基于改进的稀疏度自适应匹配追踪算法的宽带压缩频谱感知

针对在实际宽带压缩频谱感知中难以预先获知宽带频谱稀疏度的问题,提出一种改进的稀疏度自适应匹配追踪(modified sparsity adaptive matching pursuit, MSAMP)算法,该算法在支撑集选择过程中对稀疏度进行了预估计。结合序贯压缩检测技术,给出了一种基于该算法的多认知用户合作场景下的宽带压缩频谱感知方法,理论分析和实验仿真结果表明,该方法可在频谱稀疏度先验知识缺少的情况下,有效提高宽带频谱感知性能。     

激光调频连续波测距的精度评定方法研究

基于双光纤光路等光频重采样原理,提出了一种距离精度的评定方法.通过推导噪声背景下等光频重采样信号中距离参量的克拉美-罗下边界,得到了影响系统测距精度的两个重要因素:信噪比和扫描带宽,并进行了实验验证.实验表明,该评价方法并不会受到任何距离估算方法的影响,根据此方法可以选择一个最优的距离估算方法.通过对两个影响精度的因素进行仿真分析可知,在扫描带宽为2.2 nm时,若将测量光路的信噪比提升至70 dB以上,系统可获得低于10μm的测距精度.该精度评定方法可为后续改善调频连续波测距系统性能提供理论参考.     

频谱分析方法在弗兰克-赫兹实验中的应用

弗兰克-赫兹实验中定态能级间隔具有很强的周期性.本文借鉴频谱分析的方法,对弗兰克-赫兹实验数据进行处理,结果显示该方法准确确定出了定态能级间隔,结果有着很强的直观性及良好的处理效果.     

激光光强扰动对相干场成像降质影响理论研究

激光相干场成像系统发射多束激光,经大气传输对远程目标成像,大气湍流引起的激光束光强扰动是影响成像质量的一个关键因素.本文从湍流引起的激光束光强扰动对回波解调信号的影响关系入手,建立了激光回波光强扰动因子对相位闭合系数和成像频谱分量的降质传函理论模型;基于三光束激光相干场成像系统仿真验证了理论模型的有效性.研究表明激光相干场成像频谱分量和成像像质主要受三光束相位闭合求解算法中第二光束光强扰动影响.该研究揭示了激光回波光强扰动对成像像质的影响机理,对于分析大气湍流等引起的光强扰动降质效应和合理分配多光束光强稳定性以提高成像质量具有理论指导意义.     

炮体表面瞬态温度分布的散斑干涉测试研究

为了可以实现对炮体表面瞬态温度分布变化的实时监测,同时克服传统瞬态高温测试仪器单点探测以及热惯性大等局限性,设计了基于散斑干涉与光谱频域分析相结合的瞬态温度分布测试系统。系统采用散斑干涉技术将炮体瞬态温度变化引发的微小形变转换成散斑干涉条纹,再由傅氏变换完成干涉条纹形变到光谱分布的函数转换,从而通过光谱分布函数反演任意采样时刻上的温度分布。实验采用ZX-FB1型光纤测温仪测试单点位置上瞬态温度作为标准值,再由555 nm激光器与面阵CCD采集散斑干涉条纹,分别使用图像识别法与傅氏变换法完成干涉条纹与瞬态温度的算法匹配,从而反演瞬态温度。实验结果显示,两种方法均能实现瞬态温度检测,但基于傅氏变换频谱分析的散斑干涉法精度更高,并且可以有效地克服由表面瑕疵、漆面磨损等问题造成的粗大误差。     

合成孔径激光雷达多通道TOPS模式及频谱恢复方法

针对多通道循序扫描地形观测模式中单个通道的回波数据在方位向存在模糊,采用传统空域波束形成技术及方位预滤波方法均无法恢复信号频谱的问题,在分析产生模糊原因的基础上,提出了一种基于谱压缩的空域波束形成方法.该方法首先对信号进行反旋处理,压缩信号的频谱宽度;然后对多通道数据进行空域波束形成,获得无模糊的频谱;最后对信号反旋处理引入的相位项进行补偿,得到原始信号的二维频谱.点目标及场景仿真实验数据处理结果均验证了该算法的有效性.     

High-Q microwave photonic filter with self-phase modulation spectrum broadening and third-order dispersion compensation

We propose and experimentally demonstrate a scheme of high-Q microwave photonic filter （MPF） using the techniques of self-phase modulation （SPM） spectrum broadening and third-order dispersion （TOD） compensation. The optical pulses from a mode-locking laser are spectrally broadened by the SPM in the highly nonlinear fiber. A wideband optical frequency comb with 365 spectral lines within 10-dB power variation from the highest spectral power is obtained. By applying a cubic phase modulation via a waveshaper, the effect of TOD which broadens the MPF passband is eliminated. The final implemented MPF has a Q-value as high as 296 and a tuning range of 700 MHz.     

Design optimization of highly efficient spectrum-splitting and beam-concentrating diffractive optical element for lateral multijunction solar cells

Two improved algorithms are proposed to extend a diffractive optical element （DOE） to work under the broad spec- trum of sunlight. An optimum design has been found for the DOE, with a weighted average optical efficiency of about 6.8% better than that of the previous design. The optimization of designing high optical efficiency DOEs will pave the way for future designs of high-efficiency, low-cost lateral multijunction solar cells based on such a DOE.     

Spectral analysis of the UFBG-based acousto optical modulator in V–I transmission matrix formalism

In this study, the V-I transmission matrix formalism （V-I method） is proposed to analyze the spectrum characteristics of the uniform fiber Bragg grating （FBG）-based acousto--opfic modulators （UFBG-AOM）. The simulation results demon- strate that both the amplitude of the acoustically induced strain and the frequency of the acoustic wave （AW） have an effect on the spectrum. Additionally, the wavelength spacing between the primary reflectivity peak and the secondary reflectivity peak is proportional to the acoustic frequency with the ratio 0.1425 nm/MHz. Meanwhile, we compare the amount of calculation. For the FBG whose period is M, the calculation of the V-I method is 4 × （2M-l） in addition/subtraction, 8 × （2M - 1） in multiply/division and 2M in exponent arithmetic, which is almost a quarter of the multi-film method and transfer matrix （TM） method. The detailed analysis indicates that, compared with the conventional multi-film method and transfer matrix （TM） method, the V-I method is faster and less complex.     

New terahertz dispersive device for single-shot spectral measurements of terahertz pulse

A new terahertz dispersive device designed for single-shot spectral measurements of broadband terahertz pulses is proposed. With two-dimensional quasi-randomly distributed element design, the device exhibits approximately the dispersive property of single-order diffraction in far field. Its far-field diffraction pattern is experimentally verified employing a continuous terahertz source centered at 2.52 THz and a pyroelectric focal-plane-array camera, which is in good agreement with the numerical result. The device provides a new approach for direct single-shot spectral measurements of broadband terahertz waves.