流动注射在线共沉淀HG-AFS测定痕量铅

建立了流动注射在线共沉淀HG-AFS测定痕量铅的分析方法。方法基于铅在碱性介质中与氢氧化镁共沉淀，沉淀收集在锥形沉淀腔中，用HCl溶洗沉淀和NaBH4反应，产生的氢化物被载气引入原子化器中进行测定。测定铅的RSD为3％(5ng/mL，n=10)，检出限为0．01ng。检出限较直接进样降低了11倍。对国家标准物质中铅的测定结果与标准值相符。     

流动注射-速差动力学分析研究 meso-四-(4-三甲铵基苯)卟啉光度法测定痕量铅

本文研究了多种金属离子与meso-四-(4-三甲铵基苯)卟啉的显色反应动力学特性。利用Pb(Ⅱ)和其它金属离子之间的反应速差,建立了一种选择性好的测定痕量Pb(Ⅱ)的流动注射分析法。将此法应用于陶瓷和人发样品中铅的直接测定,结果满意。     

停留—催化反应速差动力学法同时测定Fe,Mo

根据Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）对Ｈ２Ｏ２氧化邻氨基酚的催化反应速率不同，结合流动注射停留技术，建立了同时测定Ｆｅ（Ⅲ）、Ｍｏ（Ⅵ）的速差动力学分光光度法．测定铁和钼的线性范围分别为０．１～２．５μｇ／ｍＬ和０．５～１５μｇ／ｍＬ．除Ｗ（Ⅵ）的允许量较小外，其它离子不干扰测定．用本法测定了合成样液中铁和钼含量，结果满意．     

二乙基二硫代氨甲酸银体系流动注射法测定砷

本文设计了一种ＡｇＤＤＣ流动注射－分光光度法测定砷的系统。该系统采用自制的氢化物发生及吸装置，将液体流路和载气流路结合在一起。     

A flow injection-ETAAS system for the on-line determination of total and dissolved silica in waters

In this work total (Si-tot) and ‘soluble’ or reactive (Si-sol) concentrations of silicon in natural and tap waters were sequentially determined by electrothermal atomic absorption spectrometry (ETAAS). First, samples were on-line diluted based on the merging-zone principle in order to allow the determination of Si-tot within the 300–1000 μgSi l⁻¹ range. After the dilution process, a sub-sample was collected in the capillary of a sampling arm assembly (SAA). Thereafter, samples were subject to a precipitation/dissolution process in order to allow the determination of Si-sol within the 280–850 μgSi l⁻¹. Si-sol was precipitated with ammonium chloride and collected on the walls of a knotted coil. The precipitate was dissolved with ammonium molybdate in an acidic medium (HNO₃) and a sub-sample was then collected in the SAA. In both cases, 10 μl volumes of the sub-sample were injected into the atomizer with the previous introduction of 20 ng of Eu as chemical modifier (10 μl) by the spectrometer autosampler. The recovery values obtained with natural waters spiked samples were over 46% and the agreement between observed and certified samples values was good. The proportion of Si-sol in comparison with the Si-tot was high (85–95%) in most natural waters. The precision of the method was 2.4–3.5 and 4.5–6.2% (n=10) for the determination of Si-tot and Si-sol, respectively.     

A downsized flow set up based on multicommutation for the sequential photometric determination of iron(II)/iron(III) and nitrite/nitrate in surface water

