CO2部分氧化乙烷制乙烯Pd—Cu／MoO3—SiO2催化剂的研究

用化学吸附－红外光谱、化学吸附－程序升温脱附（ＴＰＤ）和微型反应技术研究了Ｐｄ－Ｃｕ／ＭｏＯ３－ＳｉＯ２（ＭｏＳＯ）催化剂对ＣＯ２和乙烷的吸附活化和部分氧化反应性能．结果表明，乙烷以Ｃ—Ｈ键中的Ｈ吸附于ＭｏＳＯ载体表面ＭｏＯ键的端基氧上；Ｐｄ－Ｃｕ／ＭｏＳＯ催化剂对ＣＯ２有良好的化学吸附活化性能，ＣＯ２的吸附除有线式吸附态和剪式吸附态外，还有一种新的卧式吸附态；Ｐｄ－Ｃｕ／ＭｏＳＯ催化剂的晶格氧参与了化学反应．探讨了在Ｐｄ－Ｃｕ／ＭｏＳＯ催化剂上ＣＯ２的部分氧化乙烷反应机理     

偏最小二乘光度法同时测定铜和铁的研究及应用

７－（１－苯偶氮）－８－羟基喹啉－５－磺酸钠在ＰＨ＝４．７５ＨＡｃ－ＮａＡｃ缓冲溶液中能与Ｃｕ（Ⅱ）和ＦＥ（Ⅲ）形成稳定的络合物，本文研究了Ｃｕ（Ⅱ）－ＰＡＨＱＳ、Ｆｅ（Ⅲ）－ＰＡＨＱＳ体系的显色条件，以偏最小二乘法处理两者重叠吸收峰，建立了光度法同时测定铜和铁的方法。     

Sol-Gel Preparation and Photoelectrochemical Properties of Fe2TiO5 Thin Films

Polycrystalline Fe₂TiO₅ films were prepared on nesa silica glass substrates by the sol-gel method, and their photoanodic properties were measured in a three-electrode wet cell with an aqueous buffer solution of pH = 7. Gel films were crystallized into Fe₂TiO₅ when fired at 500°C. The photoanodic current significantly increased when the films were fired at 700°C, and then decreased with increasing firing temperature. Thicker films obtained by repeating the gel film deposition and firing showed smaller photocurrent, and the 50 nm thick film prepared via non-repetitive deposition exhibited the maximum photocurrent. Although the photoresponse was extended to wavelengths near 500 nm, the maximum quantum yield was as low as 0.12 at a wavelength of 340 nm.     

Dehydrogenation of methanol on low Cu and Re—Cu catalysts supported on sibunite

The activity and selectivity of mono- and bimetallic catalysts containing copper and rhenium on sibunite were studied in the decomposition of methanol to methyl formate (MF), water, H₂, CO, and CO₂at 200—400 °C. Methane is also formed on rhenium-containing catalysts at 300—400 °C. The dehydrogenating activity and selectivity to form MF are higher on the copper-sibunite catalysts than on the rhenium-sibunite samples. The introduction of 0.25% Re into the 4% copper-containing catalyst enhances its total activity and stability.     

Electronic structure of the Fe3S4 cluster and its quasi-aromaticity

The localized molecular orbitals and their energy levels for the clusters [Fe₃S₄(SH)₃]^2–, [(HS)₃Fe₃S₄·Ni(PH₃)]^2–, [Mo₃S₄(OH₂)₉]⁴⁺, and [Mo₃S₄·Ni]⁴⁺ have been calculated by mean of the Edmiston-Ruedenberg energy localization technique under the CNDO/2 approximation in order to reveal the resemblance between [Fe₃S₄]⁺ and [Mo₃S₄]⁴⁺ in the geometrical configurations and the addition reactivities with heterometal atoms. It is shown that in these two cluster species with core {M ₃(₃-S)(-S)₃} of similar structure (M = Mo, Fe) there exist three synergically connected three-centered two-electron (M-S-M) -bonds around the puckered six-membered {M₃S₃} rings on account of delocalization of a lone electron pair on each bridging S atom; these (M-S-M) -bonds are thus capable of forming cubane-like heterometal clusters with intruder metal atoms through the ( M) bonding. It is therefore seen that unlike the [Mo₃S₄]⁴⁺ with appreciable bonding between the Mo atoms, the extra d-electrons on the metal atoms in the [Fe₃S₄]⁺ cluster are localized on the Fe atoms, exhibiting an electronic structure significantly different from that of the [Mo₃S₄]⁴⁺ cluster.     

