Preparation and Characterization of Al8.31Si1.91Mg3.78O20/Al4.8Si1.2O9.6/Mg2.0Al4.02Si4.98O18 Multiphase Material

A two-step sintering method was used to prepare Al8.31Si1.91Mg3.78O20 (corundum solid solution)/Al4.8Si1.2O9.6 (mullite solid solution)/Mg2.0Al4.02Si4.98O18 (cordierite solid solution) multiphase material, for the purposes of making these three crystal structures have point defects which could help the particles diffuse and transfer at high temperature, accelerate the sintering efficiently and enhance the material strength as well as the bulk density. The impacts of different formulas on the structure and properties of the multiphase material were investigated. With XRD and SEM analyses, for each sample, the crystal structure and microstructure were characterized, the crystalline phase content and cell parameters were determined with Rietveld Quantification software, and the properties were tested. The comparative optimal formula determined was calcinated chamotte of 80wt% and calcinated sludge of 20wt%; and its corresponding bending strength and retention rate of bending strength after a thermal shock were 29.74 MPa and 80.15%, respectively.     

溶胶-凝胶新方法合成介孔铁酸铜纳米粉体催化剂上CO低温氧化(英文)

Mesoporous CuFe2O4 solid solution nanopowders with high specific surface areas were synthesized by a novel, very simple and inexpensive sol-gel route using propylene oxide as gelation agent, and used as the catalyst in low temperature CO oxidation. The samples were characterized by X-ray diffraction, N2 adsorption-desorption, thermogravimetric/differential thermal analysis, Fourier transform infrared spectroscopy, scanning electron microscopy, transmission electron microscopy, and temperature-programmed reduction. The results revealed that the samples have a nanocrystalline structure with crystals in the range of 10 to 25 nm, and that all the catalysts have mesoporous pores. The addition of Cu into iron oxide affected its structural and catalytic properties. The sample containing 15 mol% Cu showed the highest specific surface area and catalytic activity, and showed high catalytic stability in low temperature CO oxidation.     

柱前衍生化-高效液相色谱法分析木糖结晶母液的单糖组成

采用1-苯基-甲基-吡唑啉酮(PMP)柱前衍生化-反相高效液相色谱(HPLC)法建立了8种常见单糖的分离模式,并用于木糖结晶母液单糖组成的定量分析.结果表明:木糖结晶母液至少由甘露糖、鼠李糖、纤维二糖、葡萄糖、半乳糖、木糖、阿拉伯糖及岩藻糖8种单糖组成,其中以葡萄糖、半乳糖、木糖和阿拉伯糖为主.以峰高定量,8种单糖的浓...     

稀土元素对Ti0.26Zr0.07V0.24Mn0.1Ni0.33贮氢合金微观结构和电化学性能的影响

本文研究了稀土元素对Ti0.26Zr0.07V0.24Mn0.1Ni0.33合金的微观结构和电化学性能的影响。结果表明,Ti0.26Zr0.07V0.24-xMn0.10Ni0.33REx(RE=Ce,Nd,Gd;x=0.01)合金均有V基固溶体相和C14型Laves相两相组成。合金中两相的晶格参数随加入稀土元素的不同而发生变化。稀土元素部分取代可改善合金电极的活化性能。然而,对合金电极的其他性能影响因元素种类不同而各异。Ce取代增大了合金电极的最大放电容量,Nd元素可以有效改善合金的高倍率放电性能。工作温度对合金电极的放电容量影响较大,Nd和Gd在333 K最大放电容量可达426和465 mAh.g-1。过高的温度使其循环容量衰减加剧。     

Absolute quantification of superoxide dismutase in cytosol and mitochondria of mice hepatic cells exposed to mercury by a novel metallomic approach

In the last years, the development of new methods for analyzing accurate and precise individual metalloproteins is of increasing importance, since numerous metalloproteins are excellent biomarkers of oxidative stress and diseases. In that way, methods based on the use of post column isotopic dilution analysis (IDA) or enriched protein standards are required to obtain a sufficient degree of accuracy, precision and high limits of detection. This paper reports the identification and absolute quantification of Cu,Zn-superoxide dismutase (Cu,Zn-SOD) in cytosol and mitochondria from mice hepatic cells using a innovative column switching analytical approach. The method consisted of orthogonal chromatographic systems coupled to inductively coupling plasma-mass spectrometry equipped with a octopole reaction systems (ICP-ORS-MS) and UV detectors: size exclusion fractionation (SEC) of the cytosolic and mitochondrial extracts followed by online anion exchange chromatographic (AEC) separation of Cu/Zn containing species. After purification, Cu,Zn-SOD was identified after tryptic digestion by molecular mass spectrometry (MS). The MS/MS spectrum of a doubly charged peptide was used to obtain the sequence of the protein using the MASCOT searching engine. This optimized methodology reduces the time of analysis and avoids the use of sample preconcentration and clean-up procedures, such as cut-off centrifuged filters, solid phase extraction (SPE), precipitation procedures, off-line fractions insolates, etc. In this sense, the method is robust, reliable and fast with typical chromatographic run time less than 20 min. Precision in terms of relative standard deviation (n = 5) is of 3–5% and detection limits is 0.21 ng Cu g⁻¹.     

