双折射器件对机载激光雷达偏振探测影响的研究

根据膜层理论给出了机载激光雷达回波信号垂直入射偏振棱镜时偏振平行分量透过率的数学解析表达式,定量分析了偏振棱镜对机载激光雷达回波信号平行分量透过率的影响,理论计算表明：棱镜晶体厚度、空气膜层厚度及棱镜结构角共同影响回波信号通过偏振棱镜的透过率;当回波信号波长为532 nm,利用1/2石英波片测得的偏振平行通道和偏振垂直通道的增益比k为1.2时,机载激光雷达偏振通道增益比k的真实值在1.003～1.463之间,若不考虑1/2波片对k值的影响,会给退偏振比反演带来较大的系统误差.     

Automated phase correction via maximization of the real signal

Due to improved quantification capabilities and enhanced signal-to-noise ratio (SNR), phase-corrected real reconstruction in magnetic resonance imaging is superior to the common magnitude reconstruction, especially at low SNR. This requires the development of an automated phase-correction algorithm. Existing methods are not well suited for multiple unconnected regions of very low SNR. For this situation, a method based on the real-signal maximization is implemented, in which the experimental image phase is approximated by a three-dimensional polynomial of up to third order. The presented implementation was successfully applied to data originating from different samples and pulse sequences.     

分离式热管换热器传热特性的实验研究

本文在自行设计分离式热管实验装置的基础上,对其传热特性进行了实验研究。其工作温度为170～250℃,热流密度为25～50 kW/m~2。蒸发段和冷凝段构成相同,均是由7根直径30 mm的无缝钢管短管束组成,管长为160 mm,带有紧套的钢帛环形肋片结构尺寸为:外径45 mm、厚1 mm、片间距4 mm。实验结果表明,在本实验条件下,分离式热管的最佳充液率按管束总容量计为18%～38%。根据实验结果拟合了最佳充液率(24%)下蒸发段内部平均沸腾换热系数和冷凝段内部凝结换热努塞尔数综合关系式。     

数字域时间延迟积分时间CMOS相机高分“凝视”成像设计分析

为实现凝视卫星高分跟踪成像,设计了数字域时间延迟积分(TDI)互补金属氧化物半导体(CMOS)传感器在凝视姿态下的成像匹配模型,推导了卫星凝视跟踪成像时相对轨道坐标系的姿态变化,采用坐标变换方法实时计算其在凝视过程中随姿态变化的行转移时间,利用蒙特卡罗方法统计计算了凝视模式下姿态指向精度和稳定度对成像的影响。利用数字域TDI CMOS原理样机和小卫星姿态控制系统全物理仿真平台对成像进行了仿真分析。结果表明,卫星的姿态控制精度在成像过程中会引起纵向的像移速度失配和横向匹配的残余像移,成像积分级数越高,图像信噪比越大。积分级数的增加对卫星姿态提出较高要求,仿真平台姿态角和姿态角速度控制精度分别优于0.05°,0.005°/s时,采用积分级数为48级能较好地满足成像质量要求。     

Minimum SNR and acquisition for bias-free estimation of fractional anisotropy in diffusion tensor imaging - a comparison of two analytical techniques and field strengths

