A Water Sensitive Hydrate: The Bis‐Catena Complex Salt [Mn(H2O)6][BiI4]2·2H2O

Bright red crystals of [Mn(H₂O)₆][BiI₄]₂ · 2H₂O are obtained from a solution of MnI₂, BiI₃, and I₂ in absolute ethanol, which is exposed to humid air. Reversible dehydratization sets in at about 50 °C. Added water decomposes the hydrate by irreversible precipitation of BiOI. The optical bandgap is about 1.9(1) eV. X‐ray diffraction on a single‐crystal revealed a monoclinic lattice (space group P2₁/c) with a = 760.39(4) pm, b = 1315.6(1) pm, c = 1398.37(7) pm, and β = 97.438(4)°. In the crystal structure zigzag chains of edge‐sharing [BiI_2/1I_4/2]^– octahedra and linear strings of H₂O‐bridged [Mn(H₂O)₆]²⁺ octahedra run parallel [100].     

三相中空纤维液相微萃取在羟基苯甲酸类化合物分析中的应用

在优化的三相中空纤维液相微萃取(3p-HFLPME)条件下,研究了6种羟基苯甲酸类化合物(HBAs)的3p-HFLPME行为;揭示了HBAs的富集因子(EF)与其正庚醇/水条件分配系数(log Pn-heptanol/5 mmol/L HCl)、pKa和羟基数目(N)的相关性,初步阐明了聚偏氟乙烯中空纤维对HBAs的电荷转移传递机理以及有机溶剂对HBAs的选择性萃取机理。优化的3p-HFLPME条件: 以MOF 503聚偏氟乙烯中空纤维为有机溶剂支持体,正庚醇为有机相,5 mmol/L HCl体系为给体,80 mmol/L NH3·H2O为接受相,搅拌速度为1200 r/min,萃取35 min。该方法的精密度（以相对标准偏差计）小于3%,检出限为0.09~30.00 μg/L,加标回收率为93.3%~107.1%,HBAs质量浓度为5 mg/L时的富集因子最高达107.6倍。     

两个修正的分子连接性指数用于有机物反磁磁化率的改进QSPR研究

为了预测有机物的摩尔反磁磁化率,基于分子图的连接矩阵和可变的原子价连接性指数δi’提出了一种可变的分子连接性指数mχ’ 及其逆指数mχ”。包含在δi’、 mχ’ 和mχ”定义式中的三个可变参数x、 a和y的最佳值可通过优化方法得到。当x=2.9、a=1.10、y=0.36时, 通过最佳子变量集合法可以构建一个良好的5参数模型。对721个有机物（训练集）,该模型的相关系数r、标准偏差s和平均绝对偏差分别是0.9930、4.96 cgs和3.74cgs。交叉验证说明,从统计学角度该模型具有良好的稳定性。另外该模型对另外360个有机物（测试集）摩尔反磁磁化率预测结果的平均绝对偏差为4.37cgs。结果表明本文的方法在预测有机物摩尔反磁磁化率方面比文献方法更有效。多元线性方法能得到比较理想的预测有机物摩尔反磁磁化率的模型。     

Online process control of acidic texturisation baths with ion chromatography

Etching of silicon with mixtures of hydrofluoric acid and nitric acid is a widely used process in silicon solar cell fabrication. One precondition for an optimized usage of the acidic etching baths is the exact knowledge of the chemical bath composition. In this paper, we investigated a fast and online-capable method for the total analysis of all bath constituents by ion chromatography. The chromatographical system consists of a low-volume injection valve, which injects the concentrated samples directly into the KOH-based eluent. After separation and detection of nitrate and fluoride, a post-column derivatization with sodium molybdate is applied to detect the hexafluorosilicic acid, which enriches in the texturisation bath during the etching process. The results of the presented approach are discussed and compared with already published chromatographical and titration methods found in literature.     

有机-无机复合物[Cu（en）（H_2O）（2,2-′bipy）]_2H_3[BW_（12）O_（40）]·2.5H_2O的水热合成、结构及性质

利用水热合成方法制备了组成为[Cu（en）（H2O）（2,2′-bipy）]2H3BW12O4.02.5H2O的多金属氧簇有机-无机复合物,并用元素分析、IR和UV光谱、XPS、TG、荧光光谱、X射线单晶衍射对化合物进行了表征和性质研究.该化合物属于单斜晶系,P2（1）/c空间群,a=1.951 1（2）nm,b=1.229 76（12）nm,c=2.505 9（3）nm,β=91.266（2）°,V=6.011 1（11）nm3,Z=4.化合物阴离子[BW12O40]5-与配位阳离子[Cu（en）（H2O）（2,2′-bipy）]＋通过静电作用相结合.XPS表明化合物中Cu、W氧化态分别为＋1和＋6价.     

