Co-adsorption of surfactants and propyl gallate on the hydrophilic oxide surfaces

Propyl gallate (PG) adsolubilisation in the cationic, anionic and nonionic surfactant micelles formed in the bulk solution and at the silica/solution interface has been investigated. It was found that in the absence of surfactant, propyl gallate does not adsorb on the silica surface from aqueous solution. However, in the presence of hexyltrimethylammonium bromide (CTAB), its uptake by silica significantly increases. Alumina is quite an effective adsorbent for SDS and propyl gallate and does not adsorb nonionic TX-100. The addition of PG promotes adsorption of SDS and TX-100.     

Surfactant effect on the conductivity behavior of CsH2PO4: Characterization by electrochemical impedance spectroscopy

Cesium dihydrogen phosphate (CDP) nanoparticles were synthesized using the surfactants cetyltrimethyl ammonium bromide (CTAB), polyoxyethylene-polyoxypropylene (F-68) and (F-68:CTAB) with molar ratio 0.06. The samples conductivity such as CDP_CTAB, CDP_F-68 and CDP_{(F-68:CTAB)0.06} was studied by impedance spectroscopy in the frequency range 0.01 Hz to 1 MHz. The Nyquist plots were drawn at different temperatures of 210, 230 and 260 °C, which are defined below transition, phase transition and above transition, respectively. The measured conductivities obey the Arrhenius relation. The influence of surfactants on conductivity are more significant at higher temperature due to grain boundary. The conductivity of CDP_CTAB increased slightly with increasing temperature to 260 °C, whereas the conductivity of other samples decreased with increasing temperature over 230 °C. The results indicated that the conductivities increase in the order of CDP_CTAB>CDP_{(F-68:CTAB)0.06}>CDP_F-68. These are in accordance to the ion exchange capacities of the samples that the surfactant shows a direct influence on the samples proton mobility. It is found that the conductivity of CsH₂PO₄ is influenced by surfactant type.     

Binding of a surfactant counterion to low-charge-density poly(acrylic acid) and poly(methacrylic acid)

The binding of a cationic surfactant, dodecylpyridinium (C12Py) chloride, with a low-charge-density poly (methacrylic acid) (PMA) was investigated in buffer solutions under the condition of constant pH. The binding isotherms with PMA consisted of two and three steps at a pH lower and higher than 3.2, respectively. Bindings in the first step were independent of pH and this step was considered to correspond to the solubilization of the hydrocarbon chains of C12Py into the nonpolar region of the compact form of PMA. This is the indication of the compact form from the binding isotherm. At pH higher than 3.2, the second step was discriminated and it depended on the pH. In the third step, a sharp rise in the degree of binding (β) was observed accompanying the solubilization of the precipitates of the PMA–C12Py complex. The binding with poly(acrylic acid) (PAA) and PMA in conventional unbuffered NaCl solutions was also examined and the pH profile of the solution during the binding process was determined. In the case of unbuffered NaCl solutions, the binding with PAA took place cooperatively at the critical association concentration (cac). The binding isotherm consisted of two steps and the pH decreased with the increase in β. The binding isotherm of PMA, on the other hand, consisted of three steps: the pH decreased slightly in the first step and considerably in the second step with the increase in β but it increased with β in the third step, exhibiting a pH minimum around 3.2. The binding in the first step coincided with that obtained in the buffered solutions. Linear relationships between β and the pH were found for both polymers. In the case of PMA, no cac was observed in both buffered and unbuffered NaCl solutions. Received: 24 January 2001 Accepted: 23 May 2001     

Enantioselective epoxidations of alkenes catalyzed by (salen)Mn(III) in aqueous surfactant systems

An aqueous reaction medium, based on a surfactant solution of diethyltetradecylamine N-oxide (AOE-14), was developed for the enantioselective epoxidation of 1,2-dihydronaphthalene and of various cis-β-alkyl styrenes with increasing hydrophobicity, using bleach as oxidant and the Jacobsen chiral (salen)Mn(III) as catalyst. AOE-14 is able to both solubilize all reactants in water and bind the metal of the salen complex acting as coligand. Its use leads to good yields (>75%) and to ee values ranging from 75% up to 91% even in the case of cis-β-alkyl styrenes where lower cis/trans epoxide ratios are observed. The ratio of surfactant/substrate used is 1:1 or 4:1, much lower than those generally used in the literature.     

Water-promoted unprecedented chemoselective nucleophilic substitution reactions of 1,4-quinones with oxygen nucleophiles in aqueous micelles

Unique nucleophilic substitution and addition reactions of nitrogen and sulfur nucleophiles with 1,4-quinones in aqueous suspension with amines and thiols have recently been demonstrated by us.² However, the reactivity of oxygen nucleophiles toward nucleophilic substitution compared to nitrogen and sulfur nucleophiles ‘on water’ is not facile. An unprecedented economical, green methodology approach using ordinary laundry detergent (LD; washing powder, 0.5 mol %, reusable)/SDS as surfactant ‘in water’ for nucleophilic substitution by oxygen nucleophiles in 1,4-quinones in excellent yields has been demonstrated.     

