氧化锰团簇粒子在有序多孔氧化锆孔道中的组装及其特殊性能研究

利用醇溶液浸渍法及后续的热处理工艺成功实现了氧化锰团簇粒子在有序多孔氧化锆孔道中的组装，借助XRD，TEM，UV-vis，EPR以及O~2-TPD等分析手段进行样品结构表征及性能分析。研究表明，氧化锰团簇粒子能比较均匀地分散于规则的孔道中；团簇粒子的生长随着热处理温度的提高受到孔道大小的限制；孔道中的氧化锰团簇粒子能显示出与较大尺寸氧化锰粒子完全不同的强顺磁信号，并且还具有优异的表面氧吸附特性。     

Thermal behavior of short-range-order in quenched Cu-12 at% Mn assessed by DSC

Summary The ordering behavior of quenched Cu-12 at% Mn was investigated by differential scanning calorimetry (DSC) under increasing temperature conditions. The ordering process can be better explained in terms of a homogeneous short-range-order (SRO) rather than a disperse-short-range-order (DSRO) model as for concentrated Cu-γMn solid solutions. At the employed high quench rates ordering is established in one stage here termed stage 1, assisted by excess vacancies. This stage obeys a first order kinetics law, being the effective activation energy consistent with a weighed average sum of the activation energy for migration of free and bound vacancies. An estimated solute-vacancy binding energy of 15 kJ mol^-1 seems quite reasonable for this alloy together with the assessed activation energy for complex migration of 92.6 kJ mol^-1. By adopting a first SRO order parameter based in quasi-chemical theory in pair approximation and using boundary values calculated from displayed features of DSC traces, the retained degree of quenched-in order at room temperature was calculated. This procedure also enabled to estimate an ordering energy of -2.7 kJ mol^-1. The effect of quenching temperature demonstrate that for smaller vacancy sink densities, the retained degree of order at room temperature goes through a minimum.     

Excess molar enthalpy of binary mixtures of hexane+ethyl benzene, <Emphasis Type="Italic">o</Emphasis>-xylene, <Emphasis Type="Italic">m</Emphasis>-xylene and <Emphasis Type="Italic">p</Emphasis>-xylene at 298.15 K

Summary This paper reports excess molar enthalpies of the binary systems hexane+ethyl benzene, hexane+o-xylene, hexane+m-xylene and hexane+p-xylene at 298.15 K and atmospheric pressure, over the whole composition range. The data was measured directly using a Calvet microcalorimeter. The excess magnitude was correlated to a Redlich-Kister type equation for each mixture. Also, we will discuss the results for the four mixtures studied here and by comparison with the same binary systems but containing propyl propanoate as first component. Finally, we will correlate our results with the Nitta-Chao and the three UNIFAC theoretical approximations.     

纤维素基磁性聚偕胺肟树脂的研究——循环吸溴中吸附与还原能力的变化

研究了酸式纤维素基磁性聚偕胺肟树脂（ＡＭＡＯ）在循环吸溴过程中吸附容量和还原能力的变化，发现原树脂的吸溴初速和溴的还原率比再生树脂高一倍以上，但第一次和第二次再生树脂的吸附速度和还原效率几乎相同，暗示着树脂吸溴后基本结构已发生了彻底的变化．树脂在循环使用时吸溴容量变化不大而溴的还原量却显著降低，表明ＡＭＡＯ作为吸溴剂有较高的实用价值．     

铑（Ⅲ）与2—（3,5—二氯—2—吡啶偶氮）—5—二甲氨基苯胺络合物的催化氢波

本文提出一种新的测定铑的催化氢波体系.先使Rh(Ⅲ)与3,5-diCl-PADMA在HAc-NaAc缓冲溶液中生成稳定的络合物,再以适量HclO_4将溶液酸化后进行极谱测定。利用正交试验法确定体系的最佳分析条件为:0.05 mol/L pH5.0的HAc-NaAc,1.6×10~(-5)mol/L3,5-diCl-PADMA,沸水浴加热15min.,4.4 mol/L HCIO4酸化。在此条件下的线性范围为1.9×10~(-11)～3.9×10~(-9)mol/L,检出限达5.8×10~(-12)mol/L。大量Cu(Ⅱ)、Ni(Ⅱ)、Fe(Ⅲ)及Co(Ⅱ)对体系的干扰可用EDTA消除。研究了催化波的性质,表明该波为Rh(Ⅲ)与3,5-diClPADMA络合物的催化氢波。     

