Investigation on the scattering effect of ceramic Nd:YAG

This paper investigates the scattering effect of domestic 0.5 at{\%} ceramic Nd:YAG. An effective method has been utilized to measure the scattering and absorption coefficients. An end-pumped continuous wave (CW) Nd:YAG ceramic laser was also demonstrated. A maximum output power of 6.7~W at 1064~nm was obtained at an 808-nm pump power of 32.9~W. Conversion efficiency and slope efficiency have been achieved. This indicates that scattering has an important effect on the optical performance of ceramic Nd:YAG.     

人体静电放电对有机发光二极管的影响

研究了静电放电（ESD）人体模式（HBM）下的脉冲应力对有机发光二极管（OLED）的性能及寿命的影响,并讨论了相应的物理机制。对比分析了4组OLED在施加ESD放电为0,200,800,1 600 V前后的电学和光学特性,并进行了相应的寿命测试分析。研究发现,OLED器件的光谱对ESD不敏感,随着冲击电压的增大,由于静电打击对载流子的短期抑制效应,OLED的亮度出现轻微下降。在静电冲击电压为200 V和800 V时,伏安特性没有发生变化;当静电冲击电压增至1 600 V时,反向漏电有明显增加。后续的加速寿命实验表明,静电打击对器件的工作寿命没有明显的规律性影响,但是会一定程度提高非本质老化失效的概率。     

Brewster-angle cut doubled light shutter

New types of doubled electro-optic, and low voltage controlled doubled elasto-optic light shutters containing Brewster-angle cut crystals instead of separate polarizers are investigated. Light transmission characteristics show that the devices without polarizers can give a modulation depth of about 20%.     

达旦黄-曲通X-100体系共振光散射法测定蛋白质

基于在Triton X-100存在下,蛋白质与达旦黄作用使得体系的共振光散射增强,在λ＝492 nm处光散射强度最大,增强作用的强弱与蛋白质的含量成正比,据此建立了共振光散射测定蛋白质的新方法。此方法对牛血清白蛋白的检出限达到17.7 ng·mL-1,线性范围为0.03～0.9 μg·mL-1,用于合成样与人血清样品的分析,取得了令人满意的结果。同时也研究了人血清白蛋白、鸡蛋白蛋白、溶菌酶、胰蛋白酶与达旦黄的作用。     

一个新的IEC61000-4-2标准ESD电流解析表达式

分析了两个ESD标准电流波形表达式,并提出一个新的基于脉冲函数来描述ESD标准电流的解析表达式,该表达式符合最新的标准IEC61000-4-2,在零时刻的电流及其微分部为0,且波形与实际测量波形基本吻合。     

Synthesis and characterization of thermally crosslinkable hole‐transporting polymers for PLEDs

Two new thermally crosslinkable hole‐transporting polymers, X‐PTPA and X‐PCz, were synthesized via Yamamoto coupling reactions. The number‐averaged molecular weights (M_n) of X‐PTPA and X‐PCz were found to be 45,000 and 48,000, respectively, and therewith, polydispersity indices were of 1.8 and 1.7, respectively. Thermally crosslinked X‐PTPA and X‐PCz exhibit excellent solvent resistance and stable optoelectronic properties. The UV–visible maximum absorption peaks of X‐PTPA and X‐PCz in the thin film state are at 389 and 322 nm, respectively. The HOMO levels of X‐PTPA and X‐PCz are estimated to be ?5.27 and ?5.39 eV, respectively. Multilayered devices (ITO/crosslinked X‐PTPA or X‐PCz/SY‐PPV/LiF/Al) were fabricated with SY (SuperYellow) as the emitting layer. The maximum efficiency of the multilayered device with a crosslinked X‐PTPA layer is approximately three times higher than that of the device without a crosslinked X‐PTPA layer and much higher than that of the crosslinked X‐PCz device. This result can be explained by the observations that crosslinked X‐PTPA produces increased electron accumulation within the emitter, SY, and also efficient exciton formation due to improved charge balance. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2013 , 51, 5111–5117     

Nanoassemblies with light‐responsive size and density from linear flexible polyelectrolytes

This study presents electrostatically self‐assembled nanoparticles from linear flexible polyelectrolytes (poly(diallyldimethylammonium chloride or quarternized poly(4‐vinylpyridine)) and an ionic photo‐isomerizable azo dye (Acid Yellow 38) that can change their size upon UV‐light irradiation. Assemblies with narrow size distribution are stable in aqueous solution. For samples with under‐stoichiometric dye load, UV‐light exposure triggers a size decrease, e.g. from a hydrodynamic radius of R_h = 94 nm to R_h = 62 nm for an Ay38‐PDADMAC sample with a charge ratio of l_charge = 0.7. Size changes are caused by trans‐cis isomerization of the dye, accompanied by a change in hydrophilicity, binding enthalpy and entropy. Assemblies are characterized by static and dynamic light scattering, atomic force microscopy, UV–vis spectroscopy and isothermal titration calorimetry. Zeta potential measurements give insight into the electrostatic stabilization and size‐control of the ionic nano‐assemblies, revealing a master curve of effective surface charge density versus hydrodynamic radius. © 2013 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys., 2013     

On the formation mechanism for electrically generated exciplexes in a carbazole–pyridine copolymer

Although carbazole‐containing copolymers are frequently used as hole‐transporting host materials for polymer organic light‐emitting diodes (OLEDs), they often suffer from the formation of undesired exciplexes when the OLED is operated. The reason why exciplexes sometimes form for electrical excitation, yet not for optical excitation is not well understood. Here, we use luminescence measurements and quantum chemical calculations to investigate the mechanism of such exciplex formation for electrical excitation (electroplex formation) in a carbazole–pyridine copolymer. Our results suggest that the exciplex is formed via a positively charged interchain precursor complex. This complex is stabilized by interactions that involve the nitrogen lone pairs on both chain segments. © 2011 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2012     

Light level control in birefringent fibres through thermal stress effects caused by the absorption of broadside incident light: a single-ended fibre-optic system

In this paper, light level control is demonstrated using optically induced thermal stress effects in a polarization-maintaining optical fibre. The controlling light beam is absorbed by a blackened segment of the fibre and produces local heating. Light control is demonstrated in the single-ended sensor configuration, which displays a response that cannot be explained from phase delays only, but requires the addition of the coupled mode theory.