Twisted penta‐Carbazole/Benzophenone Hybrid Compound as Multifunctional Organic Host,Dopant or Non‐doped Emitter for Highly Efficient Solution‐Processed Delayed Fluorescence OLEDs

A new multi‐functional penta‐carbazole/benzophenone hybrid compound 5CzBP was designed and synthesized through a simple one‐step catalyst‐free C—N coupling reaction by using 2,3,4,5,6‐pentafluorobenzophenone and carbazole as starting materials. 5CzBP is very soluble in tetrahydrofuran (THF), which brings an environmentally friendly device fabrication for solution‐processed OLEDs instead of most widely used chlorinated solvents when 5CzBP is employed as the bulk‐phase of organic host or non‐doped emitter in the emissive layer. 5CzBP exhibits thermally activated delayed fluorescence (TADF) characteristic with relatively high triplet energy of 2.60 eV and a low ΔE_ST of 0.01 eV. By using the new TADF material as organic host for another green TADF emitter, maximum external quantum efficiency (EQE) of 12.5% has been achieved in simple solution‐processed OLED device. Besides, a maximum EQE of 8.9% and 5.7% was further obtained in TADF devices based on 5CzBP as dopant and non‐doped emitter, respectively. The simultaneously acting as efficient TADF host and non‐doped TADF emitter provides the potential guidance of the future simple single‐layer two‐color white OLEDs based on low‐cost pure organic TADF materials.     

Ionization of aqueous toluic acids: Conductance and thermodynamics

Conductivities of aqueous solutions ofortho-, meta-, andpara-toluic acids have been measured for the concentration range 0.1–2 millimolar and at 5° intervals from 5 to 100°C. At each temperature pK _a(m) andA ₀ have been calculated using the paired ion model recently described by Fuoss. Thermodynamic parameters have been calculated for the ionization of each acid, and Walden products for the anions. Results are discussed in terms of contributions to acidity by enthalpy and entropy changes as well as by hydration of the various solute species.     

Upper Critical Solution Temperature-Type Responsive Cyclodextrins with Characteristic Inclusion Abilities

Water-soluble and thermoresponsive macrocycles with stable inclusion toward guests are highly valuable to construct stimuli-responsive supramolecular materials for versatile applications. Here, we develop such macrocycles – ureido-substituted cyclodextrins (CDs) which exhibit unprecedented upper critical solution temperature (UCST) behavior in aqueous media. These novel CD derivatives showed good solubility in water at elevated temperature, but collapsed from water to form large coacervates upon cooling to low temperature. Their cloud points are greatly dependent on concentration and can be mediated through oxidation and chelation with silver ions. Significantly, the amphiphilicity of these CD derivatives is supportive to host-guest binding, which affords them inclusion abilities to guest dyes. The inclusion complexation remained nearly intact during thermally induced phase transitions, which is in contrast to the switchable inclusion behavior of lower critical solution temperature (LCST)-type CDs. Moreover, ureido-substituted CDs were exploited to co-encapsulate a pair of guest dyes whose fluorescence resonance energy transfer process can be switched by the UCST phase transition. We therefore believe these novel thermoresponsive CDs may form a new strategy for developing smart macrocycles and allow for exploring smart supramolecular materials.     

Electrokinetic actuation of an uncharged polarizable dielectric droplet in charged hydrogel medium

Electrokinetic transport of an uncharged nonconducting microsized liquid droplet in a charged hydrogel medium is studied. Dielectric polarization of the liquid drop under the action of an externally imposed electric field induces a non-homogeneous charge density at the droplet surface. The interactions of the induced surface charge of the droplet with the immobile charges of the hydrogel medium generates an electric force to the droplet, which actuates the drop through the charged hydrogel medium. A numerical study based on the first principle of electrokinetics is adopted. Dependence of the droplet velocity on its dielectric permittivity, bulk ionic concentration, and immobile charge density of the gel is analyzed. The surface conduction is significant in presence of charged gel, which creates a concentration polarization. The impact of the counterion saturation in the Debye layer due to the dielectric decrement of the medium is addressed. The modified Nernst–Planck equation for ion transport and the Poisson equation for the electric field is considered to take into account the dielectric polarization. A quadrupolar vortex around the uncharged droplet is observed when the gel medium is considered to be uncharged, which is similar to the induced charge electroosmosis around an uncharged dielectric colloid in free-solution. We find that the induced charge electrokinetic mechanism creates a strong recirculation of liquid within the droplet and the translational velocity of the droplet strongly depends on its size for the dielectric droplet embedded in a charged gel medium.     

Effect of Penetration Enhancers on Toenail Delivery of Efinaconazole from Hydroalcoholic Preparations

The incorporation of permeation enhancers in topical preparations has been recognized as a simple and valuable approach to improve the penetration of antifungal agents into toenails. In this study, to improve the toenail delivery of efinaconazole (EFN), a triazole derivative for onychomycosis treatment, topical solutions containing different penetration enhancers were designed, and the permeation profiles were evaluated using bovine hoof models. In an in vitro permeation study in a Franz diffusion cell, hydroalcoholic solutions (HSs) containing lipophilic enhancers, particularly prepared with propylene glycol dicaprylocaprate (Labrafac PG), had 41% higher penetration than the HS base. Moreover, the combination of hydroxypropyl-β-cyclodextrin with Labrafac PG further facilitated the penetration of EFN across the hoof membrane. In addition, this novel topical solution prepared with both lipophilic and hydrophilic enhancers was physicochemically stable, with no drug degradation under ambient conditions (25 °C, for 10 months). Therefore, this HS system can be a promising tool for enhancing the toenail permeability and therapeutic efficacy of EFN.