Improvement of direct determination of Cu and Mn in seawater by GFAAS and total elimination of the saline matrix with the use of hydrofluoric acid

Hydrofluoric acid, added to seawater, can assist in the removal of chloride in the drying step by precipitating fluoride salts, thus suppressing the chloride interference effects induced on the atomization signals of Cu and Mn. By adding HF to seawater before the analysis, MgF₂ and CaF₂ are precipitated at the bottom of the sampling flask, without precipitating Cu and Mn, and are consequently not introduced into the graphite furnace. Because sodium salts are eliminated at the pretreatment step, the whole seawater matrix is eliminated before the atomization of Cu or Mn. Therefore, the analyzed volume of seawater can be increased by using the multi-injection procedure without degradation of the limit of detection and risks of spectral interferences. The limit of detection obtained for Cu and Mn are 0.05 and 0.01 μg L⁻¹, respectively, for a 50 μL analyzed seawater volume.     

Ce0.6Zr0.35Y0.05O2和Pr0.6Zr0.35Y0.05O2催化剂表面上CO氧化和18O-16O交换反应的研究

测定了在Ce0.6Zr0.4O2,Ce0.6Zr0.35Y0.05O2,Pr0.6Zr0.4O2和Pr0.6Zr0.35Y0.05O2 (分别表示为CZ,CYZ,PZ和PYZ)样品表面上的CO氧化反应和18O-16O 同位素交换反应.结果表明: 在CZ和PZ系列固熔中掺杂Y3 离子可以改善晶格氧的迁移速度;PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.其原因是将Y3 掺杂到Ce0.6Zr0.4O2 或Pr0.6Zr0.4O2晶格中,增加了样品的氧空位浓度,从而提高了晶格氧的迁移性质,而PrOx比CeO2具有更低温度的氧化还原性质,因此PZ和PZY的晶格氧比CZ 和CZY 的晶格氧具有更高的氧化反应活性.     

K-Mo基催化剂的表面酸性与其合成醇选择性

对500℃和800℃焙烧制得的氧化态K－MoO3／γ－AlO3，K－MoO3／SiO2及非负载K－Mo催化剂进行硫化后，测试其合成醇活性．结果表明500℃焙烧制得的负载型催化剂显示较高的合成低碳烃活性和较低的合成低磷醇选择性，经800℃焙烧后，合成低磷醇的选择性大幅度提高．500℃焙烧的非负载K－Mo催化剂显示较高的合成醇选择性，经800℃焙烧后，促碳醇的选择性保持不变．用氨的吸附及TPD方法测定了各样品的酸性，并与催化剂活性对照，发现催化剂酸性越强，酸量越大，则其合成醇选择性越低．催化剂上的乙醇分解实验证实，催化剂的酸量大小与它的醇分解活性成正变关系，这些结果说明催化剂酸性对其合成醇性能有直接的影响．     

STUDY OF Cu-Mu CATALYST FOR THE SYNTHESIS OF METHYL FORMATE AND METHANOL FROM SYNTHESIS GAS

将一种新型的ＣｕＭｎ催化剂用于由合成气合成甲酸甲酯和甲醇，该催化剂表现出良好的反应活性和甲酸甲酯选择性。考察了反应温度、合成气压力及催化剂制备方法等对合成甲酸甲酯和甲醇的反应活性及选择性的影响。在反应条件下，产物收率最高达６０．１０ｇ／（Ｌ·ｈ），产物甲酸甲酯的选择性很高。用ＢＥＴ、ＸＲＤ及ＸＰＳＡｕｇｅｒ等测试方法对催化剂的比表面、晶相组成以及铜、锰在催化剂中的价态进行了表征，并探讨了催化剂失活的原因。     

X-射线荧光光谱法测定钛铁中的硅、锰、磷、铝

介绍用X-射线荧光光谱仪测定钛铁中Si、Mn、P、Al含量的方法,通过试验确定了合适的研磨时间、压力和保压时间,用压片法制样,建立了各元素的工作曲线,各元素的测定范围分别为Si3.00%～6.00%,Mn1.00%～3.00%,P0.030%～0.070%,Al5.00%～9.00%。通过强度测量得到测定Si、Mn、P、Al的相对标准偏差分别为0.074%、0.308%、0.383%、0.040%,精密度满足测试要求。将该方法测定结果与化学法比对,准确度满足国家标准方法分析误差的要求。