双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

关于态射的Drazin逆

给出了态射的Drazin逆存在的条件及显式表达式，改进并推广了[1]、[2]与[3]中的一些主要定理。     

高功率固体激光放大系统相位自校正方法研究

就光学元件间低频相位误差叠加提出用相关系数作为叠加相位结果的估计参量，并通过模拟计算和验证实验证明了相关系数能有效地对低频相位叠加结果进行比较估计，在此基础上就高功率固体激光放大系统中放大片的选取和安装提出了自校正方法并实现了自校正过程。     

Small Stress Change Triggering a Big Earthquake： a Test of the Critical Point Hypothesis for Earthquakes

Whether or not a small stress change can trigger a big earthquake is one of the most important problems related to the critical point hypothesis for earthquakes. We investigate global earthquakes with different focM mechanisms which have different levels of ambient shear stress. This ambient stress level is the stress level required by the earthquakes for their occurrence. Earthquake pairs are studied to see whether the occurrence of the preceding event encourages the occurrence of the succeeding one in terms of the Coulomb stress triggering. It is observed that the stress triggering effect produced by the change of Coulomb failure stress in the same order of magnitudes,about 10-2 MPa, is distinctly different for different focal mechanisms, and thus for different ambient stress levels.For non-strike-slip earthquakes with a relatively low ambient stress level, the triggering effect is more evident,while for strike-slip earthquakes with a relatively high ambient stress level, there is no evident triggering effect.This water level test provides an observational support to the critical point hypothesis for earthquakes.     

Self-assembly behaviour of amphiphilic diblock copolymer in selective solvents studied by synchrotron small-angle x-ray scattering

The aggregation behaviour of styrene-vinyl benzoic acid (PSm-b-PVBAn) amphiphilic diblock copolymers in selective solvents with different m and n was investigated by synchrotron small-angle x-ray scattering (SAXS). We have carried out a detailed analysis of scattering intensity, dimension, shape and microstructure of the diblock copolymers of narrow distribution in water, methanol, ethanol and isopropanol selective solvents, respectively. We have found that the aggregation behaviour of the copolymer depends on the nature of the solvent and the micelle forms fiat disc objects with the ratio of radius ω=0.4. The average radius gyration Rg of the copolymer decreases as solvents change from isopropanol to ethanol and to methanol, and increases with increasing pH in aqueous solution, but decreases with the addition of COCl2 in ethanol solvent. The scattering intensity of diblock copolymer micelle follows I(h) ∝ h^-α in different selective solutions, suggesting that the PSm-b-PVBAn coils have self-similar structure behaviour or a fractal structure in the selective solvents. All of these revealed that the aggregation behaviour of the diblock copolymer changes dramatically with experimental condition in the selective solvent. The increase of mass fractal dimension (Dm) from 2.12 to 2.47 indicates that the copolymer chain changes from a swollen coil to a rather compact disc in the course of changing solvents, decreasing surface fractal dimension (Ds) from 2.98 to 2.58 indicates that the copolymer micelle change from a rather rough surface to a smooth form in the course of increasing pH in aqueous solutions, and increasing Dm and Ds from 2.29 to 2.35 and 2.70 to 2.90, respectively, indicates the shrinkage of copolymer micelle to a rather compact and rough disc form by adding COCl2 in ethanol solvents.     

B值随机变量阵列加权和的完全收敛性

设{X_ni:1≤i≤n,n≥1}为行间独立的B值r.v.阵列,g(z)是指数为1/p的正则变化函数,r>0,{ani 1≤t≤n,n≥1}为实数阵列,本文得到了使(?)成立的条件,推广并改进了Stout及Sung等的著名结论.     

遥感器CCD驱动器热设计及其在摄像过程中的温度变化

CCD驱动器是航天成像遥感器摄像过程中的主要热源之一。防止CCD驱动器过热是保证其正常工作的重要方面。介绍了遥感器的工作模式和对CCD驱动器采取的热控制措施。通过热平衡试验,利用回归的方法,对CCD驱动器在摄像过程中的温度变化规律进行了分析,同时对热控制效果进行了评估。CCD驱动器工作时升温速率在0.85℃/min左右,整个摄像过程中最高温度约为26℃,所实施的热控制措施效果理想。     

摄像型等厚干涉实验仪器的研究

介绍了“摄像型等厚干涉实验仪”的构造及等厚干涉实验新的测量方法。     

QIC-160等静压机自动控制系统的设计与实现

QIC-160等静压机是20世纪80年代初引进的国外成套大型设备，主要用于粉末成型产品的压制。设备最高工作压力达200MPa，温度可达120℃。设备从引进到现在已经20多年了，电器元件也已老化，鉴于该设备现在液压系统及主体运行还基本正常，故对原设备控制系统进行了设计更新。     

侵彻环境下两种钨合金的细观响应特性

本文实验发现具有较大密度和较高速度的93W钨合金长杆模拟弹的穿靶深度反而比密度较小，速度较低的90W钨合金长杆弹的穿靶深度小．针对这一现象，本文从两种材料在侵彻环境下的细观响应特性的差异上给出了有实验根据的合理分析，结论是90W在侵彻环境下较易于形成绝热剪切带，从而在弹头部发生“自锐化”效应所致．