Molecular Simulation on Transport Properties of Confined Water

The diffusivity and viscosity of water confined in micropores were studied by molecular dynamics simulations. The effects of pore width and density were analyzed at pore widths from 0.9 to 2.6nm. The diffusivity in micropores is lower than that of the bulk, and it decreases as pore width decreases and as density increases. But the viscosity in micropores is much larger than that of the bulk, and it increases as pore width decreases and as density increases. The diffusivity in channel parallel direction is obviously larger than that in channel perpendicular directions.     

高效液相色谱法测定水中4,4′-二氨基联苯

4,4′-二氨基联苯俗称联苯胺,是合成染料的中间体,可用于制造多种染料和颜料。作为联苯的衍生物之一,4,4′-二氨基联苯有强烈的致癌作用,可通过吸入、食入或透过皮肤吸收导致中毒,引起接触性皮炎,还会刺激黏膜,损害肝和肾脏,以及导致膀胱癌和胰腺癌。我国对水中4,4′-二氨基联苯的含量有严格的限制。GB 3838—2002《地表水环境质量标准》规定,地表水中4,4′-二氨基联苯的限     

富羧酸基团的共轭微孔聚合物:结构单元对孔隙和气体吸附性能的影响

Polar groups in the skeletons of conjugated microporous polymers (CMPs) play an important role in determining their porosity and gas sorption performance. Understanding the effect of the polar group on the properties of CMPs is essential for further advances in this field. To address this fundamental issue, we used benzene, the simplest aromatic system, as a monomer for the construction of two novel CMPs with multi-carboxylic acid groups in their skeletons (CMP-COOH@1 and CMP-COOH@2). We then explored the profound effect the amount of free carboxylic acid in each polymer had on their porosity, isosteric heat, gas adsorption, and gas selectivity. CMP-COOH@1 and CMP-COOH@2 showed Brunauer-Emmett-Teller (BET) surface areas of 835 and 765 m²·g^-1, respectively, displaying high potential for carbon dioxide storage applications. CMP-COOH@1 and CMP-COOH@2 exhibited CO₂ capture capabilities of 2.17 and 2.63 mmol·g^-1 (at 273 K and 1.05 × 10⁵ Pa), respectively, which were higher than those of their counterpart polymers, CMP-1 and CMP-2, which showed CO₂ capture capabilities of 1.66 and 2.28 mmol·g^-1, respectively. Our results revealed that increasing the number of carboxylic acid groups in polymers could improve their adsorption capacity and selectivity.     

激光聚焦与激光打微孔实验设计

利用激光束的高亮度、高方向性、高单色性等特点,让固体激光器所产生的激光依次通过光阑、准直镜组、聚焦透镜来获得光斑半径小、强度高的光束,并用其对金属靶材进行加工,得到了优于机械打孔的微孔.     

考虑重力因素的断溶体储层“井-洞-缝”模型试井解释方法

顺北油田属于大型断裂构造运动形成的断溶体储层，纵向裂缝系统和垂向分布的溶洞是主要的储集体空间.本文提出溶洞中的压力变化是由流动和波动共同产生的，依此把能量守恒方程与试井理论相结合，建立考虑重力因素的断溶体储层试井解释方法.定义无量纲量，并对无量纲方程进行Laplace变换，得到Laplace空间上的井底压力.由Stehfest数值反演算法得到试井分析所需的图版曲线.对重力因素进行敏感性分析表明：重力因素只影响双对数曲线的末期，当重力因素很明显时，曲线特征类似于定压边界.对新疆油田的某井进行分析，解释了曲线后期下掉原因，并给出溶洞体积以及波动相关参数等，分析结果与生产实际情况相吻合.     

基于滤纸微孔板的酶联免疫吸附测定方法研究

用光刻法在普通定量滤纸上制作出了疏水图案,得到了滤纸微孔板。将表面修饰后的SiO2微球负载在滤纸表面,以提高滤纸纤维吸附蛋白质的能力,基于此建立了以间接酶联免疫吸附法测定羊抗兔免疫球蛋白的方法。以酶标兔抗羊IgG为例,负载SiO2微球后,滤纸微孔板吸附该蛋白质的量提高了20%～700%;将SiO2负载法应用于羊抗兔IgG的检测时,可使信号增强20%～150%。在本实验条件下,测定羊抗兔IgG的线性范围为3×10-12～3×10-8mmol/孔。本方法使生物免疫试剂消耗量减少至3～5μL/孔、检测时间降至20 min/板、滤纸微孔板制作成本可低至约每板1.1美元,为研制准确、快速和低成本的疾病检测设备提供了新的思路和可能性。     

