反应修饰剂ZnSO4和预处理对苯选择加氢制环己烯Ru-Zn催化剂性能的影响

共沉淀法制备了Ru-Zn催化剂,考察了反应修饰剂ZnSO₄和预处理对苯选择加氢制环己烯Ru-Zn催化剂性能的影响。结果表明,反应修饰剂ZnSO₄可以与Ru-Zn催化剂中助剂ZnO反应生成（Zn（OH）₂）₃（ZnSO₄）（H₂O）盐。随反应修饰剂ZnSO₄浓度增加,（Zn（OH）₂）₃（ZnSO₄）（H₂O）盐量的逐渐增加,Ru-Zn催化剂活性逐渐降低,环己烯选择性逐渐升高。因为（Zn（OH）₂）₃（ZnSO₄）（H₂O）盐中的Zn²⁺可以使Ru变为有利环己烯生成的缺电子的Ru^δ+物种,而且还可以占据不适宜环己烯生成的强Ru活性位。但当反应修饰剂ZnSO₄浓度高于0.41 mol·L^-1后,继续增加ZnSO₄浓度,由于Zn²⁺水解浆液酸性太强,可以溶解部分（Zn（OH）₂）₃（ZnSO₄）（H₂O）盐,Ru-Zn催化剂活性升高,环己烯选择性降低。但环己烯选择性却略微降低,这是由于ZnSO₄溶液中大量的Zn²⁺可以与生成的环己烯形成配合物,稳定生成的环己烯,抑制生成的环己烯再吸附到催化剂表面并加氢生成环己烷。在ZnSO₄最佳浓度0.61 mol·L^-1下对Ru-Zn催化剂预处理15 h,Ru-Zn催化剂中助剂ZnO可以与ZnSO₄完全反应生成（Zn（OH）₂）₃（ZnSO₄）（H₂O）盐,在该催化剂上25 min苯转化68.2%时环己烯选择性和收率分别为80.2%和54.7%。而且该催化剂具有良好的稳定性和重复使用性能。     

(Pr0.9La0.1)2(Ni0.74Cu0.21Ga0.05)O4+δ-Ce0.9Gd0.1O2-δ复合阴极的制备及电化学性质

采用EDTA-柠檬酸盐法制备了（Pr_0.9La_0.1）₂（Ni_0.74Cu_0.21Ga_0.05）O_4+δ（PLNCG）,并与Ce_0.9Gd_0.1O_2-δ（CGO）形成复合阴极PLNCG-CGO。XRD和SEM分析结果表明PLNCG与CGO在1 000℃具有较好的化学相容性。电化学阻抗测试结果表明PLNCG-30% CGO复合阴极在700℃的极化电阻为0.092 Ω·cm²;过电位为39.3 mV时,电流密度达到113.3 mA·cm^-2。氧分压分析表明电极反应的速率控制步骤为电荷转移过程。阳极支撑单电池（Ni-CGO/CGO/PLNCG-30% CGO）在700℃的最大输出功率密度达到569 mW·cm^-2,开路电压（OCV）为0.76 V。综上结果预示PLNCG-30% CGO复合阴极是一种有发展前景的电极材料。     

氯化铜的少溶剂固态连串配位化学反应

在少量水的存在下,由于 NH₄[CuCl₃]对水不稳定,CuCl₂·2H₂O 与氯化铵的配位化学反应只能得到 1:2 产物(NH₄)₂[CuCl₄(H₂O)₂];但在无水乙醇中,无水 CuCl₂与氯化铵按 1:1或 1:2的物质的量之比混合时,能相应地得到 NH₄[CuCl₃]或(NH₄)₂[CuCl₄]。CuCl₂·2H₂O与 2,2''-联吡啶(bipy)的少溶剂固态化学反应仍能像固态化学反应一样,根据反应物的配比生成相应的唯一产物,但在物质的量之比为1:1的反应中发现1:2产物曾经形成。热力学分析说明,如果连串反应的后一步的Δ_rG^⊖大于前一步的,则上述反应现象是可能的。     

Preparation of novel chelating sponge as an adsorbent for the removal of Cu~（2＋） from water

The novel chelating sponge modifed with hydroxamic acid groups was prepared by a grafting polymerization followed by a nucleophilic substitution reaction.Elementary analysis,SEM,FT-IR spectroscopy and XPS were used to characterize the spongy adsorbent（PVA-MA-HH）.Adsorption isotherm study indicated that PVA-MA-HH had high equilibrium adsorption capacity for Cu2＋.     

