Pyrolysis GC/MS analysis of a bacterial population in a saline activated sludge system—Identification of the origin of the pyrolysis product 2-methylpyrimidine

During the investigation of problems with the physical handling of sludge from a saline activated sludge wastewater system, pyrolysis/GC/MS was used in an attempt to determine whether changes in the bacterial population in the sludge were occurring. The pyrolysis GC/MS analysis revealed an unknown peak among other typical bacterial pyrolysis products. This unknown was identified as 2-methylpyrimidine. This pyrolysis product was only found in appreciable amounts in samples from other saline systems but not in freshwater systems analyzed as points of comparison for the system of concern. Further investigation confirmed the source of 2-methylpyrimidine to be ectoine, a compound produced by halophilic bacteria as a compatible solute for osmoadaptation. Pyrolysis GC/MS was shown to be a useful tool to indicate the presence of ectoine in halophilic bacteria.     

一种煤与两种城市污水污泥混合热解的热重分析

采用热重分析法对一种煤和两种城市污水污泥（S1和S2）及其混合物进行了热解实验研究,揭示了煤和污泥在氮气中的热解特性及污泥对煤热解特性的影响。煤和污泥的热解特性参数不同,主要表现在总失重率、失重速率及挥发分析出温度区间等。煤与污泥S1混合有助于增加样品的热解总失重率,提高失重速率;污泥S1与煤的挥发分析出区间部分重合,污泥灰中含的无机物对煤的热解起到催化效果;煤和S2污泥混合后热解反应过程中无明显相互作用;煤与城市污水污泥混合物的相互作用与样品特性和混合比例有关。     

Focused ultrasound solid-liquid extraction and selective pressurised liquid extraction to determine bisphenol A and alkylphenols in sewage sludge by gas chromatography-mass spectrometry

A new method for determining endocrine disrupter compounds (EDCs) in sewage sludge is described in this paper. EDCs studied were bisphenol A (BPA) and alkylphenols (APs). In order to obtain a fast and simple method, selective pressurised liquid extraction (SPLE) and focused ultrasound solid-liquid extraction (FUSLE) were tested. Best results for SPLE were obtained using Florisil as clean-up sorbent and dichloromethane as extraction solvent, while temperature was the only significant variable. Analyte extraction by SPLE was completed in only one extraction cycle of 1 min at 130 °C. FUSLE was carried out in one step of 20 s at 75% power (0.5 cycles) and with 8 mL of ethyl acetate. Although the optimised FUSLE process was faster, simpler and cheaper, SPLE provided higher recovery values (ranging from 81 to 105%) and therefore SPLE-based method was selected and validated. The SPLE and GC-MS method showed an LOD of 10.7 ng/g for BPA and LODs between 1.2 and 41.6 ng/g for APs. Relative standard deviation values lower than 6% were obtained for all analytes. As a result, an efficient, fast and simple method based on SPLE and GC-MS for the determination of BPA and APs in sewage sludge is proposed.     

Determination of azoles in sewage sludge from Spanish wastewater treatment plants by liquid chromatography-tandem mass spectrometry

A simple and rapid analytical method for the determination of 16 azoles in sewage sludge has been developed and validated. The method was based on ultrasound-assisted extraction followed by dispersive solid-phase extraction cleanup and liquid chromatography-electrospray tandem mass spectrometric detection. The azoles were selected by their intensive usage as biocides (tebuconazole, propiconazole, cyproconazole and thiabendazole), antimycotic pharmaceuticals (ketoconazole, econazole, fluconazole and clotrimazole) or fungicides in agriculture (difenoconazole, flusilazole, hexaconazole, prochloraz, bromuconazole, epoxiconazole and triticonazole). The recoveries of these compounds through the method were between 71.9 and 115.8%, with relative standard deviations lower than 20%. Detection limits were in the range of 0.5-5.0 ng/g. The developed method was applied to the analysis of azoles in sewage sludge samples collected from 19 Spanish wastewater treatment plants. Although azoles used as biocides or agriculture fungicides were present in a few sludge samples, the pharmaceuticals ketoconazole, econazole and clotrimazole were present in all of the analyzed sludge samples, being ketoconazole the one found at the highest level, representing the 68.6% of the total azole content found in the 19 sludge samples studied.     

