Differences in the electrorheological response of a particle suspension under direct current and alternating current electric fields

We have observed an unusual reduction of shear stress with increasing shear rate under direct current electric fields, for an electrorheological fluid composed of sulfonated poly(styrene-co-divinylbenzene) particles dispersed in silicone oil. At all shear rates, the shear stress under the electric field is larger than that in the absence of the field, indicating that there is still some field-induced agglomeration of the particles. In contrast, the behavior under alternating current electric fields is the Bingham-fluid-type response commonly observed with electrorheological fluids. It is suggested that the conventional dipole–dipole interaction approach based on simplified microstructural models would be unable to explain these phenomena. Received: 27 November 2000 Accepted: 22 May 2001     

TS和PTS单晶体的热刺激电流

测定了双(对甲基磺酸)2,4-己二炔-1,6-二醇酯(TS)及其不同聚合程度TS-PTS混合体和完全聚合的聚合物PTS在100-300K温度范围内的热刺激电流。在沿分子堆砌方向上(对PTS则是大分子链方向)上观察到了它们的热刺激电流,并在相应于它们相变152K和192K处呈现热刺激电流峰。研究了聚合程度对相变的影响,绘制了TS-PTS体系的相图。对另三个热刺激电流峰的归属作了定性解释。     

The structure and electrochemical characteristics of La0.67Mg0.33 (Ni0.8Co0.1Mn0.1) x (x=2.5–5.0) multiphase alloys for nickel-metal hydride batteries

This paper presents results concerning structure and electrochemical characteristics of the La_0.67Mg_0.33 (Ni_0.8Co_0.1Mn_0.1) _x (x=2.5–5.0) alloy. It can be found from the result of the Rietveld analyses that the structures of the alloys change obviously with increasing x from 2.5 to 5.0. The main phase of the alloys with x=2.5–3.5 is LaMg₂Ni₉ phase with a PuNi₃-type rhombohedral structure, but the main phase of the alloys with x=4.0–5.0 is LaNi₅phase with a CaCu₅-type hexagonal structure. Furthermore, the phase ratio, lattice parameter and cell volume of the LaMg₂Ni₉phase and the LaNi₅ phase change with increasing x. The electrochemical studies show that the maximum discharge capacity increases from 214.7 mAh/g (x=2.5) to 391.1 mAh/g (x=3.5) and then decreases to 238.5 mAh/g (x=5.0). As the discharge current density is 1,200 mA/g, the high rate dischargeability (HRD) increases from 51.1% (x=2.5) to 83.7% (x=3.5) and then decreases to 71.6% (x=5.0). Moreover, the exchange current density (I ₀) of the alloy electrodes first increases and then decrease with increasing x from 2.5 to 5.0, which is consistent with the variation of the HRD. The cell volume reduces with increasing x in the alloys, which is detrimental to hydrogen diffusion and accordingly decreases the low-temperature dischargeability of the alloy electrodes.     

SDS/n－C5H11OH/n－C7H16/H2O体系中W/O－BI微乳液界面电性质

In the system of SDS/n-C5H11OH/n-C7H16/H2O with the weight ratio of SDS/n-C5H11OH/H2O system at5.0/47.5/47.5, the upper phase of the system was W/O microemulsion, and the lower phase was the bicontinuous microemulsion. When the n-heptane content was less than 1%, with the increase of the n-heptane content, the capacitance (Co, Cod) in the upper phase (W/O) dropped, the capacitance (CB1, CBld) in the lower phase (BI) raised. At the same time, the W/O-BI inteffacial potential (ΔE), capacitance (Ci), and charge-transfer current (ict) decreased.After the n-heptane content reached 1%, with the increase of the n-heptane content, ΔE, Ci and ict demonstrated no significant change.     