An efficient,rapid and facile procedure for conversion of aldoximes to nitriles using triphenylphosphine and N-halo sulfonamides

N,N,N＇,N＇-Tetrabromobenzene-1,3-disulfonamide （TBBDA）/triphenylphosphine and N,N,N＇,N＇-tetra- chlorobenzene-1,3-disulfonamide （TCBDA）/triphenylphosphine have been introduced as highly efficient systems for the versatile conversion of aldoxime derivatives into nitriles. The process reported here is operationally simple and reactions have been mildly performed in dichloromethane at room temperature.     

H_6P_2W_（18）O_（62）á18H_2O： A green and reusable catalyst for one-pot synthesis of pyrano[4,3-b]pyrans in water

A convenient,effcient and environmentally benign procedure has been developed for the synthesis of pyrano[4,3-b]pyran derivatives via a one-pot,three-component reaction of 4-hydroxy-6-methylpyran-2-one,aldehydes and malononitrile in water using H6P2W18O62á18H2O as catalyst.Reusability of the catalyst and reaction media,short reaction times and easy isolation of products are some added advantages of the present methodology.     

Kinetic study of electrochemically induced Michael reaction of1,4-dihydroxyanthraquinone with acetylacetone and benzoylacetone

The electrochemical oxidation of 1,4-dihydroxyanthraquinone has been studied in the presence of acetylacetone and benzoylacetone as nucleophiles in a mixture of ethanol/water by means of cyclic voltammetry as a diagnostic technique.The results indicate the participation of electrochemically produced anthraquinone in the Michael addition reaction with acetylacetone and benzoylacetone to form the corresponding new anthraquinone derivatives.On the basis of the EC mechanism,the observed homogeneous rate constants（kobs）of the reaction of anthraquinone with acetylacetone and benzoylacetone were estimated by comparing the experimental cyclic voltammograms with the digitally simulated results.     

基于5-(2-羧基苯基)吡啶-3-甲酸配体的镍(Ⅱ)和锌(Ⅱ)配位聚合物的合成、晶体结构、催化及抗磨性质

采用水热方法,选用5-(2-羧基苯基)吡啶-3-甲酸配体(H₂cpna)与1,2-二(4-吡啶基)乙烷(dpea)或1,2-二(4-吡啶基)乙烯(dpey)分别与NiCl₂·6H₂O和ZnCl₂在160℃下反应,合成了2个三维配位聚合物{[Ni(μ₃-cpna)(μ-dpea)_0.5]·H₂O}_n (1)和{[Zn(μ₃-cpna)(μ-dpey)_0.5]·H₂O}_n (2),并对其结构、催化和摩擦性质进行了研究。研究表明,在室温条件下化合物2在Knoevenagel缩合反应中显示出较好的催化活性。同时,2在聚α-烯烃合成润滑剂中显示出有效的抗磨性能。     

预处理气氛对CuO/CeO2/γ-Al2O3催化剂表面性质及“NO+CO”反应性能的影响

用不同的预处理气氛制备了CeO₂/γ-Al₂O₃载体以调节表面Ce的价态,并以Cu(CH₃COO)₂为前驱体制备了CuCeAl催化剂。XRD和H₂-TPR的结果表明在还原气氛下处理的CeO₂/γ-Al₂O₃载体具有更多的活性氧原子,因此相应的CuCeAl催化剂表面有更多分散态的Cu²⁺/Cu⁺物种。NO+CO反应的结果表明分散态的Cu²⁺/Cu⁺是NO转化的活性物质,而Cu⁰在低温下具有较好的N₂选择性。因此,同时含有分散态Cu²⁺/Cu⁺和少量晶相Cu⁰的催化剂具有最好的催化性能。     

含硫柔性二苯甲酸及氮杂环配体的Zn(Ⅱ)和Mn(Ⅱ)配合物的合成及晶体结构

以2,2'-二硫代二苯甲酸、2,2'-联吡啶、咪唑、硝酸锌和硝酸锰为原料,使用水热方法合成了配合物[Zn(EBLA)(2,2'-bipy)(H₂O)](EBLA=2,2'-二苯甲酸硫醚)(2,2'-bipy=2,2'-联吡啶)(1),自然挥发法制备了配合物[Mn(EBSA)(im)₂(H₂O)]_n(EBSA=2,2'-二硫代二苯甲酸)(im=咪唑)(2).利用元素分析、红外和热重分析对其进行了表征.利用X-射线单晶衍射对结构进行了测定,并研究了配合物1的荧光性质.配合物1中,2,2'-二苯甲酸硫醚是通过水热方法由2,2'-二硫代二苯甲酸发生原位反应制备,Zn²⁺离子是五配位的四角锥双核结构;配合物2中,Mn²⁺离子是六配位的变形八面体一维链状结构.配合物中存在氢键和π-π堆积等弱的分子间作用力.