用于聚合物镍氢电池的新型PVA/SiO2碱性微孔聚合物电解质（英文）

采用溶胶凝胶法,结合相转移法和碱液活化法制备了PVA/SiO2碱性微孔聚合物电解质,通过SEM、XRD、交流阻抗法和循环伏安法表征了电解质的结构与电化学性能.研究表明,PVA/5ωSiO2(ω为质量分数)共混膜上的微孔大小合适,聚合物电解质的离子电导率最大可达1.62×10-2 S cm-1,电化学稳定窗口2 V以上;将PVA/SiO2碱性微孔电解质组装成聚合物镁基镍氢电池,与传统镍氢电池相比,循环稳定性大大增加.     

液态丙烯腈低聚物修复聚丙烯腈基碳纤维微孔缺陷

提出一种全新的缺陷修复的方法,即将聚丙烯腈基(PAN)碳纤维T300在液态丙烯腈低聚物(LAN)中浸渍后,再进行预氧化和碳化热处理,可以将T300的拉伸强度提高25%.应用二维小角X射线散射(SAXS)法可以计算出LAN修复缺陷前后T300微孔缺陷的长度(L)、横截面尺寸(lp)、取向角(Beq)、相对体积(Vrel)的变化,结果表明碳纤维的拉伸性能越好,微孔的长度、取向角、相对体积含量越小.T300拉伸性能的提高是由于缺陷修复的结果.应用BET比表面积法、扫描电子显微镜(SEM)表征LAN修复缺陷前后T300的比表面积以及表面形貌的变化,结果表明,T300在LAN中浸渍并经过预氧化和碳化热处理,比表面积变小,表面缺陷明显减少.进一步验证LAN对碳纤维中的微孔缺陷具有修复作用.应用X射线光电子能谱(XPS)法表征LAN修复前后T300表面化学成分的变化,结果表明,LAN修复后含氧官能团(C―OH,C=O,HO―C=O)显著增加,有利于增强碳纤维与树脂基体之间的相互作用,从而提高碳纤维的力学性能.     

Hydrothermal Synthesis and Structural Characterization of a Novel 3-D Open Framework Zinc Phosphate Microporous Compound(C_5N_2H_(14))·[Zn_3(OH_2)(PO_4)_2(HPO_4)]

One novel organically templated zincophophate(C5N2H14)·[Zn3(OH2)(PO4)2(HPO4)] has been synthesized under hydrothermal conditions and characterized by single-crystal X-ray diffraction together with elemental analysis, infrared spectroscopy, thermogravimetric analysis, and powder X-ray diffraction. The title compound crystallizes in the monoclinic space group P21/n, with a = 9.7904(11), b = 14.0287(14), c = 11.8651(13) , β = 104.690(3), V = 1576.4(3) 3, Z = 4, T = 296(2) K, Mr = 601.31 and Dc = 2.533 g/cm3. The compound consists of a macroanionic [Zn3(OH2)(PO4)2(HPO4)]2- framework and(C5N2H14)2+ cations, and its structure is built up from ZnO3(OH2), ZnO4, HPO4 and PO4 tetrahedral units that result in 4, 8 and 10-ring channels.     

香菇生物质基氮掺杂微孔碳材料的制备及其在超级电容器中的应用

采用简易浸泡法和一步碳化/活化法制备香菇生物质基氮掺杂微孔碳材料(NMCs),利用扫描电子显微镜(SEM)、透射电子显微镜(SEM)、X射线衍射(XRD)和X射线光电子能谱(XPS)对材料的结构形貌进行表征,并研究了其超级电容特性。测试结果表明,NMCs的微孔比表面积高达1 594 m~2·g~(-1),且拥有更高数量的含氮官能团,其吡啶型含氮官能团比例也有所提高,展现出优异的超级电容特性。在0.5 A·g~(-1)的电流密度下,其比容量高达325 F·g~(-1),当电流密度上升到20 A·g~(-1)时,其比电容仍然高达180 F·g~(-1),表现出优异的倍率性能;同时,在5 A·g~(-1)的电流密度下,电极经历5 000次充放电循环后具有97.7%的比容量保持率,展现出优异的循环稳定性。这主要归因于NMCs超高的微孔比表面积和丰富的含氮官能团。