular weight carbonyl compounds based on the oxidative chemiluminescence of 2,4-dinitrophenylhydrazine with acidic permanganate, which is enhanced during conversion to the corresponding phenylhydrazone-carbonyl derivatives. By exploiting the common derivatization pathway and oxidation mechanism of phenylhydrazones under kinetically controlled conditions in a flow configuration, a common light emission is produced which corresponds to the total aqueous concentration of carbonyl compounds. The experimental conditions that afford the optimum analytical features were optimized for acetone, acetaldehyde and formaldehyde which constitute the most abundant carbonyl compounds in environmental samples. The method was successfully applied to the determination of total carbonyl content in natural waters and drinking water at the low μg L⁻¹ levels with satisfactory recoveries (94.0-99.5%) and very good reproducibility (RSD = 1.58-2.99%, n = 8, C = 2 μg L⁻¹). Validation of the results was performed with gas chromatography suggesting that the proposed method provides a fast alternative to the routine screening of low molecular weight carbonyl compounds in natural waters.     

Non-specific adhesion on biomaterial surfaces driven by small amounts of protein adsorption

This work explores how long-range non-specific interactions, resulting from small amounts of adsorbed fibrinogen, potentially influence bioadhesion. Such non-specific interactions between protein adsorbed on a biomaterial and approaching cells or bacteria may complement or even dominate ligand–receptor mating. This work considers situations where the biomaterial surface and the approaching model cells (micron-scale silica particles) exhibit strong electrostatic repulsion, as may be the case in diagnostics and lab-on-chip applications. We report that adsorbed fibrinogen levels near 0.5 mg/m² produce non-specific fouling. For underlying surfaces that are less fundamentally repulsive, smaller amounts of adsorbed fibrinogen would have a similar effect. Additionally, it was observed that particle adhesion engages sharply and only above a threshold loading of fibrinogen on the collector. Also, in the range of ionic strength, I, below about 0.05 M, increases in I reduce the fibrinogen needed for microparticle capture, due to screening of electrostatic repulsions. Surprisingly, however, ionic strengths of 0.15 M reduce fibrinogen adsorption altogether. This observation opposes expectations based on DLVO arguments, pointing to localized electrostatic attractions and hydration effects to drive silica–fibrinogen adhesion. These behaviors are benchmarked against microparticle binding on silica surfaces carrying small amounts of a polycation, to provide insight into the role of electrostatics in fibrinogen-driven non-specific adhesion.     

流动注射双安培法测定盐酸苯肼

使用经过恒电位预阳极化处理的双铂电极,在外加电压差为0.20 V时,通过偶合盐酸苯肼在一支电极上的氧化和氧化铂在另一支电极上的还原两个不可逆电极过程,建立快速准确分析测定盐酸苯肼的流动注射双安培检测法.结果表明:在pH为2.36的B-R缓冲溶液中,外加电位差为0.20 V时测得盐酸苯肼的氧化电流与其浓度在1.0×10~(-6)～1.0×10~(-4)mol/L范围内呈线性关系(r=0.9949,n=9),检出限为1.0×10~(-7)mol/L.对1.0×10~(-5)mol/L的盐酸苯肼溶液的连续23次测定,电流值的相对标准偏差为2.26%.常见离子均不干扰测定.样品处理方法简单,且有较高的选择性和灵敏性,结果令人满意.     

流动注射双安培法测定橙皮甙

基于橙皮甙的不可逆氧化和氧化铂的不可逆还原体系构成了双安培法直接检测橙皮甙的新方法。在外加电压为0.2 V时,通过偶合橙皮甙在一支电极上的氧化和氧化铂在另一支电极上的还原两个不可逆电极过程,构成流动注射双安培检测体系。在pH 8.95的B-R缓冲溶液中,测得橙皮甙的氧化电流与其浓度在6.0×10-6~8.0×10-4mol/L范围内呈良好的线性关系(r=0.9997,n=11),检出限为1.0×10-6mol/L。连续30次测定6.0×10-4mol/L橙皮甙,其峰电流相对标准偏差(RSD)为3.2%,常用药物赋形剂和无机离子均不干扰橙皮甙的测定。方法已用于江中健胃消食片中橙皮甙含量的测定。     

