Effect of absorbed pump power on the quality of output beam from monolithic microchip lasers

The dependence of the beam propagation factor (M ² parameter) with the absorbed pump power in the case of monolithic microchip laser under face-cooled configuration is extensively studied. Our investigations show that the M ₂ parameter is related to the absorbed pump power through two parameters (α and β) whose values depend on the laser material properties and laser configuration. We have shown that one parameter arises due to the oscillation of higher order modes in the microchip cavity and the other parameter accounts for the spherical aberration associated with the thermal lens induced by the pump beam. Such dependency of M ² parameter with the absorbed pump power is experimentally verified for a face-cooled monolithic microchip laser based on Nd³⁺ -doped GdVO₄ crystal and the values of α and β parameters were estimated from the experimentally measured data points.     

Quantum states in fabricating poly-Si films

The quantum states are presented in these processions of fabricating poly-Si films. Amorphous silicon films prepared by PECVD has been crystallized by conventional furnace annealing (FA) and rapid thermal annealing (RTA), respectively. It is found that the thin films grain size present quantum states with the increasing of the gas flow ratios of SiH₄, H₂ mixture, substrate temperatures, frequency power, annealing temperature and time.     

烟气中Hg的氧化机理的研究

本文对Ｈｇ与Ｃｌ２在烟气中的氧化反应进行了热力平衡计算和动力学计算。平衡计算的结果表明有ＣＩ元索存在时Ｈｇ的氧化率为１００％，而在相同的条件下动力学计算纺果为Ｈｇ的氧化率在２０％～８０％之间变化，与实验结果吻合。实际的氧化反应是一种超平衡状态，不能达到理想的平衡状态。因此应采用动力学与热力平衡分析相结合的方法研究Ｈｇ在烟气中的反应机理。同时，计算结果显示Ｃｌ含量对Ｈｇ的氧化率的影响很大．     

加肋圆柱壳在轴压作用下的屈曲和后屈曲

本文讨论完善和非完善的,纵向加肋和正交加肋圆柱壳在轴压作用下的屈曲和后屈曲性态.依据文[1]提供的圆柱薄壳屈曲的边界层理论及其分析方法,给出了加肋圆柱壳在轴压作用下的屈曲和后屈曲理论分析.本文同时讨论肋骨与壳板材料不同时对加肋圆柱壳屈曲和后屈曲性态的影响.     

不同重力环境下辐射加热材料表面着火特性分析

研究外界辐射加热下，不同重力环境中热薄燃料的着火特性．探讨了重力、环境氧浓度、环境压力及外界辐射强度对着火的影响．结果表明，随着重力的变化，存在不同的着火机制．在微重力和在高的环境氧浓度中，材料的着火延迟时间变短．压力减小，着火延迟时间增大．随着辐射强度的增大，着火延迟时间变小．     

水反常热膨胀特性的简易实验

通过改变带细玻璃管的烧瓶中水的温度导致水位变化来粗略演示水的收缩情况.为较准确测定水最大密度时的温度,将2个温度计放在水下较浅处和较深处,分别测量当温度经由4℃升高时和由4℃降低时两温度计的示数,进而验证水的反常热膨胀特性.     

a-C:F薄膜的热稳定性与光学带隙的关联

以CF4和C6H6的混合气体作为气源,在微波电子回旋共振化学气相沉积(ECRCVD)装置中制备了氟化非晶碳薄膜(aC:F),并在N2气氛中作了退火处理以考察其热稳定性.通过傅里叶变换红外吸收谱和紫外可见光谱获得了薄膜中CC双键的相对含量和光学带隙,发现膜中CC键含量与光学带隙之间存在着密切的关联,在高微波功率下沉积的氟化非晶碳膜具有低的光学带隙和较好的热稳定性. 关键词： 氟化非晶碳膜 光学带隙 退火温度 热稳定性     

Variational Derivative for Buckling Loads of Beams and Frames

The finite-difference method is a numerical technique for obtaining approximate solutions to differential equations. The main objective of the present study is to give a new aspect to the finite-difference method by using a variational derivative. By applying this formulation, accurate values of the buckling loads of beams and frames with various end supports are obtained. The performance of this formulation is verified by comparison with numerical examples in the literature __________ Published in Prikladnaya Mekhanika, Vol. 41, No. 7, pp. 139–144, July 2005.     

A WKB analysis of the buckling condition for a cylindrical shell of arbitrary thickness subjected to an external pressure

We consider the plane-strain buckling of a cylindrical shellof arbitrary thickness which is made of a Varga material andis subjected to an external hydrostatic pressure on its outersurface. The WKB method is used to solve the eigenvalue problemthat results from the linear bifurcation analysis. We show thatthe circular cross-section buckles into a non-circular shapeat a value of µ₁ which depends on A₁/A₂ and a mode number,where A₁ and A₂ are the undeformed inner and outer radii, andµ₁ is the ratio of the deformed inner radius to A₁. Inthe large mode number limit, we find that the dependence ofµ₁ on A₁/A₂ has a boundary layer structure: it is constantover almost the entire region of 0 < A₁/A₂ < 1 and decreasessharply from this constant value to unity as A₁/A₂ tends tounity. Our asymptotic results for A₁ – 1 = O(1) and A₁– 1 = O(1/n) are shown to agree with the numerical resultsobtained by using the compound matrix method.     

Numerical simulation of thermally and chemically nonequilibrium flows and heat transfer in underexpanded induction plasmatron jets

The results of numerical simulation are presented for thermally and chemically nonequilibrium air plasma flows in a plasmatron discharge channel and underexpanded dissociated and partially ionized air jets flowing past a cylindrical model with a blunt leading edge and cooled copper surface under the experimental conditions realized in a VGU-4 100 kW induction plasmatron (Institute for Problems in Mechanics of the Russian Academy of Sciences) (see, for example, [1, 2]). The nonequilibrium excitation of the vibrational degrees of freedom of the molecules in the modal approximation and the difference between the electron and translational heavy-particle temperatures are taken into account in the calculations. The calculated data on the heat transfer and pressure at the stagnation point are compared with the results obtained within the framework of the thermally equilibrium model. Comparison with the experimental data obtained in the Institute for Problem in Mechanics of the Russian Academy of Sciences (Laboratory for interaction between plasma and radiation and materials) and kindly provided for comparison purposes gives satisfactory agreement.