脱乙酰基对天然魔芋葡甘聚糖分子形貌的影响

通过原子力显微镜直接观察魔芋葡甘聚糖（KGM）分子的三维结构形貌，KGM水溶液铺展在经Ca^2 处理的云母片上，干燥固定后，可获得稳定，重复的图像，实验结果表明，稀溶液中KGM分子具有伸展的螺旋链状结构，单股的长度达200－400nm，厚度为1．0nm，宽度为35．0－35．2nm，脱乙酰后分子链卷曲成直径约40－50nm,厚3．5－5．0nm的弹性圆台状。     

Vibrational assignment, <Emphasis Type="Italic">ab initio</Emphasis> calculation and normal coordinate analysis of 2,2′-biquinoline

The vibrational wavenumbers and the fundamental modes of 2,2′-biquinoline were obtained by density functional theory (DFT) with the B3LYP functional using the 6-31G(d,p) basis set. The calculated wavenumbers were scaled by a single factor of 0.965 to correct them for vibrational anharmonicity, but the force constants were overestimated. Normal coordinate analysis of the molecule was also carried out by using the force field of the quinoline molecule and the force field parameters of quinoline are shown to be transferable to 2,2′-biquinoline. The potential energy distribution associated with the normal modes is also given. The theoretical wavenumbers are found to be in good agreement with the experimental data.     

划痕试验法对特殊薄膜系结合力的检测与评价

简要介绍了划痕试验法测量表面薄膜与基体结合力的测试原理和实验方法，讨论了影响临界载荷Lc测量值准确性的主要因素，通过对薄膜系的分类以及大量实际测量数据的总结和分析，认为被测薄膜以及基体的物理化学特性对临界载荷的测量具有重要的影响，单纯从声发射信号的变化来确定临界载荷的方法有可能存在较大误差，分析和讨论了某些特殊薄膜系的声发射信号与其实际临界载荷值之间存在较大偏差的现象和原因，并提出了针对不同膜系，合理利用声发射曲线，摩擦力斜率以及显微观测来正确判定临界载荷的必要性。     

Characterization of Ultrathin Films of Cellulose Esters

The adsorption of cellulose acetate (CA), cellulose acetate propionate (CAP) and cellulose acetate butyrate (CAB) from solutions prepared in acetone onto silicon wafers led to ultrathin films, which were characterized by ellipsometry, atomic force microscopy (AFM) and contact angle measurements. The polysaccharides films were characterized in the air just after their formation and after annealing at temperatures higher than their glass transition temperature or melt temperature. The films thickness close to 2 nm and surface roughness did not vary significantly upon annealing. AFM images revealed the presence of small clumps dispersed on a homogeneous layer, which covered completely the Si wafers. Such topographic details were also observed after annealing. However, upon annealing the films surfaces changed from hydrophilic to hydrophobic, evidencing molecular re-orientation at the solid–air interface. The adhesion of bovine serum albumin (BSA) and lipase onto the cellulose esters films was quantified in order to evaluate the possibility of applying such films as selective support for biomolecules.     

衬钽管石墨炉原子吸收法测定痕量镓时基体改进剂的研究及应用

提出用钒和铜混合基体改进剂衬钽管石墨炉原子吸收测定镓的方法。衬钽管使镓的灵敏度提高6倍左右,钒和铜混合基体改进剂不仅能进一步提高灵敏度,而且能提高灰化温度,降低原子化温度,增强抗干扰能力。测定 GSD 标准样品中的镓时,不需对样品进行预分离即可直接进行测定,结果与参考值相符。     

Surface forces in foam films from ABA block copolymer: a dynamic method study

The thinning of foam films from aqueous solutions of an ABA triblock copolymer of polyethylene oxide and polypropylene oxide (average molecular weight 14,000 g/mol) is studied experimentally. The dependence of the surface forces on film thickness is obtained by the dynamic method of Scheludko and Exerowa.The total surface force measured in foam films (radius 60–70 m) from 10^–5 M (0.014 wt%) polymer solution with 0.1 M NaCl is positive at thicknesses from about 800 down to 460 . The electrostatic repulsion is negligible while the contribution of van der Waals attraction is small (within 15%). Therefore a positive surface force component predominates. Most probably it arises from steric interactions between the hydrophilic polyethylene oxide tails of the polymer. The dynamic method appears to be a suitable technique for exploring the stabilization of foam films from ABA copolymers.     