Kinetics of the Formation of Goethite in the Presence of Sulfates and Chlorides of Monovalent Cations

The synthesis of goethite by oxidation of Fe²⁺in presence of metallic iron was undertaken in an aqueous medium containing indifferent salts such as Na₂SO₄, (NH₄)₂SO₄, NaCl, and NH₄Cl. Temperature and bubbling air rate were maintained, respectively, at 70°C and 1 L/min. The influence of anions and cations on the kinetics of each step of the process has been followed distinctly, the iron dissolution rate has been determined by the variation of the medium acidity, and the precipitation of goethite has been determined by gravimetric measurements. With respect to Cl⁻, the SO₄²⁻anion decreases the rate of the two reactions. NH₄⁺acts as an inhibitor when it is present at low concentrations and as an accelerator for higher concentrations; the limit corresponding to the change of NH₄⁺behavior depends on the nature of the counter ion. The reaction product is composed of pure goethite in the presence of sulfate salts, whereas a mixture of goethite and lepidocrocite, respectively, 60–70 and 40–30%, was observed in the presence of chloride salts.     

Solid Phase Extraction and Simultaneous Spectrophotometric Determination of Trace Amounts of Copper and Iron Using Mixture of Ligands

 A novel sensitive and simple method for rapid and selective extraction, preconcentration and determination of iron (as its bathophenanthroline complex) and copper (as its neocuproine complex) using octadecyl silica cartridges and dual wavelength spectrophotometry is presented. The dual wavelength method (533 nm for the iron-bathophenanthroline and 454 nm for the copper-neocuproine as the analytical wavelength) is used to eliminate spectral interferences. Extraction efficiency and the influence of flow rates of sample solution and eluent, pH, amount of neocuproine, bathophenanthroline and hydroxylamine hydrochloride, type and least amount of eluent for elution of iron and copper complexes from cartridge, break-through volume and limit of detection are evaluated. The effects of various cationic and anionic interferences on percent recovery of iron and copper are also studied. Extraction efficiencies >95% are obtained by elution of cartridges with minimal amount of organic solvent. Iron and copper were determined in the range of 3–100 ng mL⁻¹. The limits of detection are 0.98 and 1.13 ng mL⁻¹ for iron and copper, respectively. The proposed method is applied successfully to the determination of both analytes in river, tap and well water samples. Author for correspondence. E-mail: yyamini@modares.ac.ir Received September 18, 2002; accepted December 12, 2002 Published online May 5, 2003     

Selective Formation of Spinel Iron Oxide in Thin Films by Complexing Agent-Assisted Sol-Gel Processing

The structure of iron oxide was controlled by regulating the hydrolytic polymerization of aquo iron complexes with organic polydentate ligands such as diols. Iron oxides were prepared by calcining the precursor polymers obtained from iron nitrate nonahydrate and diols. When the diols were 1,2-pentanediol, 1,2-hexanediol and 1,2-octanediol, α-Fe₂O₃ with corundum structure appeared exclusively or as the main crystalline phase, in spite of the amount of diol used and the calcination temperature. In the case of 1,2-decanediol and 1,2-dodecanediol, when five moles of the diols were used to one mole of iron nitrate and the calcination temperatures were below 400°C, ψ-Fe₂O₃ with spinel structure appeared as the main phase and, when less than five moles of the diols were used, α-Fe₂O₃ appeared exclusively or as the main phase, irrespective of the calcination temperature. This tendency was also observed in thin films. Thus, a transparent magnetic film composed of γ-Fe₂O₃ could be prepared by applying a benzene solution of the iron polymer, obtained with 5 equivalents of 1,2-decanediol, on quartz and calcining the gel film at 350°C.     

Application of thermomagnetometry to corrosion studies of archaeological iron

Summary Thermomagnetometry has been applied to mineralized archaeological iron samples and samples from accelerated corrosion tests. It has successfully quantified the degree of corrosion, measured by the loss of iron, as well as the amount of magnetite formed and water held in the corrosion and adhered soil layers. Thermomagnetometry, thermogravimetric analysis and differential scanning calorimetry have been applied to the reported corrosion products from archaeological iron. Fourier transform infra-red and Raman spectroscopies and X-ray diffraction analyses were undertaken on the residues and at intermediate heating stages, where the thermal analyses indicated, to identify the reaction products.     

Carbonylation of Benzyl Halides Over Two-Phase Catalyst of Iron Pentacarbonyl

Carbonylation of benzyl halides to phenylacetic acid was studied in a two-phase system with iron pentacarbonyl as the catalyst precursor. The solutions consisted of a benzyl halide and iron pentacarbonyl in benzene and tetrabutylammonium hydrogen sulfate in aqueous sodium hydroxide. Stirring under carbon monoxide readily produced phenylacetic salts in aqueous phase which were then acidified and extracted with ether. The yields of phenylacetic acid from benzyl iodide and from benzyl bromide were similar at a evel of about 50percnt;, that of the latter being higher by 1%. The yield from benzyl chloride was far less, at a level of only 21%. The rate as studied with gas chromatography was found to decrease in the order benzyl iodide>benzyl bromide>benzyl chloride.