纤维素基磁性聚偕胺肟树脂的研究——锌副族金属离子在树脂上的吸附

研究了Ｚｎ２＋、Ｃｄ２＋、和Ｈｇ２＋离子在碱式纤维素基磁性聚偕胺肟树脂（ＢＭＡＯ）上的吸附动力学。结果表明，吸附速度受粒内扩散所控制。测得粒内扩散系数分别是１．２２×１０－４、２．４２×１０－４和３．９０×１０－４ｃｍ２·ｓ－１；Ｈｇ２＋离子在树脂上的吸附行为符合Ｆｒｅｕｎｄｌｉｃｈ和Ｌａｎｇｍｕｉｒ等温吸附方程；浓集因数随Ｈｇ２＋离子浓度降低而上升，有利于从稀溶液中除去Ｈｇ２＋离子。将树脂加至Ｚｎ２＋、Ｃｄ２＋或Ｈｇ２＋离子浓度为５０ｐｐｍ的溶液中，离子去除率分别是９６．１、９９．９和９９．３％。     

Sonoelectroanalysis: investigation of bismuth-film-modified glassy carbon electrodes

Bismuth-modified glassy carbon electrodes have been investigated for their suitability in sonoelectroanalysis. The stability of the bismuth film to the application of ultrasound was assessed via voltammetric and atomic force microscopy (AFM) studies which revealed little ablation at powers up to an intensity of 130 W cm^–2 delivered from a 25-kHz sonic horn. Furthermore, bismuth-film-modified glassy carbon electrodes were evaluated for the sonoelectroanalytical quantification of zinc and cadmium. Detection limits of 2×10^–7 M and 6×10^–9 M respectively were found after a 60-s deposition time via an acoustically assisted deposition protocol.     

高血压类风湿症疗效与锌,钙关系初探

以临床典型病案为例，探讨了中医中药传统理论和现代微量元素研究的关系，重点讨论了向量元素锌、宏量元素钙与高血压、风湿症的病因病机和治疗关系。     

Retention, kinetics and thermodynamics profile of cadmium adsorption from iodide medium onto polyurethane foam and its separation from zinc bulk

The sorption behaviour of 2.5 × 10⁻⁵ M solution of Cd(II) on polyurethane foam (PUF) from iodide medium have been investigated. The conditions were optimized from aqueous solutions of different pH (1-10) and of acids of varied concentration (0.01-1.0 M). The maximum concentration of KI was found to be 0.24 M and equilibration time was established to be 20 min. The data successfully followed the Freundlich and Dubinin-Radushkevich (D-R) isotherms at low metal ion concentration while Langmuir isotherm followed at higher metal ion concentration. The Freundlich parameter 1/n = 0.66 ± 0.02 have been evaluated whereas D-R isotherm yields the sorption free energy E = 10.5 ± 0.1 kJ mol⁻¹ indicating ion exchange type chemisorption. The monolayer coverage (XL) constant of Langmuir isotherm was found to be 23.7 ± 0.4 mg g⁻¹. The numerical values of thermodynamics parameters enthalpy (ΔH), entropy (ΔS) and Gibbs free energy (ΔG) indicated the endothermic and spontaneous nature of sorption. The Scatchard plot analysis was tested to evaluate the binding sites of the PUF and stability constants of sorption were determined. On the basis of these parameters, the sorption mechanism was discussed. Among the foreign ions tested, Pb(II), Hg(II), cyanide and nitrite should be absent. The clean separation of Cd(II) from Zn(II) ions in the ratio 1:250, respectively, was achieved by column chromatography.     

Zinc-catalyzed Williamson ether synthesis in the absence of base

Zinc powder was found to be a highly efficient catalyst for the synthesis of aromatic ethers using microwave heating in the presence of N,N-dimethylformamide as well as under stirring in an oil-bath using tetrahydrofuran as solvent without any inorganic base. This method can be used for selective mono-, di- or tri-O-alkylations.     

微量元素锌促进儿童生长发育临床研究

报道以微量元素锌治疗缺锌患儿１１８例并与１１４例作对照观察．结果发现，衡量生长发育与营养的敏感指标：身高、体重、血清白蛋白及血色素等参数，治疗组比对照组都显著提高（Ｐ值＜０．０１）．证明锌制剂对缺锌儿童有显著的促进生长发育及改善营养状态作用，作者并对锌的作用机理作了论述．     

Zinc(II) and Cadmium(II) Complexes of the 3‐(2‐Pyridyl)‐5,6‐diphenyl‐1,2,4‐triazine (PDPT) Ligand,Structural Studies of [Zn(PDPT)2Cl(ClO4)] and [Cd(PDPT)2(NO3)(ClO4)]

Two new mixed‐anion zinc(II) and cadmium(II) complexes of 3‐(2‐pyridyl)‐5,6‐diphenyl‐1,2,4‐triazine (PDPT) ligand, [Zn(PDPT)₂Cl(ClO₄)] and [Cd(PDPT)₂(NO₃)(ClO₄)], have been synthesized and characterized by elemental analysis, IR‐ and ¹H NMR spectroscopy. The single crystal X‐ray analyses show that the coordination number in these complexes is six with four N‐donor atoms from two “PDPT” ligand and two of the anionic ligands, ZnN₄ClO_perchlorate, CdN₄O_nitrateO_perchlorate. Self‐assembly of these compounds in the solid state via π–π‐stacking interactions is discussed.     