SYNTHESIS AND PROPERTIES OF SULFONATED POLY（ARYLENE ETHER） CONTAINING TRIPHENYL METHANE MOIETIES FROM ISOCYNATE MASKED BISPHENOL

A novel sulfonated poly（arylene ether） containing triphenylmethane moieties was synthesized by the sulfonation of a designed parent polymer using chlorosulfonic acid as sulfonation agent. The sulfonation took place at the para position of the pendant phenyl rings because of the specially designed parent polymer. The position and degree of sulfonation were characterized by ^1H-NMR and elemental analysis. The sulfonated polymers are highly soluble in common organic solvents, such as dimethylsulfoxide, N,N＇-dimethylacetamide, dimethylformamide, ethylene glycol monomethyl ether, and can be readily cast into tough and smooth films from solutions. The films showed good thermal and hydrolysis stabilities. Moreover, Fenton＇s reagent test revealed that the films exhibited superior stability to oxidation. The proton conductivities of the films were comparable with Nation 117 under same conditions. The membrane electrode assembly （MEA） prepared with the asmade film （706 EW, 100 μm dry thickness） shows better cell performance than Nation 115-MEA in the whole current density range.     

Vergleichende Messungen des Zeta-Potentials von Faserstoffen durch Elektroosmose und Strömungsstrom/Strömungspotential

An apparatus for the determination of zetapotential is described, which allows measurement of both streaming potential and streaming current as well as electroosmosis with one and the same fiber diaphragm with various electrodes (calomel, Ag/AgCl, palladium). Measurements with glass fibers, fibers of polyacrylonitrile and of polyester, and with cellulose pulp show that identical values for the electrokinetic parameters are obtained independent of voltage applied during electroosmosis resp. pressure difference during streaming measurements. This allows the conclusion that the zetapotential in dilute electrolyte solution is here an unequivocally determinable figure.

Herrn Prof. Dr.R. C. Schulz mit den herzlichsten Glückwünschen zum 65. Geburtstag gewidmet.     

Theoretical analysis of the performance of a model supercapacitor consisting of metal oxide nano-particles

The factors influencing the electrochemical behaviour of a supercapacitor have been partly examined in this work. The effects of so-called intrinsic parameters, i.e. exchange current density, unit cell length and double layer (DL) capacitance; as well as the so-called application parameters, i.e. cell current, on the cell potential discharge time have been considered. The contributions of each type of capacitors, DL capacitor and faradaic supercapacitor under various states of operation and material have been analyzed, and the competing (compensating) effects of the two types of capacitors as regards to the discharge and power characteristics manifested by current–potential and energy–power (Ragone plots) are elucidated.     

A unified orbital model of delocalised and localised currents in monocycles, from annulenes to azabora-heterocycles

Why are some (4n+2)π systems aromatic, and some not? The ipsocentric approach to the calculation of the current density induced in a molecule by an external magnetic field predicts a four‐electron diatropic (aromatic) ring current for (4n+2)π carbocycles and a two‐electron paratropic (antiaromatic) current for (4n)π carbocycles. With the inclusion of an electronegativity parameter, an ipsocentric frontier‐orbital model also predicts the transition from delocalised currents in carbocycles to nitrogen‐localised currents in alternating azabora‐heterocycles, which rationalises the differences in (magnetic) aromaticity between these isoelectronic π‐conjugated systems. Ab initio valence‐bond calculations confirm the localisation predicted by the naïve model, and coupled‐Hartree–Fock calculations give current‐density maps that exhibit the predicted delocalised‐to‐localised/carbocycle–heterocycle transition.     

有限线性扩散区域内EC＇反应催化电流

有限线性扩散区域内ＥＣ＇反应催化电流吴志斌，董绍俊，吴浩青（同济大学化学系，上海，２０００９２）（中国科学院长春应用化学研究所）（复旦大学化学系）关键词有限线性扩散空间，ＥＣ＇反应，催化电流化学修饰电极等有关膜电极及薄层池的电极过程动力学问题均涉及到...     

基于定向纳米碳管气体放电的气敏传感器研究

介绍了一种基于定向纳米碳管的气敏传感器,以生长定向纳米碳管的氧化铝模板作为阳极,铝板作为阴极,利用纳米碳管的尖端发射效应,在较低的电压下使气体产生放电现象。通过对纳米碳管在气体中击穿电压和放电电流的测量,实现对气体的定性定量检测。同时纳米碳管气敏传感器还具有体积小、灵敏度高、稳定性好、响应速度快、在常温常压下即可进行检测等优点,具有较好的应用前景。