Three-component cyclization of hydroxylamino-substituted quinoline with reactive methylene compounds and formaldehyde: new method for the synthesis of 7-(isoxazolidin-2-yl)-6-fluoroquinolones

A one-step procedure was developed for the synthesis of new 6-fluoro-7-(isoxazolidin-2-yl)-4-oxo-1,4-dihydroquinolines. The procedure is based on the 1,3-dipolar cycloaddition of the azomethine oxide and 1,1-disubstituted alkenes, which are generated in situ from 6-fluoro-7-hydroxylamino-4-oxo-1,4-dihydroquinoline-3-carboxylic acid and CH-active compounds (dialkyl malonates, ethyl acetoacetate), respectively, in the presence of formaldehyde at 100—120 °C.     

Determination of various deformation processes in impact-modified PMMA at strain rates up to 105%/min

The deformation processes in impact-modified PMMA, which deforms homogeneously, were determined by means of the stress/strain experiment (, ) with simultaneous lateral strain measurement (_lat) in a wide range of strain rates () up to 10⁵%/min (impact stress). The elastic, plastic cavitation and plastic shear processes were determined as a function of strain. Therefore we calculated the elastic strain ( _el), the elastic volume expansion ( _{vol el}), the cavitation strain ( _cav), which is identical with the plastic volume expansion ( _{vol pl}), the shear strain ( _sh) and the energy densities (W_el, W_cav, W_sh) related to these three processes.For strains of 3 % onward it was found that plastic shear processes and plastic cavitation processes are responsible for a partial loss of elastically stored energy. Both plastic processes turn out to be mostly anelastic deformations, their amount depending strongly on the strain rate. The contributions of the processes to the total deformation of the unmodified PMMA in its strain range are similar to those of the impact-modified PMMA, and the high impact strength is caused by a shift of the catastrophic rupture to very high strains.     

Individual determination of ortho and non-ortho substituted polychlorobiphenyls (PCBs) in sediments by high performance liquid chromatographic pre-separation and gas chromatography/ECD detection

Summary An analytical procedure for the individual determination of ortho and non-ortho PCB congeners in sediments, using high performance liquid chromatography (HPLC) preseparation and gas chromatography/ECD detection, is described. Gas chromatography/FTIR spectrometry (GC/FTIR) and gas chromatography/mass spectrometry (GC/MS) were employed for individual congener identification and determination. Sample extraction, clean-up of extract and selective elution procedures were optimized by using reference certified marine sediment samples. Recovery and precision were typically 83% and 16% respectively at 2 ng/g of total PCB content. The proposed procedure, tested by analyzing real sediment samples, showed a reproducibility better than 20% at 13 ng/g PCB level.     

Homolytic addition of polyhaloalkanes to α-vinyloxy-ω-trialkylstannoxy-alkanes as a new route to 2-perhaloalkylmethyl-substituted 1,3-dioxacyclanes

Photoinduced reactions of -vinyloxy--trialkylstannoxyalkanes, CH₂=CHO(CH₂) _n OSnEt₃ (n = 2 to 4), with polyhaloalkanes result in 2-perhaloalkylmethyl-substituted 1,3-dioxacyclanes.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 9, pp. 1824–1826, September, 1995.     

Identification of cis/trans isomers of methyl ester and oxazoline derivatives of unsaturated fatty acids using GC–FTIR–MS

Identification of cis/trans isomers of unsaturated fatty acids cannot usually be achieved by GC-MS (gas chromatography-mass spectrometry) without reference substances. In this study a GC-FTIR-MS system (gas chromatography-Fourier transform-mass spectrometry) was used to identify fatty acid methyl esters (FAMEs) and differentiate between the cis/trans isomers. Besides methyl esters, 2-alkenyl-4,4-dimethyloxazoline derivatives (DMOX), which have been used to locate double bond positions of unsaturated fatty acids, were examined with respect to their suitability for cis/trans differentiation. A combined GC-FTIR-MS system with a wide band (4000–550 cm^?1) mercury cadmium telluride (MCT) detector was used in series and parallel to identify 31 reference unsaturated fatty acids, including 7 pairs of cis/trans isomers. Serum samples of healthy persons and commercially available fish oil were analyzed as examples of complex mixtures. Using splitless injection the detection limit for the less sensitive IR detector was 25 ng/μl in case of the weak cis and trans bands. In the FTIR spectra cis/trans isomers were identified by analysis of bands arising from C? H out-of-plane (oop) bending: for both the FAME and DMOX derivatives cis-1,2-disubstituted double bonds give a strong band near 720 cm^?1 and the corresponding trans isomers near 967 cm^?1. cis Isomers could be identified further by a band at 3012 cm^?1. With the combined data of the GC-FTIR-MS system it is now possible to identify polyunsaturated fatty acids with regard to the discrimination of cis/trans isomers.     