Determination of manganese and zinc in powdered chocolate samples by slurry sampling using sequential multi-element flame atomic absorption spectrometry

In the present work, a slurry sampling flame atomic absorption spectrometric method to determine directly manganese and zinc in powdered chocolate samples is proposed. The optimization step was performed using univariate methodology involving the following factors: nature and concentration of the acid solution, sonication time, and particle size. The established conditions led to the use of a sample mass of 150 mg, 2.0 mol L^− 1 nitric acid solution, sonication time of 15 min, and a slurry volume of 50 mL. This method allows the determination of manganese and zinc with detection limit of 52 and 61 ng g^− 1, respectively, and a precision expressed as relative standard deviation (RSD) of 2.6% and 3.2% (both, n = 10) for contents of manganese and zinc of 52.4 and 100.0 μg g^− 1, respectively. The proposed method was applied for determination of manganese and zinc in five powdered chocolate samples. In these, the manganese content varied from 42.8 to 52.7 and from 88.6 to 102.4 μg g^− 1 of zinc. The analytical results were compared with the results obtained by analysis of these samples after digestion using open vessel and acid bomb digestion procedures and determination using FS-FAAS. The statistical comparison by t-test (95% confidence level) showed no significant difference between these results.     

Phosphaniminato-Komplexe von Cobalt und Zink mit Heterocubanstruktur. Die Kristallstrukturen von [CoI(NPMe3)]4 und [ZnI(NPMe3)]4

Phosphoraneiminato Complexes of Cobalt and Zinc with Heterocubane Structure. Crystal Structures of [CoI(NPMe₃)]₄ and [ZnI(NPMe₃)]₄ The title compounds have been prepared from CoI₂ and ZnI₂, respectively, and Me₃SiNPMe₃ by fusion reactions at 180°C in the presence of sodium fluoride. They crystallize from dichloromethane as dark green (Co) or colourless (Zn) single crystals including three molecules CH₂Cl₂ per formula unit, which were characterized by crystal structure determinations. [CoI(NPMe₃)]₄ · 3 CH₂Cl₂: Space group P3m1, Z = 2, structure solution with 2376 independent reflections, R = 0.033. Lattice dimensions at ?50°C: a = b = 1455.8, c = 1270.5 pm. [ZnI(NPMe₃)]₄ · 3 CH₂Cl₂: Space group P3m1, Z = 2, structure solution with 2197 independent reflections, R = 0.043. Lattice dimensions at ?60°C: a = b = 1454.9, c = 1270.5 pm. Both complexes are isostructural with one another. They form heterocubane structures in which the metal atoms are linked via μ₃-N-bridges of the phosphoraneiminato groups with M₄N₄ bridge-type bond angles close to 90°.     

Quantitative separation of zinc traces from cadmium matrices by solid-phase extraction with polyurethane foam

A system for separation of zinc traces from large amounts of cadmium is proposed in this paper. It is based on the solid-phase extraction of the zinc in the form of thiocyanate complexes by the polyurethane foam. The following parameters were studied: effect of pH and of the thiocyanate concentration on the zinc extraction, shaking time required for quantitative extraction, amount of PU foam necessary for complete extraction, conditions for the separation of zinc from cadmium, influence of other cations and anions on the zinc sorption by PU foam, and required conditions for back extraction of zinc from the PU foam. The results show that zinc traces can be separated from large amounts of cadmium at pH 3.0±0.50, with the range of thiocyanate concentration from 0.15 to 0.20 mol l⁻¹, and the shaking time of 5 min. The back extraction of zinc can be done by shaking it with water for 10 min. Calcium, barium, strontium, magnesium, aluminum, nickel and iron(II) are efficiently separated. Iron(III), copper(II) and cobalt(II) are extracted simultaneously with zinc, but the iron reduction with ascorbic acid and the use of citrate to mask copper(II) and cobalt(II) increase the selectivity of the zinc extraction. The anions nitrate, chloride, sulfate, acetate, thiosulphate, tartarate, oxalate, fluoride, citrate, and carbonate do not affect the zinc extraction. Phosphate and EDTA must be absent. The method proposed was applied to determine zinc in cadmium salts using 4-(2-pyridylazo)-resorcinol (PAR) as a spectrophotometric reagent. The result achieved did not show significant difference in the accuracy and precision (95% confidence level) with those obtained by ICP–AES analysis.