Application of the Dorodnitsyn finite element method to swirling boundary layer flow

The Dorodnitsyn finite element method for turbulent boundary layer flow with surface mass transfer is extended to include axisymmetric swirling internal boundary layer flow. Turbulence effects are represented by the two-layer eddy viscosity model of Cebeci and Smith¹ with extensions to allow for the effect of swirl. The method is applied to duct entry flow and a 10 degree included-angle conical diffuser, and produces results in close agreement with experimental measurements with only 11 grid points across the boundary layer. The introduction of swirl (w_e/u_e = 0.4) is found to have little effect on the axial skin friction in either a slightly favourable or adverse pressure gradient, but does cause an increase in the displacement area for an adverse pressure gradient. Surface mass transfer (blowing or suction) causes a substantial reduction (blowing) in axial skin friction and an increase in the displacement area. Both suction and the adverse pressure gradient have little influence on the circumferential velocity and shear stress components. Consequently in an adverse pressure gradient the flow direction adjacent to the wall is expected to approach the circumferential direction at some downstream location.     

A setup heuristic for interval orders

The setup minimization problem for linear extensions of interval orders is considered and a simple greedy heuristic is shown to be never worse than twice the optimum.     

Numerically induced oscillations in finite element approximations to the shallow water equations

Numerical noise has been a problem with finite element solutions to the shallow water equations. Two methods used to reduce the noise level are evaluated, and these results are compared with published results for equal-order interpolations. The two methods are mixed-interpolation (quadratic interpolation for velocity and linear interpolation for sea level) and a spectral form of the wave equation. Whereas mixed interpolation removes the troublesome sea level mode, it can still have considerable noise in velocity. The spectral wave equation is efficient and does not contain the spurious eigenmodes which contribute to high noise levels.     

The effect of the choice of the reference pressure location in numerical modelling of incompressible flow

The discontinuity of a finite-element pressure field that is sometimes present in the neighbourhood of the pressure-specification-point is shown to arise either from round-off, or from mistakes in modelling. The implications of this are considered. In particular it restricts grid refinement near the pressure-specification-point. The analysis can be extended to finite-difference calculations, and to other fields governed by equations similar to Poisson's equation.     

IDENTIFICATION OF MULTIVARIATE ARMA MODELS

ＩＤＥＮＴＩＦＩＣＡＴＩＯＮＯＦＭＵＬＴＩＶＡＲＩＡＴＥＡＲＭＡＭＯＤＥＬＳＬＩＧＵＩＢＩＮ（李贵斌）（ＤｅｐａｒｔｍｅｎｔｏｆＰｒｏｂｏｂｉｌｉｔｙａｎｄＳｔａｔｉｓｔｉｃｓ，ＰｅｋｉｎｇＵｎｉｖｅｒｓｉｔｙＢｅｉｊｉｎｇ１００８７１，Ｃｈｉｎａ）...     

Wave equation hydrodynamics on deforming elements

The shallow water wave equation is derived in a general deforming co-ordinate system. A weak form is developed which displays the natural boundary condition prominently and which may be implemented on C⁰ elements. A time-stepping algorithm is implemented with clastic mapping of interior node motion. Lossless test cases show agreement with analytic solutions. A simple hypothetical test case shows intuitively good behaviour at length scales approaching those required of estuarine simulations.     

Arrow's theorem: unusual domains and extended codomains

In this paper we establish Arrow's theorem in a general ordinal case. When some configurations are allowed in the domain and if this domain is included in the codomain, the only social functions satisfying the independence condition and the weak Pareto Principle are the absolute dictatorships or the absolute oligarchies.     

Conforming finite element computations applied to a spatially periodic,harmonic Navier-Stokes problem

In this paper computations in the two dimensional case of a harmonic Navier-Stokes problem with periodic boundary conditions are presented. This study of an incompressible viscous fluid leads to a non-symmetric linear problem (very low Reynolds number). Moreover unknown functions have complex values (monochromatic dynamic behaviour). Numerical treatment of the incompressibility condition is a generalization of the classical treatment of Stokes problem. A mixed formulation, where discrete pressure plays the role of Lagrange multipliers is used (Uzawa algorithm). Two conforming finite element methods are tested on different meshes. The second one uses a classical refinement in the shape function: the so-called bulb function. All computational tests show that the use of a bulb function on each element gives better results than refinement in the mesh without introducing too many degrees of freedom. Finally numerical results are compared to experimental data.     

Three-dimensional study of extrusion processes by Boundary Element Method.

In this paper we report an implementation of a Boundary Element Method (BEM) dealing with three-dimensional extrusion problems of viscous fluid. Die shapes with and without sharp corners and their influence on the final shape of extrudate have been studied: both shrinkage and swelling of the extrudates relative to the original die shapes have been discovered. The first half of this paper deals with the problem of implementing isoparametric boundary elements. It is followed by results of test problems, and finally the results of extrusion study are presented.     

胃康灵胶囊中15种元素含量分析

微波消解法制备供试品,电感耦合等离子体-质谱(ICP-MS)法测定中成药胃康灵胶囊中15种元素的含量,探讨其宏量、微量元素与疗效的关系。胃康灵胶囊中常量元素含量丰富,微量元素含量差别较大,Fe含量最多,Se含量最少,有害元素含量不高。胃康灵胶囊中元素与胃炎及胃溃疡的治疗密切相关。