聚丙烯微孔膜的等离子体接枝聚合改性

利用拉伸时的晶型转变致孔特性,从β晶相聚丙烯经单向或双向拉伸制得了新型聚丙烯微孔膜、用等离子体接枝聚合技术接上了亲水性聚合物如聚丙烯酸、聚丙烯腈等。研究了等离子体处理时间、单体性质对得到的亲水膜的亲水性、离子/溶质渗透性的影响。发现接枝聚丙烯酸的双向拉伸膜对Na~+、Mg~(++),尿素有较大的渗透性,并具有优良的形状稳定性。     

吹气孔直径对RH精炼过程钢液流动和混合特性的影响

针对90t RH精炼装置,以水力学模拟研究了吹气孔直径对真空循环精炼过程中钢液流动和混合特性的影响.模型和原型的相似比为15.模型吹气孔直径分别为0.8 mm和1.2 mm.结果表明,1.2 mm孔径下环流量和主要工艺参数间的关系为Ql Q80.26Du0.69Dd0.80;在给定的吹气量和插入管内径下,增大吹气孔直径并不显著改变精炼过程中钢液流动特征,环流量随吹气孔直径的增大而略有增大,其关系式为Ql=2.40Q 0.23gD0.72u D0.88d d0.13in;相应地,混合时间稍有缩短;0.8和1.2 mm孔径下,τm与搅拌能密度的关系分别为τm ε5和τm ε0.49.     

双液系气－液平衡相图绘制中有关问题的探讨

本文以物理化学实验“苯－乙醇气液平衡相图绘制”为研究对象，对其混合液的浓度调整以期达到再利用进行了探讨，提出了调整方法，进行了实验验证，取得了理想的效果。     

In situ Synthesis of Oligonucleotides on Plasma Treated Polypropylene Microporous Membrane

Polypropylene microporous membranes were treated with plasma in a mixture of N2 and H2 (1:2 in volume). Attenuated total reflectance Fourier transform infrared spectroscopy (ATR-FTIR), X-ray photoelectron spectroscopy (XPS) and ultra-violet (UV) spectra demonstrated the success of grafting amino groups. The density of the polar amino groups on the membrane surface is about 0.59 μmol/cm^2. The as-treated membranes were successively applied to the in situ synthesis of oligonucleotides and an average coupling yield was more than 98%. The surface feature of the treated membrane is suggested to be responsible for its advantage over a glass slide.     

椭偏法测膜厚的直接计算方法

改进了椭偏法测薄膜折射率和膜厚的迭代计算方法，由测量得到的起偏角A和检偏角P直接算出薄膜折射率和膜厚．     

脂溶性酞菁钴(III)为载体的高选择性亚硝酸根PVC膜电极

以自制的4,4',4',4''-四特丁基酞菁钴(II)为原料合成二氯4,4',4',4''-四特丁基酞菁钴(III)。以此为载体制备PVC膜电极。该电极的电位选择性次序明显不同于Hofmeister次序, 其最佳 响应斜率为-52mV/pNO2^-, 线性范围为3×10^-^5～1×10^-^1mol.dm^-^3NaNO2。通过改变配合物轴向的配位阴离子, 用紫外-可见光谱法对电极的响应机理作了初步探讨。     

动态广义球对称含荷黑洞的统计熵

利用改进了的brickwall膜模型,计算了动态广义球对称含荷黑洞的熵,研究结果表明,对于动态黑洞,将黑洞熵表示为与视界面积成正比时,则比例系数总与动态黑洞的视界速度有关 关键词： 广义球对称黑洞 黑洞熵 brick-wall膜模型 WKB近似     

MOCVD生长的GaN单晶膜透射光谱研究

采用MOCVD技术在Al2O3(0001)衬底上生长了GaN薄膜，使用透射光谱、光致发光光谱和X射线双晶衍射三种技术测试了五类GaN薄膜样品，实验结果表明：GaN薄膜透射谱反映出的GaN质量与X射线双晶衍射测量的结果一致，即透射率越大，半高宽越小，结晶质量越好；而X射线双晶衍射峰半高宽最小的样品，其PL谱的带边峰却很弱，这说明PL谱反映样品的光学性能与X射线双晶衍射获得的结晶质量不存在简单的对应关系，同时还报导了一种特殊工艺生长的高阻GaN样品的RBS／沟道结果。     

Self-Assembly of Micro-Parts onto Si Substrates at Liquid-Liquid Interface

We report a new approach for the self-assembly of cuboid micro-parts onto Si substrates to construct three-dimensional microstructures. To perform assembly, the Si substrates are prepared with a deep cavity array as binding sites. An aggregate composed of hundreds of uniformly aligned micro-parts is formed at the C10F18-H2O interface. The micro-parts are arranged by passing the substrate through the aggregate of micro-parts, thus the micro-parts are left on the substrate, and then the substrate is vibrated ultrasonically in the solution, making it possible for the micro-parts to fall into the cavities on the substrate. Finally the substrate is pulled out of the solution after assembly. This technique could give a high yield of up to 70%, providing a new method for micro-assembly.     

TlBaCaCuO外延膜的光响应

在波长γ＝６３２．８ｎｍ，入射功率约０．８ｍ的Ｈｅ－Ｎｅ激光照射下，对ＴｌＢａ２Ｃａ２ＣｕＯ２（Ｔｌ－２２１２）外延膜的光响应行为进行了实验研究。结果显示：在样品转变温度（Ｔｃ＝１０５．５Ｋ）附近，ＴｌＢａ－ＣａＣｕＯ外延膜的光响应行为表现为辐射热与非辐射热效应共存现象。光响应信号电平与样品温度、偏置电流、及入射光束的调制频率等诸因素有密切关系的关系。实验结果还表明，辐射热与非辐射热效应的响应行为