钝体后湍流预混燃烧的PDF模拟

本文采用PDF方法对矩形燃烧室内钝体后的湍流预混火焰进行了数值模拟。脉动速度-频率-标量联合的PDF输运方程用Monte Carlo方法求解,质量、动量和能量的平均值由基于无结构网格的有限体积法求解,压力通过状态方程获得。PDF方程中所需的平均密度、平均速度和压力由有限体积法提供,并将用Monte Carlo方法求出的雷诺应力、化学反应源项和比热比传递给有限体积法。本文对丙烷和空气燃烧的不同简化化学反应机理进行了研究,并与实验结果进行比较,获得满意的结果。     

An experimental and kinetic modeling study of a premixed nitromethane flame at low pressure

A premixed nitromethane/oxygen/argon flame at low pressure (4.67 kPa) has been investigated using tunable vacuum ultraviolet (VUV) photoionization and molecular-beam mass spectrometry. About 30 flame species including hydrocarbons, oxygenated and nitrogenous intermediates have been identified by measurements of photoionization efficiency spectra. Mole fraction profiles of the flame species have been determined by scanning burner position at some selected photon energies. The results indicate that N₂ and NO are the major nitrogenous products in the nitromethane flame. Compared with previous studies on nitromethane combustion, a number of unreported intermediates, including C₃H₄, C₄H₆, C₄H₈, C₂H₂O, C₂H₄O, CH₃CN, H₂CNHO, C₃H₃N and C₃H₇N, are observed in this work. Based on our experimental results and previous modeling studies, a detailed oxidation mechanism including 69 species and 314 reactions has been developed to simulate the flame structure. Despite some small discrepancies, the predictions by the modeling study are in reasonable agreement with the experimental results.     

聚心火焰在共振腔作用下引发爆轰的数值研究

 基于带化学反应的二维轴对称Euler方程，利用带有Superbee限制函数的波传播算法，对共振腔中的氢气-空气预混气的聚心燃烧进行了数值模拟，讨论了共振腔不同抛物面对起爆的影响。数值结果表明，在开始阶段，燃烧诱导的激波在轴心、火焰和固壁的反射，使火焰失稳，随后共振腔中的抛物壁面上产生一定频率和强度的反射激波，不断穿越火焰，使火焰进一步失稳，加剧了燃烧速度，最终导致爆轰的形成。同时，火焰在与激波的作用过程中，形状扭曲变形，呈封闭端小敞口端大的扁平头部蘑菇云。共振腔抛物面的不同形状引起激波聚焦位置的变化，会影响激波和火焰的相互作用，使起爆提前或推迟，甚至不起爆。     

火焰辐射及偶丝导热对热电偶测温影响的数值分析

本文利用层流同向扩散乙烯火焰的数值模拟结果,根据所得的火焰温度场、气体速度场、火焰辐射场,分析火焰辐射、热电偶偶丝导热对热电偶测温的影响.结果表明在火焰的低温区火焰辐射要大于节点向外辐射,节点得到的能量要高于节点损失的能量,因此在火焰的低温区节点温度要高于当地的气体温度;同时直径为100μm的热电偶存在较大的导热,对节点温度测量有较大的影响.     

On intrinsic oscillation in radiation-affected diffusion flames

A linear stability analysis is conducted to study the onset of near-limit flame oscillation with radiative heat loss in 1-D chambered planar flames using multi-scale activation-energy asymptotics. The oscillatory instability near the radiation-induced extinction limit at large Damköhler numbers is identified, in additional to the one near the kinetic limit at small Damköhler numbers. It is shown that radiative loss assumes a similar role as varying the thermal diffusivity of the reactants. Thus, flame oscillation near the radiative limit is still thermal-diffusive in nature although it may develop under unity Lewis numbers. The unstable range of Damköhler numbers near the radiative limit shows quite similar parametric dependence on the Lewis numbers of reactants, Le_F and Le_O, the stoichiometry, ?, and the radiative loss as that near the kinetic limit. They both increase monotonically with Le_O and ? and increase then decrease with Le_F. Increasing radiative loss extends the parameter range under which flame oscillations may develop. However, they show different dependence on the temperature difference between the supplying reactants. Unless radiative loss approaches its maximum value the system can sustain, flame oscillation near the radiative limit is only possible within a limited range of ΔT, whereas it is promoted monotonically with decreasing ΔT near the kinetic limit. Furthermore, while radiative loss shows small effect on the nondimensional oscillation frequency, the dimensional frequency of flame oscillations near the radiative limit can be substantially smaller than that near the kinetic limit.     

Continuous flame oxidation in supercritical water

Abstract

Continuous flames have been observed in Supercritical water oxidation (scWO) of isopropyl alcohol (IPA), using a vertical continuous reactor with sapphire windows and a mixing nozzle. Two types of continuous flame were confirmed: the one was long pale blue colored and the other was red short cone shaped, changing blue to red at around air ratio 2.0. The flame was strongly influenced by IPA concentration, air ratio and design of the mixing nozzle. Results for decomposition of PA are presented for IPA concentrations ranging from 600 up to 28260 ppm as TOC and initial reactor temperatures, were mostly around 490°C, at 25 MPa. Decomposition rate at steady state was over 99.9%. Experimentally measured CO₂ and O₂ concentrations at the flue gas were in good agreement with theoretically calculated values. Even for low air ratio as 1.1, high decomposition rate without CO, NO, NO₂ was achieved.     

Improved Performance of On-line Atom Trapping in Flame Furnace Atomic Absorption Spectrometry by Chemical Vapor Generation: Determination of Cadmium in High-Salinity Water Samples

ABSTRACT

On-line atom trapping inside a nickel flame furnace using chemical vapor generation for sample introduction was proposed for the determination of trace cadmium by flame atomic absorption spectrometry (AAS). Cadmium volatile species was generated upon reaction with potassium borohydride and then flushed into a flame furnace for on-line trapping by a flow of nitrogen carrier gas. The middle part of the flame furnace, where the carrier gas impacts, is cooled by the gas flow, and this provides a fine strategy for on-line atom trapping for the purpose of preconcentration. A stainless steel plate is put on the top of the flame burner in the middle to form a flame-free zone, which also greatly lowers the temperature of the flame furnace and facilitates the atom-trapping process. Due to the introduction of chemical vapor generation, matrix effect was greatly alleviated compared with direct pneumatic nebulization for on-line atom trapping in flame furnace AAS. With trapping time of 35 s, the current approach achieved an excellent limit of detection of 20 ng L^?1. The proposed method was successfully applied for the quantification of cadmium in high-salinity samples.     

枪口焰烟光学特性测试研究

针对狙击作战中对狙击手的探测、定位及告警的需求,开展了枪口焰烟光学特性测试研究。根据枪口焰烟文献资料与光学测量设备的性能参数,设计了枪口焰烟光学特性外场测试详细方案。对某5.8 mm与7.62 mm口径弹道步枪的枪口焰烟光学特性进行了外场测试。测试结果表明,枪口焰烟辐射主要集中在2μm～5μm,持续时间约为6 ms,辐射能量最大值出现在2 ms附近,5.8 mm弹道步枪枪口焰烟在中波和长波的辐射强度均高于7.62 mm。枪口焰烟光学特性的测试结果为枪口焰烟的探测及武器发射药的改进提供了重要依据。