Cu(II)-imprinted styrene-divinylbenzene beads as a new sorbent for flow injection-flame atomic absorption determination of copper

The paper reports preparation and analytical features of a new Cu(II)-imprinted polymer, based on salen-OMe ligand 2,2′-[ethane-1,2-diylbis(nitrilo(E)methylylidene)]bis(6-allyl-4-methoxyphenol) and styrene-divinylbenzene matrix, as well as its application to on-line preconcentration and flame atomic absorption determination of copper. Sorbent beads (average diameter of 60-80 µm) were obtained using suspension polymerization technique and employed as a column filling. Copper sorption was the most effective at pH 6.8, whereas the highest elution effectiveness was observed when 0.5% HNO₃ was applied. The sorbent exhibited good long-term stability and acid resistance. Enrichment factor (EF) of 12 was found for 60 s loading time and loading flow rate of 4 mL min^− 1. EF value may be further increased by expanding the loading time and/or flow rate. Batch sorbent capacity in optimal pH conditions was found to be 0.16 mmol g^− 1 (9.55 mg g^− 1) of a dry polymer. Calcium(II) turned out to be the only significant interferent. Cadmium(II), silver(I), nickel(II), zinc(II) in concentrations lower than about 1 mg L^− 1 did not disturb copper(II) preconcentration. Different calibration methods such as: set of standards method (SSM), standard addition method (SAM) and combinatory calibration method (CCM) were employed for copper(II) determination in tap water, spring mineral water and certified reference material. Analysis of EU-H-3 reference material confirmed good accuracy of the proposed method. Relative standard deviation (RSD) was 3.2 for standard addition method and 2.8% for set of standard calibration method. Detection limit for sample consumption 16 mL was 1.03 and 1.07 µgL^-1 respectively.     

Flow injection wetting-film extraction system for flame atomic absorption spectrometric determination of cadmium in environmental waters

A newly simple flow injection wetting-film extraction system coupled to flame atomic absorption spectrometry (FAAS) has been developed for trace amount of cadmium determination. The sample was mixed on-line with sodium diethyl dithiocarbamate and the produced non-charged Cd(II)-diethyl dithiocarbamate (DDTC) chelate complex was extracted on the thin film of diisobutyl ketone (DIBK) on the inner wall of the PTFE extraction coil. The wetting-film with the extracted analyte was then eluted by a segment of the cover solvent, and transported directly to the FAAS for evaluation. All the important chemical and flow parameters were optimized. Under the optimized conditions an enhancement factor of 35, a sample frequency of 22 h⁻¹ and a detection limit of c_L = 0.7 μg l⁻¹ Cd(II) were obtained for 60 s preconcentration time. The calibration curve was linear over the concentration range 1.5-45.0 μg l⁻¹ Cd(II) and the relative standard deviation, R.S.D. (n = 10) was 3.9%, at 10.0 μg l⁻¹ concentration level. The developed method was successfully applied to cadmium determination in a variety of environmental water samples as well as waste-water sample.     

Simultaneous Determination of Caffeine,Ibuprofen, and Paracetamol by Flow‐injection Analysis with Multiple‐pulse Amperometric Detection on Boron‐doped Diamond Electrode

This work presents a simple, fast and low‐cost method for the simultaneous determination of three drugs by flow‐injection analysis with multiple‐pulse amperometric (MPA) detection using a wall‐jet flow cell with a boron‐doped diamond electrode. The amperometric determination of caffeine (CF), ibuprofen (IB) and paracetamol (PC) was performed by the application of a four‐potential waveform using the MPA technique. PC is oxidized at E₁ (1.20 V/70 ms) and thus selectively detected; PC and CF are oxidized at E₂ (1.49 V/40 ms); PC, CF and IB are oxidized at E₃ (1.70 V/70 ms); and E₄ (1.80 V/100 ms) is applied for electrode cleaning. The subtraction of currents obtained at the different potentials did not provide accurate determinations of CF and IB, thus it was required to investigate correction factors to determine CF and IB without the interference from PC and CF using the respective amperometric signals obtained at E₂ and E₃. The proposed method was successfully applied for the determination of three drugs in pharmaceutical samples with low generation of residues and a high analytical frequency (150 h^?1) in comparison with HPLC‐DAD method.