细长竖直管路内自然对流沸腾临界热通量研究

l引言管内或窄小流路内的自然对流沸腾CHF的研究比较少。文献［1～41对水及氟里昂系等液体进行了实验，在Kutataladze【’］的池内沸腾无量式基础上，提出如下经验公式当L／De－－＋0时上式退化为池内沸腾公式。式中qm。x是临界热通量；Hi。是蒸发潜热；。是汽液界面张力；尸l和p。分别是液体和蒸汽的密度；9是重力加速度；c是实验常数；不同研究者之间相差很大。当L／De较大时各经验公式的计算值会相差l～2倍。式（1）没有任何物理机理的支持，仅以J和L／De之间的无量纲关系对实验值进行统计整理，对物性的实际影响、De独立于L／De的…     

关于离子选择电极分析中的二次标准加入-逼近法的研究

本文导出了一种简单的离子选择电极分析二次标准加入-逼近法的表达式,通过在标准溶液中加入总离子强度调节缓冲溶液（TISA）来保持试液离子强度恒定,进行了文献数据及实验检验,方法简便。     

Stationary optimal control of a stochastic system with stable environmental interferences

In this paper, we consider a class of nonstationary control systems. We obtain some conditions for stationary optimal controls of such systems. The results are then applied to a linear-quadratic system.     

The Doss Trick on Symmetric Spaces

The Doss trick is employed to find solutions of Schrüdinger equations on symmetric spaces of compact type. The potentials and initial conditions are taken from an algebra of functions which admit an holomorphic extension to the complexification of the considered symmetric spaces.     

形学家的世界

形学家从存在的形状、构型和形貌的角度看世界.他们用数学的语言描述大自然的结构花样,并从外在的形式出发去理解物理世界最本质的规律."形"的美学感召足他们科学研究和艺术创造的驱动力.     

强流相对论电子束的数值模拟

我们研制了CEBQ程序和ENVLOP程序，模拟稳态相对论电子束在二极管区的产生和加速，以及电子束在阳极通道内的传输过程。CEBQ程序模拟二极管区电子轨道，当阳极电压为1．5MV时，阴极总发射电流为17．9kA，进入阳极通道内的传输电流为4．3kA，阳极入口处D=4cm的束发射度为24．9cm．mrad。ENVLOP程序使用线性近似下的包络方程，描述电子束包络在螺旋管引导磁场作用下的变化，讨论了外加引导磁场对包络的影响。计算结果表明，在合适引导磁场作用下，束包络起伏较小，进入阳极通道的束流(4．3kA)能全部通过。     

MR diffusion - "diffraction" phenomenon in multi-pulse-field-gradient experiments

Using pulsed-field-gradient (PFG) experiments, the sizes of the pores in ordered porous media can be estimated from the "diffraction" pattern that the signal attenuation curves exhibit. A different diffraction pattern is observed when the experiment is extended to a larger number (N) of diffusion gradient pulse pairs. Simulations to calculate signal values from arbitrary gradient waveforms are performed for diffusion in restricted geometries using a matrix operator formalism. The simulations suggest that the differences in the characteristics of the attenuation curves are expected to make it possible to measure smaller pore sizes, to improve the accuracy of pore size measurements and potentially to distinguish different pore shapes using the N-PFG technique. Moreover, when an even number of PFG pairs is used, it is possible to observe the diffraction pattern at shorter diffusion times and measure an approximation to the average pore size even when the sample contains pores with a broad distribution of sizes.     

All-optical pseudorandom binary sequence generator with TOAD-based D flip-flops

An all-optical pseudo random binary sequence (PRBS) generator is designed using serially interconnected discrete Terahertz Optical Asymmetric Demultiplexer (TOAD)-based D flip-flops in a configuration exactly like the standard electronic setup. The performance of the circuit is evaluated through numerical simulation, which confirms its feasibility in terms of the choice of the critical parameters. The proposed scheme has been theoretically demonstrated for a 3-bit and 7-bit degree PRBS but can be extended to higher order by means of additional TOAD-based D flip-flops. Thus it can constitute an efficient solution for implementing all-optically a PRBS in an affordable, controllable and realistic manner.     

Activities of Selenia Spazio

Summary Selenia Spazio was involved since its beginning, more than twenty years ago, in scientific space missions, like almost all space industries in the world. In fact the European space organizations were mainly devoted to the development of autonomous launchers and to scientific research in the nearby and in the far away space. First programs in which Selenia Spazio had a role, designing and manufacturing space electronic equipment, were scientific satellites and ELDO launchers, followed by COSB and other cosmic research missions. In all these years cosmic physics and related research programs continued to receive technological support and see full involvement by space industry. To speed up publication, the proofs were not sent to the authors and were supervised by the Scientific Committee.     

Stabilized fiber-optic extrinsic Fabry–Perot sensor system for acoustic emission measurement

A fiber-optic Fabry–Perot (F–P) acoustic emission (AE) sensor system based on an improved double wavelength stabilization technique is described. Without stabilization, the sensor system drifts out of quadrature due to the presence of low-frequency dynamic strains. The stabilization is achieved by using a dense wavelength division multiplexer (DWDM) to generate two quadrature phase-shifted output signals. An optimum model of double wavelength stabilization is established. The filtering wavelengths of DWDM are calculated using an optimization design method. The performance of the developed sensor system was verified by two preliminary tests. One was a test on the stabilization of operating point of fiber-optic F–P sensor, and other was the detection of simulated AE signals generated by the impact and pencil lead breaking. The test results demonstrate that simulated AE signals are successfully detected using this stabilized sensor system, which solves the fade-out problem.