钴配合物[Co_2(H_2O)_8(C_(10)H_8N_2)_2]·(HO_3PCH_2CH_2SO_3)(SO_4)(H_2O)_4的合成与晶体结构研究

用硫酸钴、4,4'-联吡啶和2-磺酸基乙基膦酸合成了一个新颖的钴化合物:[Co_2(H_2O)_8(C_(10)H_8N_2)_2]·(HO_3PCH_2CH_2SO_3)(SO_4)(H_2O)_4,并对其进行了红外.元素分析、热重测试,通过单晶衍射仪测定了其晶体结构.结果表明,配合物属单斜晶系C2/c空间群,分子式为C_(22)H_(45)Co_2N_4O_(22)PS_2,分子量为930.57,晶胞参数为a=19.8456(18),b=11.2957(10),c=34.719(3)(A),β=106.095(3)°,晶胞体积为7477.9(12)(A)~3,Z=8,Dc=1.653 g/cm~3,F(000)=3856,μ=1.131 mm~(-1),最终残差因子R_1=0.0726,wR_2= 0.1719(相对于5612个I>2σ(I)的可观测衍射点).在这个化合物中,二齿配体4,4'-联吡啶把Co(II)桥连成[Co(4,4'-bipy)]~(2+)链.化合物中的[Co(4,4'-bipy)]~(2+)链有三个不同的朝向.2-磺酸基乙基膦酸没有参与配位而是做为一个有机模板剂填充在[Co(4,4'-bipy)]~(2+)链形成的空隙中.     

反相微乳液助水热法可控合成FeNi3合金纳米结构

利用水热法处理表面活性剂/正辛烷/正己醇/水四元微乳体系成功合成FeNi3合金纳米结构. 通过改变表面活性剂的用量和类型来调控产物粒径与形貌. 当表面活性剂为聚乙二醇4000(PEG4000)时, 产物为球状, 粒径约为75 nm. 当表面活性剂为十六烷基三甲基溴化铵(CTAB)时, 产物为海胆状.单个海胆状颗粒是由许多纳米棒构成, 其直径约为42 nm, 长度为0.4-1.2 μm. 利用X射线粉末衍射(XRD), 穆斯堡尔谱, 扫描电子显微镜(SEM), 透射电子显微镜(TEM), 选区电子衍射(SAED), 多功能磁天平(MMVFTB)等测试手段对产物的组成、形貌和磁性能进行了表征. 球状和海胆状的FeNi3样品在室温下呈现典型的铁磁性特征, 其饱和磁化强度(Ms)值分别为114.4和97.4 emu·g-1, 矫顽力(Hc)值分别为94.0和329.0 Oe.     

Morphological and phase evolution of TiO2 nanocrystals prepared from peroxotitanate complex aqueous solution: Influence of acetic acid

Nanosized anatase and rutile TiO₂ having different shape, phase and size have been prepared from aqueous solutions of peroxo titanium complex starting from titanium(IV) isopropoxide (TTIP), acetic acid and hydrogen peroxide (H₂O₂) in water/isopropanol media by a facile sol-gel process. The TiO₂ nanocrystals are characterized by powder X-ray diffraction (XRD), Raman spectroscopy, FT-IR spectroscopy, TEM, high resolution transmission electron microscopy (HRTEM) and selected area electron diffraction (SAED) techniques. The influence of pH and the sequence of addition of reaction contents on the phase and morphology of TiO₂ are studied. The reasons for the observation of only anatase and/or mixture of anatase and rutile are given.     

X-ray crystallographic structure and physical properties of the pentacoordinated [TPAFeCl] complex

A new pentacoordinated ferrous compound [TPAFeCl]⁺ (TPA = tris(2-pyridylmethyl)amine) was synthesized from the reaction between H₃TPA(ClO₄)₃ and Fe(PⁿPr₃)₂Cl₂ in MeCN. The unique trigonal bipyramidal [TPAFeCl]⁺ complex was characterized as a S = 2 high spin complex based on the crystallographic structure, magnetic susceptibility, ¹H NMR spectrum and semi-empirical ZINDO/S calculations. Crystal of [TPAFeCl]₂(FeCl₄)(MeCN)₂ was monoclinic with a = 12.019(2) Å, b = 27.550(5) Å, c = 14.138(2) Å, β = 94.168(3)°, V = 4668.9(13) Å³, space group C/c, and the unit cell contained a racemic mixture of Δ and Λ isomers with ferrous tetrachloride anion.     

Perchloric Acid–Silica (HClO4⋅SiO2)‐Catalyzed Synthesis of 14‐Alkyl‐ or 14‐Aryl‐14H‐dibenzo[a,j]xanthenes and N‐[(2‐Hydroxynaphthalen‐1‐yl)methyl]amides

The synthesis of 14‐aryl‐ or 14‐alkyl‐14H‐dibenzo[a,j]xanthenes 3 involving the treatment of naphthalen‐2‐ol ( 1 ) with arenecarboxaldehydes or alkanals 2 in the presence of HClO₄?SiO₂ as a heterogeneous catalyst was achieved (Table 1), and this reaction was extended to the preparation of N‐[(2‐hydroxynaphthalen‐1‐yl)methyl]amides 5 by a three‐component reaction with urea ( 4a ) or an amide 4b – d as a third reactant (Table 2).