Hollow fiber liquid phase microextraction as a preconcentration and clean-up step after pressurized hot water extraction for the determination of non-steroidal anti-inflammatory drugs in sewage sludge

A method for the quantitative determination of non-steroidal anti-inflammatory drugs (NSAIDs) in sewage sludge was developed and validated. The target compounds were extracted using pressurized hot water extraction (PHWE) and then purified and preconcentrated by three-phase hollow fiber liquid phase microextraction (HF-LPME) followed by LC–ESI-MS analysis. The PHWE was optimized with regard to the pH of solvent as well as other operational parameters. The optimum conditions were 0.01 M NaOH as the extraction solvent, temperature of 120 °C, pressure of 100 bar, static time 5 min, 5 cycles, flush volume 90% and purge time 60 s. Spike recoveries for sludge samples spiked at 200 ng g⁻¹ were in the range of 101–109% but for the native drugs in non-spiked sludge samples, recoveries were 38.9%, 59.8%, 90.3% and 47.8% for ketoprofen, naproxen, diclofenac and ibuprofen, respectively. Donor phase pH, ionic strength and extraction time were optimized for HF-LPME after PHWE. The optimum conditions were 2 h extraction at pH 1.5 without salt addition. Enrichment factors in the range of 947–1213 times were achieved (extraction recoveries were 23.6–30.3%) for HF-LPME after PHWE. The matrix effect on the ionization of drugs in LC–ESI-MS was also investigated. The results show that there is a smaller matrix effect (−8.9% to +14.6%) in comparison with other published values obtained using solid phase extraction (SPE) for clean-up after pressurized liquid extraction (PLE). Method detection limits (MDLs) and method quantification limits (MQLs) for different drugs were in the range of 0.4–3.7 ng g⁻¹ and 1.5–12.2 ng g⁻¹ in dried sludge samples, respectively. The characteristics of the proposed method were compared with those of other published works. The considerably lower ion suppression/enhancement and minimum use of organic solvents (a few microliters of di-n-hexyl ether) in the sample preparation step are two highlighted advantages of the proposed method in comparison with previously published works. The method was applied to determine NSAIDs in sewage sludge from Källby wastewater treatment plant (Lund, Sweden) in April, June, August and October 2010. The highest concentration level was recorded for ibuprofen in the April sewage sludge sample (588 ng g⁻¹) and all of the selected NSAIDs were detected in all the samples analyzed.     

微生物量对印染废水中的基质去除速率的影响

基于Monod方程,引入微生物量函数,建立了考虑微生物量作用的基质去除速率方程,并利用基质去除的零级反应速率求解有关参数.活性污泥好氧处理印染废水时,所需要的微生物量与反应时间密切相关,当HRT为24h,MLSS为2.2g·L-1,基质去除率为83%;而当HRT为12h,要达到相同的基质去除率,MLSS须维持在4.0g·L-1.当MLSS≤2.5g·L-1,基质去除速率与微生物量成正比;当MLSS为4.0g·L-1,基质去除速率约为最大值的86.2%,而且MLSS≥4.0g·L-1,基质去除速率随MLSS的变化不明显.所建立的基质去除速率方程能够较好地反映微生物量对基质去除速率的影响.     

Comparison of three sequential extraction procedures to describe metal fractionation in anaerobic granular sludges

In the last few decades, several sequential extraction procedures have been developed to quantify the chemical status of metals in the solid phase. In this study, three extraction techniques (modified [A. Tessier, P.G.C. Campbell, M. Bisson, Anal. Chem. 51 (1979) 844]; [R.C. Stover, L.E. Sommers, D.J. Silvera, J. Water Pollut. Con. F. 48 (1976) 2165]; and the Bureau Communautaire de Reference (BCR) [K.F. Mossop, C.M. Davidson, Anal. Chim. Acta 478 (2003) 111]) were applied to study the distribution of trace (Co, Ni, Zn and Cu) and major (Mn and Fe) elements in two different anaerobic granular sludges from full-scale methanogenic wastewater treatment plants. The Stover scheme displayed a higher number of fractions that induces a poor recovery compared to the other schemes. The sequential extraction scheme recommended by BCR and the modified Tessier scheme gave similar trends and are sufficiently repeatable and reproducible for application in fractionation studies. However, the BCR scheme seems to be of limited utilisation to study anaerobic matrixes because the extraction stage for its reducible fraction may release substantial amounts of trace elements bound to the organic/sulfides fraction, and consequently, the recovery of trace elements in the oxide fraction may be overestimated at the expense of the oxidisable fraction. As a final conclusion, the modified Tessier scheme seems to be the most suitable scheme to study the metal partitioning in anaerobic granular sludges.     

