Chlorination of α-sulfonyl carbanions with hexachloroethane: A novel preparation of α-halosulfones

The cyclic sulfones1,2, and3 are lithiated in benzene with n-butyllithium. Lithiation is demonstrated to lead to α-mono, α,α′-di and/or α,α-di and α,α,α′ trimetallation. The lithiated sulfones are chlorinated with hexachloroethane (HCE). Some mechanistic aspects of the reaction of the lithiosulfones with vicinal dihalides are discussed.     

Solvolytic behaviour and the solubilities of various inorganic compounds, lewis acids and bases in fused monobromo acetic acid solvent system—II

Solubilities and the solvolytic behaviour of various inorganic compounds, Lewis acids and bases in fused monobromoacetic acid at 60 ± 0.5°C are discussed. Ionic compounds are fairly soluble, iodides and thiocyanates being comparatively more soluble than chlorides and bromides. Tetraalkyl ammonium halides are highly soluble in this solvent. Conductometric and spectroscopic studies of various Lewis acids and bases in fused monobromoacetic acid indicate their solvolytic behaviour and their subsequent ionization. The solvolyses products BBr₃·CH₂BrCOOH and SbCl₅·CH₂BrCOOH have been observed to be the strongest Bronsted acids. Auto-ionization of this solvent has been supported by acid/base titrations.     

Experimental evidence for the existence of a Ramsauer—Townsend minimum in liquid CH4 and liquid Ar (Kr and Xe)

Experimental evidence for the existence of a Ramsauer—Townsend minimum in the electron scattering cross section for liquid CH₄ and liquid Ar (Kr and Xe) is provided from: (i) comparisons of thermal electron mobilities in gases with those in liquids, (ii) changes in the electron mobility with gas density, and (iii) the dependence of the electron mobility on temperature for liquids whose V₀, the energy of the electron state in the liquid, is ? 0 eV.     

Crystal growth and electrical properties of lithium,rubidium, and cesium molybdenum oxide bronzes

Crystals of Li_0.33 MoO₃ (blue), Rb_0.23MoO₃ (blue) and Cs_0.31MoO₃ (red) were grown by electrolysis from MoO₃M₂MoO₄ melts (M =alkali metal) with composition 70–77 mole% MoO₃. Melts richer in M₂MoO₄ produced MoO₂ only. Correlation is made between bronze formation and the coordination of Mo in the melt and in the equilibrium solid phase M₂Mo₄O₁₃. Li_0.33MoO₃ and Cs_0.31MoO₃ are semiconductors with high-temperature-range activation energies 0.16 and 0.12 eV. Rb_0.23MoO₃ has an electrical behavior similar to that of blue K_xMoO₃ with a semiconductor-metal transition at (170 ± 5) K. ESR spectra observed in Li_0.33MoO₃ and Rb_0.23MoO₃ single crystals at 4.2 K show extensive delocalization of the 4d¹ electron associated with Mo(V) centers. Attempts to grow molybdenum bronzes containing Ca or Y were unsuccessful.     

The crystal structure of hydrogen cerium(III) sulfate hydrate, [H3O][Ce(SO4)2] · H2O

[H₃O][Ce(SO₄)₂] · H₂O crystallizes in the monoclinic system with unit-cell dimensions (from single-crystal data) a = 9.359(4), b = 9.926(4), c = 8.444(3) Å, β = 96.53(9)° and space group P2₁/n, z = 4. The structure was solved by conventional heavy-atom methods using 1787 counter-measured reflections (MoKα radiation), and refined using full-matrix least-squares techniques to an R of 0.0465 (ωR = 0.0413). The structure consists of cerium(III) ions in irregular nine-coordination to oxygen atoms from two bidentate sulfate ions, four monodentate sulfate oxygen atoms, and one water molecule. The oxonium ions are present as isolated ions in the structure and take par in the hydrogen bonding network. The Ce-O bond lengths range from 2.454(7) to 2.626(6) Å.     

Ionic conductivity of Li2MgSn3O8 ramsdellite

The ionic conductivity of polycrystalline pellets of Li₂MgSn₃O₈ with ramsdellite-type structure was measured by complex impedance technique. The conductivity is 1.2 × 10^?8 (Ω cm)^?1 at 300°C and 2.3 × 10^?4 (Ω cm)^?1 at 450°C. The results are discussed in relation to structural properties.     

Acidic and reductive dissolution of magnetite in aqueous sulfuric acid: Site-binding model and experimental results

The open circuit dissolution of ionic metal oxides in mineral acids is modelled assuming that the rate is controlled by the transfer of metal ions in hydrolytic equilibrium with bulk metal ions, from the metal oxide surface to the Stern plane. The site-binding model of the double layer metal oxide/electrolyte solution is used to obtain the pH dependence of surface and Stern potentials. The nature of the active sites is discussed and their surface concentration is assumed to be proportional to suface charge σ₀. Again, the site-binding model is used to detemine the pH dependence of σ₀. It is thus shown that the rate order in c_H⁺ is essentially defined by the potential dependence of the charge transfer process, for oxides with points of zero charge near neutrality that dissolve in mildly or strongly acidic solutions. The role of surface complexation is also discussed in terms of the site-binding model and the difficulties in interpreting dissolution experiments under constant external applied potential are discussed in terms of the complexity of the semiconductor oxide/electrolyte solution interfacial region in magnetite.An experimental study of the open circuit dissolution of magnetite in sulfuric acid is presented and interpreted according to the proposed model.The reductive dissolution of magnetite is modelled by extension of the Valverde-Wagner model of oxide dissolution. Experimental results are presented to demonstrate that the reductive dissolution rate of magnetite in ferrous containing solutions is controlled by the rate of electron transfer from adsorbed Fe(II) to Fe(III) surface states of magnetite.     

Multiparametric curve fitting-VII Determination of the number of complex species by factor analysis of potentiometric data

The number of complex species in solution may be determined by a computer-assisted factor analysis of a set of potentiometric titration curves, by finding the rank of the normalized data matrix. An application of the program SPECIES is demonstrated for some examples of titration data. The method is limited in that it can discriminate only between species with differing degrees of polymerization.     

Infrared spectra of KNaSO4 and K3Na(SO4)2

The infrared spectra, transmittance and polarized reflectance, of KNaSO₄ and K₃Na(SO₄)₂ are reported. Group theoretical analysis was carried out and a vibrational assignment proposed on basis of C_3v and D_3d symmetries. Factor group and site effects are discussed.     

Preparation of cyclopentadienes and diazocyclopentadienesvia cyclopentenolones and cyclopentenones

The structure and stereochemistry of the cyclopentenolones obtained by condensation of dialkyl ketones with benzil have been studied by NMR spectroscopy. These enolones were converted into cyclopentenones and cyclopentadienes. Alkyl-substituted cyclopentadienes required phenyllithium to effect their conversion by toluenesulphonyl azide into diazo-cyclopentadienes; otherwise piperidine sufficed as base catalyst.2,3,4-Triphenyldiazocyclopentadiene was simply procured by reaction of the condensation product of benzil and phenylacetone with toluenesulphonylhydrazone followed by alkali. Cyclohexyl- and methoxy-triphenylcyclopentadienes were prepared by photolytic decomposition of diazotriphenylcyclopentadiene in cyclohexane or methanol respectively.