Although it is known that low signal-to-noise ratio (SNR) can affect tensor metrics, few studies reporting disease or treatment effects on fractional anisotropy (FA) report SNR; the implicit assumption is that SNR is adequate. However, the level at which low SNR causes bias in FA may vary with tissue FA, field strength and analytical methodology. We determined the SNR thresholds at 1.5 T vs. 3 T in regions of white matter (WM) with different FA and compared FA derived using manual region-of-interest (ROI) analysis to tract-based spatial statistics (TBSS), an operator-independent whole-brain analysis tool. Using ROI analysis, SNR thresholds on our hardware-software magnetic resonance platforms were 25 at 1.5 T and 20 at 3 T in the callosal genu (CG), 40 at 1.5 and 3 T in the anterior corona radiata (ACR), and 50 at 1.5 T and 70 at 3 T in the putamen (PUT). Using TBSS, SNR thresholds were 20 at 1.5 T and 3 T in the CG, and 35 at 1.5 T and 40 at 3 T in the ACR. Below these thresholds, the mean FA increased logarithmically, and the standard deviations widened. Achieving bias-free SNR in the PUT required at least nine acquisitions at 1.5 T and six acquisitions at 3 T. In the CG and ACR, bias-free SNR was achieved with at least three acquisitions at 1.5 T and one acquisition at 3 T. Using diffusion tensor imaging (DTI) to study regions of low FA, e.g., basal ganglia, cerebral cortex, and WM in the abnormal brain, SNR should be documented. SNR thresholds below which FA is biased varied with the analytical technique, inherent tissue FA and field strength. Studies using DTI to study WM injury should document that bias-free SNR has been achieved in the region of the brain being studied as part of quality control.     

单级自动复叠混合工质制冷循环的实验研究

由于压缩机压比的局限,制约着单一制冷剂的压缩回热循环发展,本系统采用单一压缩机和混合工质的自复叠制冷循环系统取得了较好的制冷效果。文中对单级自动复叠制冷系统进行了理论模拟,并设计和搭建了实验台进行分析。通过理论和实验数据的分析得出混合工质组合R600a/R23,并初步得到最优配比。     

含散射闪光照相系统的布局优化

为了提高现有照相系统的图像品质,对使用CCD探测器的法国客体(FTO)照相布局进行了优化,获得最佳图像品质因子下的照相布局。研究结果为:在模糊实验测量结果和高斯分布近似下,系统放大倍率为2.0;后保护器件距离客体50 cm;系统布局总长与探测系统的噪声相关,噪声越大,布局总长越短,最优布局总长的范围为3~5 m;实验验证了这一结果。     

用于诊断纳秒脉冲电流的微分环现场标定技术

分析了用于纳秒脉冲电流测量的微分环标定难点,提出微分环现场标定方法。通过脉冲形成线脉冲充电以解决微分环标定中信噪比较低、可信度较差等问题;分析了脉冲形成线充电时间、充电电压及脉冲形成开关击穿电压等回路参数对标定结果的影响。基于闪光二号加速器,对测量二极管电流的微分环进行了现场标定,前级隔离开关平均击穿电压为25 kV时,微分环标定回路电流达到1.3 kA,微分环灵敏度为9.311010,方差为0.151010。     

Improved Light-Cone QCD Sum Rule Analysis of Rare Decays Λ_b → Λ_γ and Λ_b → Λl~+ l~-

We present a systematic light-cone QCD sum rule study of the exclusive rare radiative decay Λ b →Λγ and rare semileptonic decay Λ b →Λl + l within the framework of the standard model. Although some light-cone sum rule (LCSR) studies on these rare processes can be found in different literatures, it is necessary to reanalyze them systematically for the reason that either the baryonic distribution amplitudes are improved or different interpolating currents for the Λ b baryon may lead to quite different results. In addition, the rare process Λ b →Λγ has not yet been analyzed by LCSR with the Ioffe-type current. Taking all these reasons into account, we perform LCSR calculations of both the processes with two types of interpolating currents. Our calculations show that the choice of the interpolating current for the Λ b baryon can affect the predictions significantly, especially for the rare radiative decay process.     

Primary result of ~(236)U measurement with accelerator mass spectrometry at CIAE

The rare isotope 236U has a half-life of 2.342(3)×107 years,and is produced principally by thermal neutron capture on 235U.The isotopic atom ratio of 236U/238U depends on the integral thermal neutron flux received by the material of interest.236U is potentially useful as a fingerprint for indicating the presence of neutron-irradiated uranium usually originating from nuclear activity.By extracting negative molecular ion UO- from the uranium oxide target,simulating the 236U16O- beam transport with 238U16O- an...