辣根过氧化物酶活性膜结构及生物电催化性能

通过分子沉积法研究了在聚对苯二甲酸乙二醇酯（PET）表面及金电极表面组装辣根过氧化物酶（HRP）/聚对苯乙烯磺酸钠（PSS）多层生物活性膜，用原子力显微镜(AFM)研究了组装膜的表面形貌，并研究了组装膜的形貌、粗糙度和活性关系.应用循环伏安法（CV）研究了组装HRP膜后电极对H2O2的电化学催化还原作用.实验发现，采用亚甲基蓝（MB）溶液为介质，在H2O2浓度为0.2～5.0 mmol•L－1时，其响应电流对H2O2浓度变化基本呈线性.     

Dynamic imaging of single DNA-protein interactions using atomic force microscopy

Atomic force microscopy (AFM) imaging of static DNA-protein complexes, in air and in liquid, can be used to directly obtain quantitative and qualitative information on the structure of different complexes. For example, DNA length, the location of preferential binding sites for proteins and bending of DNA as a result of the complexation can all be measured. Recording consecutive AFM images of DNA and protein molecules under conditions that they are still able to move and interact, or dynamic AFM imaging, however, can reveal information on the dynamic aspects of the interactions between these molecules. Here, an overview is given of the technical challenges that need to be considered for successful dynamic AFM imaging studies of individual DNA-protein interactions. Necessary technical improvements to the AFM set-up and the development of new sample preparation methods are described in this paper.     

Free energy perturbation approach to the critical assessment of selective cyclooxygenase-2 inhibitors

The discovery of selective cyclooxygenase-2 (COX-2) inhibitors represents a major achievement of the efforts over the past few decades to develop therapeutic treatments for inflammation. To gain insights into designing new COX-2-selective inhibitors, we address the energetic and structural basis for the selective inhibition of COX isozymes by means of a combined computational protocol involving docking experiment, force field design for the heme prothetic group, and free energy perturbation (FEP) simulation. We consider both COX-2- and COX-1-selective inhibitors taking the V523I mutant of COX-2 to be a relevant structural model for COX-1 as confirmed by a variety of experimental and theoretical evidences. For all COX-2-selective inhibitors under consideration, we find that free energies of binding become less favorable as the receptor changes from COX-2 to COX-1, due to the weakening and/or loss of hydrogen bond and hydrophobic interactions that stabilize the inhibitors in the COX-2 active site. On the other hand, COX-1-selective oxicam inhibitors gain extra stabilization energy with the change of residue 523 from valine to isoleucine because of the formations of new hydrogen bonds in the enzyme-inhibitor complexes. The utility of the combined computational approach, as a valuable tool for in silico screening of COX-2-selective inhibitors, is further exemplified by identifying the physicochemical origins of the enantiospecific selective inhibition of COX-2 by -substituted indomethacin ethanolamide inhibitors.     

Second Dissociation Constants of 4-[N-morpholino]butanesulfonic Acid and N-[2-hydroxyethyl]piperazine-N′-4-butanesulfonic Acid from 5 to 55°C

The values of the second dissociation constant, pK ₂, for the dissociation of the NH⁺ charge center of the zwitterionic buffer compounds 4-(N-morpholino)butanesulfonic acid (MOBS), and N-(2-hydroxyethyl)piperazine-N-4-butanesulfonic acid (HEPBS) have been determined from 5 to 55°C, including, 37°C at intervals of 5°C. The electromotive-force (emf) measurements have been made utilizing hydrogen electrodes and silver–silver chloride electrodes. The value of pK ₂ for MOBS was found to be 7.702 ± 0.0005, and 8.284 ± 0.0004 for HEPBS, at 25°C, respectively. The related thermodynamic quantities, G ^o, H ^o, S ^o, and C _p ^o for the dissociation processes of MOBS and HEPBS have been derived from the temperature coefficients of pK ₂. Both the MOBS and HEPBS buffer materials are useful as primary pH standards for the control of pH 7.3 to 8.6 in the region close to that of physiological fluids.