Entropy of Einstein—Maxwell-Dilaton—Axion Black Holes

The entropy of Einstein—Maxwell-dilaton—axion black holes is calculated by using the improved brick-wall model. Taking into account of the statistical physics, we propose not to consider the superradiant modes. The result shows that the nonsuperradiant modes do contribute exactly the area-law entropy for extreme black hole. Moreover, our cut-off which does not require an angular cut-off is independent of angle . As for the extreme black hole, we found that its entropy is zero.     

Single-particle quadrupole electromagnetic transitions in p-shell and sd-shell nuclei

Electron scattering Coulomb form factors for the single-particle quadrupole transitions in p-shell and sd-shell nuclei have been studied. Core polarization effects are included through a microscopic theory that includes excitations from the core orbits up to higher orbits with 2ω excitations. The modified surface delta interaction is adopted as a residual interaction. The results are discussed for the ( 1p _1/2 ^-1↦1p _3/2 ^-1) proton transition in ¹⁵N, ( 1d _5/2↦2s _1/2) neutron transition in ¹⁷O and ( 1d _3/2 ^-1↦2s _1/2 ^-1) proton transition in ³⁹K. The inclusion of core polarization effects modifies the form factors markedly and describes the experimental data very well in both the absolute strength and the momentum transfer dependence. Received: 18 April 2002 / Accepted: 1 July 2002 / Published online: 6 March 2003 RID="a" ID="a"e-mail: baguniv@uruklink.net Communicated by A. Molinari     

System Identification Models of the Equivalent Permittivity for Rain Medium

The dielectric constant for rain medium is investigated by utilizing the system identification method. The rain rate model and frequency model of permittivity in millimeter waves band for rain medium are presented. The results obtained with models are in very good agreement with references in calculating the attenuation of electromagnetic waves induced by rain, which Shows that the obtained models are valid and practicable. The cross-polar discrimination gotten with rain rate model is in agreement with references.     

An anatomically accurate eye model with a shell-structure lens

A human eye model based on anatomically accurate eye model previously proposed by Liou, has been transformed into a new eye model, in which laminated structure of the lens is considered. The crystalline lens is presented in the form of hundreds of shells with rotational symmetry, and with constant index within each shell. The refractive index increases from the cortical shell to the inner one, according to the equation proposed by Smith G. et al. The anterior surface of the lens is prolate, whereas the posterior surface of the lens is oblate which is consistent with the anatomical data. A ray tracing procedure has been applied to study the refractive structure of the eye. The optical characters of the model have been studied. The reason that the wings occur on the spherical aberration curve has been given. And we found that the lens with gradient refractive index and lens with shell structure can give same longitudinal spherical aberration results.     

分形(fractal)几何与岩石断裂

岩石断口的不规则性可以统计地认为具有自相似性,由此本文应用新几何——分形(fractal) 几何来描述这种不规则性。建立了穿晶以及沿晶界和穿晶相偶合的微观断裂fractal 模型,用电镜和光学显微镜观察了大量岩石断口的 fractal 特征,得到了 fractal 维数与岩石宏观断裂力学量之间的初步对应关系。     

A numerical exploration of secondary separation in starting flow around a flat plate by the discrete vortex model

In the present work, a further numerical simulation of the starting flow around a flat plate normal to the direction of motion in a uniform fluid has been made by means of the discrete vortex method. The secondary separation occurring at rear surface of the plate is explored, and predicted approximately using Thwait's method. The calculated results show that in the early stages of the flow secondary separation does occur. The evolution of flow field, the vortex growing process and the characteristics of secondary vortices have been described. The time dependent drag coefficients, the vorticity shed from the edges and rear surface, and the separation positions are calculated as well as the distributions of velocity and pressure on the plate. In the case of flow normal to the plate, the calculated secondary vortices are weak. Their existence will change the local velocity distributions and affect pressure distributions. However, the effect on drag coefficient is negligible.     

On the reliability of unsaturated hydraulic conductivity calculated from the moisture retention curve

In comparison with direct measurements of unsaturated hydraulic conductivity, the methods of calculations from the moisture retention curve are attractive for their fast and simple use and low cost. These are the main reasons for their increasing use, mainly in spatial variability studies. On the other hand, it is known that their applicability is limited. The possibility of the use of the retention curve to indirectly determine hydraulic conductivities is analyzed as follows. The theoretical derivation of the relationK(h) – (h) is briefly discussed with regards to potential sources of inaccuracy. The sensitivity of the algorithm forK(h) calculation is studied as a response to possible inaccuracies in the retention curve determination. Conclusions about the usability of calculated hydraulic conductivities are drawn.     

Rheological models for gypsum plaster pastes

Shear stress and shear rate data obtained for gypsum plaster pastes were correlated by means of different rheological models. The pastes were prepared from a commercial calcium sulfate hemihydrate at various water/plaster ratios ranging from 100/150 to 100/190. The tests were performed at 25°C using a rotating coaxial cylinder viscosimeter. The measurements were accomplished by applying a step-wise decreasing shear rate sequence. Discrimination among the models was made: (1) on the basis of the fitting goodness; (2) by checking the physical meaning of the calculated parameters; (3) on the basis of the stability of the parameters and of their prediction capacity beyond the limits of the experimental data. In the light of above, the Casson model seemed to be most effective for application to gypsum plaster pastes. K Consistency - n Power-law index - N Number of experimental data - P Number of parameters - Shear rate (s^–1) - ₀ Viscosity (Pa · s) - _d Dispersing medium viscosity (Pa · s) - _p Plastic viscosity (Pa · s) - Viscosity at zero shear rate (Pa · s) - Viscosity at infinite shear rate (Pa · s) - [] Intrinsic viscosity - ² Variance - Shear stress (Pa) - ₀ Yield stress (Pa) - Solid volume fraction - _m Maximum solid volume fraction     

Further study on vortex shedding flow by a circular cylinder

In the present paper the mechanism involved in vortex shedding flows is investigated in detail. In the early stage of the unsteady separated flow the interaction between secondary vortices and primary vortices is quite strong. In the later stage of the flow, corresponding to the vortex shedding the recirculating flow region on each side of the aft body goes through such a cycle: growth-contraction-growth, the secondary separation occurs periodically rather than continuously. The reduction of circulation is taken into account in three cases with different decay factors to study its influence on the prediction of main flow characteristics. Results show that to simulate vortex shedding flow it is necessary to include the reduction of circulation to bring the calculated results into good agreement with experiments. An improved discrete vortex model is suggested in which both the secondary separation and the reduction are incorporated. The processes of vortex shedding, the forces prediction and other flow characteristics are given and some discussions are made. Porject is supported by National Natural Science Foundation of China.     

A thermodynamic approach to non-linear viscoelasticity

We show that Extended Irreversible Thermodynamics (EIT) may be regarded as a unifying thermodynamic scheme which generates a variety of non-linear viscoelastic equations of state. In particular, we show how the so-called eight-constants Oldroyd model, with all its invariant properties, may be derived from the postulates of EIT. It is also shown that the structure of the thermodynamic based rheological equations of state is in complete agreement with that of the representation theorems formulation of constitutive relationships originally proposed by Rivlin and Ericksen. We discuss how more complex rheological models can be derived from higher order approximations of the theory. Finally, the connections between our approach and other related works are briefly discussed.