In this work, a downsized flow set up designed based on multicommutation concept for photometric determination of iron(II)/iron(III) and nitrite/nitrate is surface water is described. The flow system network comprised a set of three-way solenoid valves, reaction coil and a double-channel flow cell, which were nested in order to obtain a compact and small-size instrument. To accomplish the downsizing requirement light source (LED) and radiation detection (phototransistor) were coupled to the flow cell. In order to demonstrated the effectiveness of the system, the photometer methods based on Griess reaction and 1-10-phenantroline for nitrite and iron(II) determination, respectively, were selected. Under computer control the set up provided facilities to handle four reagent solutions employing a single pumping channel, thus permitting also the determination of nitrate and iron(III) after its reduction to nitrite and to iron(II), respectively. The overall system performance was demonstrated working several days running standard solution, no significant variation of base line, linear response range and slop (less than 1%) were observed. The usefulness of the downsized system was ascertained by analyzing a set of surface water. Aiming to access the accuracy sample were also analyzed employing reference procedures and no significant difference at 95% confidence level were observed for the four analytes. Other profitable features such as analytical throughput of 40 determination per hour; relative standard deviation of 1%; linear response range between 50 and 300 μg l⁻¹ for nitrite and nitrate, 0.5-6.0 mg l⁻¹ iron(II) and iron(III); low reagent consumption 75 μg for nitrate/nitrite and 0.6 mg for iron(II)/iron(III) per determination; and 2.4 ml waste generation per determination were also achieved.     

Differences in the electrorheological response of a particle suspension under direct current and alternating current electric fields

We have observed an unusual reduction of shear stress with increasing shear rate under direct current electric fields, for an electrorheological fluid composed of sulfonated poly(styrene-co-divinylbenzene) particles dispersed in silicone oil. At all shear rates, the shear stress under the electric field is larger than that in the absence of the field, indicating that there is still some field-induced agglomeration of the particles. In contrast, the behavior under alternating current electric fields is the Bingham-fluid-type response commonly observed with electrorheological fluids. It is suggested that the conventional dipole–dipole interaction approach based on simplified microstructural models would be unable to explain these phenomena. Received: 27 November 2000 Accepted: 22 May 2001     

Determination of polar organic compounds by potentiometry at an anodically pretreated nickel oxide electrode

The open-circuit potential drop of an oxidatively pretreated nickel electrode in 0.1 M NaOH was used to develop a technique for the determination of alcohols, amino acids, carbohydrates, etc., in aqueous solution. The electrode pretreatment consisted of the formation of nickel hydrated oxides on the electrode surface with an oxidation state > 2. Both electrochemical and chemical pre-oxidation of the electrode surface were examined. The analytical signal was the enhancement of the potential drop corresponding to analyte concentration. The analytical signal was linearly related to the logarithm of the analyte concentration. The limits of determination ranged from 1 mM for low-molecular-weight to 0.02 mM for alkyl polyether alcohols. The flow-injection technique allows convenient pretreatment and direct observation of the analytical signal. Interferences from chloride and calcium can be readily eliminated by excluding them during electrode pretreatment. Potentiometric measurements were correlated with amperometric anodic responses at the nickel oxide electrode, allowing an unusual direct comparison of the two methods.     

10°锥角台锥型液相色谱柱尺寸等比例放大和柱内谱带流型的可视化研究

摘要利用改进的可视化装置, 研究了10°锥角的台锥型液相色谱柱内的谱带流型与柱参数变化的关系. 将有机玻璃柱管加工成内圆台外方型的一体结构, 选择折射率一致的色谱固定相硅胶和流动相环己烷, 使整个色谱柱成为高度清晰的透明体, 能直接观察柱中彩色样品谱带的动态三维流型. 研究结果表明, 在实验条件范围内, 流动相流速对谱带流型无影响, 填料的形状和性质对塞子状流型有一定程度的影响. 比较了柱长为5cm和等比例放大后柱长为10cm锥型柱内的流型, 发现放大后的锥型柱内仍然保持塞子状流型, 总柱效等比例增加. 表明继续按比例放大成为工业规模色谱柱后仍能保持塞子状流型.     

流动注射电位滴定研究：氟化物沉淀滴定测锂

设计制作了一种简便的梯度混合室,并考察了其性能,试验结果证实了此混合室的合理性和有效性.用此混合室建立了流动注射电位滴定测锂的新方法,载流为1×10~(-5)～1×10~(-4)mol·L~(-1)的F~乙醇-水(9 1)溶液,流速4.2ml·min~(-1),混合室体积400μl,进样体积120μl,分析速度60样·h~(-1),检出范围取决于载流中滴定剂的浓度,方法用于卤水中锂的测定,结果令人满意.