Chemical preparation of conductive elastomeric blends: Polypyrrole/EPDM. I. Oxidant particle-size effect

This work describes the preparation of polypyrrole and EPDM rubber blends, PPy/EPDM, by the sorption of pyrrole (vapor phase) in an EPDM matrix containing CuCl₂. We investigated the effect of the oxidant particle-size on the sorption and polymerization equilibrium, electrical conductivity, and mechanical properties of the blends. Independently of the CuCl₂ concentration and polymerization time, the polypyrrole weight fraction in the blend, X_ppy, increases when the oxidant particle-size in changed from 150–250 μm to smaller than 106 μm. For blends containing 50 phr of CuCl₂, obtained following 72 h of exposure to pyrrole, an increase in the Young's Modulus (from 2.2 ± 0.2 to 3.9 ± 0.6 MPa) and an increase in the electrical conductivity (from 10^?9 to 10^?7 S cm^?1) was observed when the oxidant particle-size was decreased. Infrared spectroscopy, thermogravimetric analysis, scanning differential calorimetry, and scanning electron microscopy were used in sample characterization. © 1994 John Wiley & Sons, Inc.     

Simultaneous determination of capecitabine and its metabolite 5-fluorouracil by column switching and liquid chromatographic/tandem mass spectrometry

A liquid chromatographic/tandem mass spectrometric method was developed and validated for the quantitation of capecitabine and its metabolite 5-fluorouracil in human plasma. The simultaneous determination of both analytes was achieved by a column switching method using a trapping column and two analytical columns with different stationary phases. Isocratic elution was used for the separation of capecitabine on a C18 column whereas 5-fluorouracil was separated using gradient elution on an non-polar carbon phase. The calibration curves were linear for both compounds with a correlation factor (R2) > 0.9993 for 5-fluorouracil and >0.9942 for capecitabine. The assay was validated in the concentration range 5.00-1000 ng ml(-1) for both compounds. The intra-day precision was better than 10% for 5-fluorouracil and better than 11% for capecitabine whereas the inter-day precision was better than 8% for 5-fluorouracil and better than 14% for capecitabine.     

Equations describing lamellar structure parameters and melting points of polyethylene-<Emphasis Type="Italic">co</Emphasis>-(butene/octene)s

Time- and temperature-dependent SAXS-experiments were used to determine the effect of octene and butene co-units on the lamellar structure and the melting properties of polyethylene. As expected, melting points decrease with increasing co-unit content, but crystal thicknesses are not affected and depend on the crystallization temperature only. Results can be cast into some simple equations which describe the dependence:

Novel titanocene anti-cancer drugs derived from fulvenes and titanium dichloride

Starting from 6-(p−N,N-dimethylanilinyl)fulvene (1a) or 6-(pentamethylphenyl)fulvene (1b) [1,2-di(cyclopentadienyl)-1,2-di(p−N,N-dimethylaminophenyl)ethanediyl] titanium dichloride (2a) and [1,2-di(cyclopentadienyl)-1,2-bis(pentamethylphenyl)ethanediyl] titanium dichloride (2b) and their corresponding dithiocyanato complexes (3a, 3b) were synthesized. Titanocene 2b did not show a cytotoxic effect, but when 2a was tested against pig kidney carcinoma cells (LLC-PK) or human ovarian carcinoma cells (A2780/cp70) inhibitory concentrations (IC₅₀) of 2.7 × 10⁻⁴ and 1.9 ×  10⁻⁴ M, respectively, were observed.     

Analysis of turkish lignite tar by coupled LC/GC,GC/MS,and capillary SFC

This work describes the analysis of a pyrolysis product of a lignite sample obtained from the Turkish Goynuk reserve. The aliphatic, aromatic and polar compounds present in the tar are separated and identified by various chromatographic techniques: Capillary gas chromatography/mass spectrometry (GC/MS), on-line high performance microbore liquid chromatography/capillary gas chromatography (LC/GC) and capillary supercritical fluid chromatography (SFC). The suitability of each technique for this particular application is discussed, and semi-quantitative results are presented for the major components detected.