Flow characteristics of primary and digested sewage sludge

Summary Rheological study of sewage sludge is useful for the design, operation and control of sewage treatment plants. The rheology is highly dependent on physical, chemical and biological characteristics of the sludge. A pipeline rheometer is described in this paper for measurement of rheological properties of the sludge. Primary sewage sludge is a complex flocculated suspension having no fixed particle dimension, shape, size distribution or surface characteristics. The information available so far on rheology of sewage sludge is not suitable for application in design because of the lack of data on physico-chemical characteristics of this sludge.Primary and digested sewage sludge are non-Newtonian in character. Both exhibit yield stress and while primary sludge is shear-thinning in nature, digested sludge has been found to be shear-thickening. Parabolic and yield-power law models have been used to express the experimental data obtained for sludges at various concentrations and temperatures. Yield stress of primary sludge varies exponentially with concentration and linearly with temperature within the short temperature range studied. Primary sludge is found to be antithixotropic at low shear stress. Digested sludge does not exhibit time dependency.With 9 figures and 5 tables     

Influence of ultrasonication and Fenton oxidation pre-treatment on rheological characteristics of wastewater sludge

The effect of ultrasonication and Fenton oxidation as physico-chemical pre-treatment processes on the change of rheology of wastewater sludge was investigated in this study. Pre-treated and raw sludges displayed non-Newtonian rheological behaviour with shear thinning as well as thixotropic properties for total solids ranging from 10 g/L to 40 g/L. The rheological models, namely, Bingham plastic, Casson law, NCA/CMA Casson, IPC Paste, and power law were also studied to characterize flow of raw and pre-treated sludges. Among all rheological models, the power law was more prominent in describing the rheology of the sludges. Pre-treatment processes resulted in a decrease in pseudoplasticity of sludge due to the decrease in consistency index K varying from 42.4 to 1188, 25.6 to 620.4 and 52.5 to 317.9; and increase in flow behaviour index n changing from 0.5 to 0.35, 0.62 to 0.55 and 0.63 to 0.58, for RS, UlS and FS, respectively at solids concentration 10–40 g/L. The correlation between improvement of biodegradability and dewaterability, decrease in viscosity, and change in particle size as a function of sludge pre-treatment process was also investigated. Fenton oxidation facilitated sludge filterability resulting in capillary suction time values which were approximately 50% of the raw sludges, whereas ultrasonication with high input energy deteriorated the filterability. Biodegradability was also enhanced by the pre-treatment processes and the maximum value was obtained (64%, 77% and 73% for raw, ultrasonicated and Fenton oxidized sludges, respectively) at total solids concentration of 25 g/L. Hence, pre-treatment of wastewater sludge modified the rheological properties so that: (1) the flowability of sludge was improved for transport through the treatment train (via pipes and pumps); (2) the dewaterability of wastewater sludge was enhanced for eventual disposal and; (3) the assimilation of nutrients by microorganisms for further value-addition was increased.     

Thermal decomposition study of sewage sludge and of organicwaste used in the sorption of metals

The conventional treatments of effluents containing heavy metals produce significant quantities of byproducts with recalcitrant characteristics, making necessary looking after alternative techniques in order to avoid the production of new contaminated residues. Sorption process of chromium and zinc in vertical columns loaded with sewage sludge and organic solid waste has been studied in this work. The data from the TG curves of the two sorbents presented significant differences when they were submitted to the metal uptake, being noticed the displacement of the thermal events towards lower temperatures for both types of sorbents studied. As it was expected, for both sorbents, an increase in the mass of samples has been observed at the completion of the thermal tests upon metal uptake. Therefore, these facts demonstrate that during the biosorption process a physico-chemical interaction took place between sorbents and metals, as it was evidenced by the more than 100 K increase in the decomposition temperatures as well as the variation of the ΔH values of the samples.