Temperature-sensitive polypeptide brushes-coated mesoporous silica nanoparticles for dual-responsive drug release

A multifunctional nanohybrid based on mesoporous silica nanoparticle and biocompatible polypeptide was fabricated for targeted and dual-responsive therapy of tumor cells.     

Sample evaporation in conventional split/splitless GC injectors. Part 3: Retaining the liquid in the vaporizing chamber

As most sample liquids tend to pass through an empty injector insert at a speed which is too high to enable complete evaporation, movement of the liquid must be arrested before it reaches the column entrance. Stopping the liquid means deposition on to a surface; this, however, is possible only after the temperature of the surface has been cooled to (or below) the boiling point of the liquid (solvent). The performance of different means of stopping the liquid has been tested visually (by the method described in Part 2). Baffles on the wall of the injector insert had hardly any effect on evaporation: the band of liquid leaving the syringe needle performed a perfect slalorn around them. The inverted cup proved more efficient, but the best performance was obtained from a light plug of glass wool: owing to its low thermal mass, the first fibers to be met by the liquid are immediately cooled to the solvent boiling point, allowing the liquid to wet it. The sample liquid is sucked up by the glass wool, from where the sample evaporates relatively slowly, often over a period of several seconds.     

Ultrasensitive fluorescent probe for the hydrophobic range of solvent polarities

The new 3-hydroxychromone derivative 2-(6-diethylaminobenzo[b]furan-2-yl)-3-hydroxychromone (FA) displays a dramatic solvent-dependent transformation of fluorescence spectra in the range of low-polarity solvents. The two well-separated emission bands change their relative intensities so that the short-wavelength band being of a very low intensity in hexane becomes dominant in the more polar ethyl acetate and trichloromethane. We suggest the participation in this effect of excited-state intramolecular proton transfer, which is characteristic for other 3-hydroxychromone and 3-hydroxyflavone derivatives, in the range of solvents of much higher polarities. Because of these unique properties, a number of spectroscopic parameters (positions of absorption and two fluorescence maxima, the ratio of their intensities and the fluorescence quantum yield) can be measured in this solvent range with multiparametric analysis of the data. In terms of solvent polarity, the shifts in both emission bands and their intensity ratio demonstrate a good correlation with empirical polarity scales E_T^N, P_y and SPP, while the absorption spectra reveal some deviations for the tested oxygen-containing solvent molecules. A good cross-correlation is observed between fluorescence spectral shifts and the ratio of band intensities. The latter provides the means for a dramatic amplification of solvent response. Thus, a new approach for ultrasensitive scaling and probing the solvent polarity in the low-polararity range can be suggested. It involves very simple ratiometric measurements at two emission bands and can be posed for a variety of applications. We present examples of these applications for distinguishing of polarities between methylated benzene derivatives, for quantitative assay of polar impurities in low-polar solvents and for detection of the changes of solvent polarity as a function of temperature.     

An investigation of microbore reverse-phase columns containing 3 μm packing materials

A procedure for packing 15 cm × 1 mm id reverse-phase microbore columns with 3 μm silicas obtained from different manufacturers is described. The speed of analysis and detection limits are compared to those obtained with a 50 cm × 1 mm id column packed with 10 μm ODS. The effect of detector time constant on the system, and flow rates on column efficiency are also examined.     

Dual‐Amplification of Antigen–Antibody Interactions via Backfilling Gold Nanoparticles on (3‐Mercaptopropyl) Trimethoxysilane Sol‐Gel Functionalized Interface

A new dual‐amplification strategy of electrochemical signaling from antigen–antibody interactions was proposed via backfilling gold nanoparticles on (3‐mercaptopropyl) trimethoxysilane sol‐gel (MPTS) functionalized interface. The MPTS was employed not only as a building block for the electrode surface modification but also as a matrix for ligand functionalization with first amplification. The second signal amplification strategy introduced in this study was based on the backfilling immobilization of nanogold particles to the immunosensor surface. Several coupling techniques, such as with nanogold but not MPTS or with MPTS but not nanogold, were investigated for the determination of carcinoembryonic antigen (CEA) as a model, and a very good result was obtained with nanogold and MPTS coupling immunosensor. With the noncompetitive format, the formation of the antigen–antibody complex by a simple one‐step immunoreaction between the immobilized anti‐CEA and CEA in sample solution introduced membrane potential change before and after the antigen–antibody interaction. Under optimal conditions, the proposed immunosensor exhibited a good electrochemical behavior to CEA in a dynamic concentration range of 4.4 to 85.7 ng/mL with a detection limit of 1.2 ng/mL (at 3 δ). Moreover, the precision, reproducibility and stability of the as‐prepared immunosensor were acceptable. Importantly, the proposed methodology would be valuable for diagnosis and monitoring of carcinoma and its metastasis.     

A study of the behaviour of some new column materials in the chromatographic analysis of Cinchona alkaloids

Summary A major problem in the HPLC analysis of alkaloids is the poor peak shape and consequently low resolution, due to the interactions of the basic alkaloids with the residual acidic silanol groups of most reversed phase materials. The performance of new packing materials specially designed for the separation of basic compounds has been studied using mobile phases without the special additives commonly applied in the analysis of alkaloids. Strongly basic Cinchona alkaloids were used as test compounds. Retention characteristics and selectivities of each material were studied, after mobile phase optimisation for the column. The influence of the major factors (nature and content of the organic modifier, pH value, salt concentration) affecting resolution was studied. The mobile phases were chosen so that they could be used in thermospray LC-MS. The addition of salts to the mobile phase improves separation but in general the modification of the mobile phase gave little change in selectivity. The performance of silicabased C₁₈ material proved superior to the polymer materials tested.     

双核三螺旋铁配合物的合成和结构

本文选择了2-羟基-1-萘醛与水合肼形成的席夫碱,[(HO)(C₁₀H₆)CH=N-N=CH(C₁₀H₆)(OH)],作为配体,设计组装了双核三螺旋的三价铁配合物。配合物中每一个铁离子以准八面体的配位方式分别与三个NO双齿单元配位, 三个配体分别桥联两个金属形成特定的三螺旋构型。分子内和分子间的π-π堆积作用对螺旋体的形成和堆积方式起着十分重要的作用。作为对照,本文还报道了配体的晶体结构。     

Efficient catalytic aza-Michael additions of carbamates to enones: revisited dual activation of hard nucleophiles and soft electrophiles by InCl3/TMSCl catalyst system

The aza-Michael reaction of a variety of chalcones with weaker nucleophilic carbamates catalyzed by InCl₃ in the presence of TMSCl via the entry of dual activation of both hard nucleophiles (carbamates) and soft electrophiles (enones) to provide the corresponding adducts in good yields. The first example of enantioselective aza-Michael reaction of chalcones with carbamates was also investigated in the presence of the present catalyst system.     

双光束流动注射光度法测定生活用水中氯离子

将流动注射分析技术应用到双光束分光光度法中，对其理论和实验技术进行了研究，采用自行组装的流动注射系统进行了生活用水中氯离子的测定，获得满意结果。     

A deterministic algorithm for constrained enumeration of transmembrane protein folds

A deterministic algorithm for enumeration of transmembrane protein folds is presented. Using a set of sparse pairwise atomic distance constraints (such as those obtained from chemical cross-linking, FRET, or dipolar EPR experiments), the algorithm performs an exhaustive search of secondary structure element packing conformations distributed throughout the entire conformational space. The end result is a set of distinct protein conformations, which can be scored and refined as part of a process designed for computational elucidation of transmembrane protein structures.