Binary mixed micelles of chiral sodium undecenyl leucinate and achiral sodium undecenyl sulfate: I. Characterization and application as pseudostationary phases in micellar electrokinetic chromatography

Sodium 10-undecenyl sulfate (SUS), sodium 10-undecenyl leucinate (SUL) and their five different mixed micelles at varied percent mole ratios were prepared. The critical micelle concentration (CMC), C₂₀, γ_CMC, partial specific volume, methylene group selectivity, mobilities and elution window were determined using a variety of analytical techniques. These surfactant systems were then evaluated as novel pseudostationary phases in micellar electrokinetic chromatography (MEKC). As a commonly used pseudostationary phase in MEKC, sodium dodecyl sulfate (SDS) was also evaluated. The CMC values of SUS and SUL were found to be 26 and 16 mM, respectively, whereas the CMC of mixed surfactants was found to be very similar to that of SUL. The C₂₀ values decreased dramatically as the concentration of SUL is increased in the mixed micelle. An increase in SUL content gradually increased the methylene group selectivity making the binary mixed surfactants more hydrophobic. Linear solvation energy relationships (LSERs) and free energy of transfer studies were also applied to predict the selectivity differences between the surfactant systems. The cohesiveness and the hydrogen bond acidic character of the surfactant systems were found to have the most significant influence on selectivity and MEKC retention. The SUS and SDS showed the strongest while SUL showed the weakest hydrogen bond donating capacity. The basicity, interaction with n and π-electrons of the solute and dipolarity/polarizability were the least significant factors in LSER model for the surfactant systems studied. Free energies of transfer of selected functional groups in each surfactant systems were also calculated and found to be in good agreement with the LSER data.     

Facile synthesis of SERS active Ag nanoparticles in the presence of tri-n-octylphosphine sulfide

A facile and novel way was reported here for the synthesis of hydrophobic Ag nanoparticles (NPs), using AgNO₃, tri-n-octylphosphine (TOP) and sulfur (S) powder in process. TOP was used as solvent, reducing agent and stabilizer. S could chelate with excessive TOP to form trioctylphosphine sulfide (TOPS), which served as second capping agent. The hydrophobic Ag NPs could be transformed into hydrophilic state through ligand exchange. Furthermore, surface-enhanced Raman scattering (SERS) spectra of 4-aminothiophenol (4-ATP) were obtained on the hydrophobic and hydrophilic Ag NPs modified substrates, indicating that the as-synthesized Ag NPs had great potential for high sensitive optical detection applications.     

Facile synthesis and characterization of SnTe films

In this paper, we reported a novel, simple, and cost-effective route to SnTe films. The films were prepared by a chemical bath method, at room temperature and ambient pressure, using conventional chemicals as starting materials with or without surfactant. The films were characterized by X-ray diffraction, X-ray photoelectron spectroscopy and field-emission scanning electron microscopy, respectively. The SnTe film deposited without surfactant consists of nanoparticles (∼100 nm). The film deposited using polyethyleneglycol (PEG) as the surfactant consists of nanoparticles with size of ∼25 nm, whereas the film deposited using polyvinylpyrrolidone (PVP) as the surfactant consists of rough rod-like nanostructures (∼50 in diameter and ∼500 nm in length), besides nanoparticles (∼40-180 nm). The SnTe film deposited with PEG is smoother and denser. The formation mechanism of the SnTe films was proposed.     

正负离子表面活性剂/离子液体双水相性质研究

本文把短链离子液体(IL)四氟硼酸1-乙基-3-甲基咪唑鎓[C2mim]BF4引入正负离子表面活性剂十二烷基硫酸钠(SDS)和十二烷基三甲基溴化铵(DTAB)双水相体系(SDS/DTAB/H2O)中,研究了IL对双水相相图及相分离体系性质的影响。结果表明,[C2mim]BF4的阳离子性质是影响阴离子表面活性剂过量区域性质的主要因素,IL通过静电作用、氢键作用等改变体系中聚集体的形貌,最终导致阴离子双水相(ATPSa)的消失。IL的阴离子对阳离子双水相(ATPSc)区域性质起着决定作用;IL的盐效应引起的对表面活性剂混合胶束扩散双电层的压缩作用,不但促进胶团的形成,缩短了形成稳定胶团所需要的时间,加快了双水相的相分离速度,而且也造成了形成ATPSc所需DTAB含量的提高。IL的引入改变了ATPSc上、下相表面活性剂的组成及含量,使富含表面活性剂的上相中阳离子表面活性剂含量更高,进而提高了双水相的萃取性能,其上相对甲基橙的萃取效率可高达96.67%。     

测定亚硝酸根的表面活性剂增敏催化动力学光度法

基于在稀硫酸介质中溴化十六烷基三甲基铵对ＮＯ２－催化溴酸钾氧化曙红褪色反应的作用，建立了测定ＮＯ－２的表面活性剂增敏催化动力学光度法。加入十六烷基三甲基溴化铵（ＣＴＭＡＢ）后体系最大吸收波长由４８０ｎｍ红移至５４０ｎｍ，ΔＡ增大约２０倍。ΔＡ与ＮＯ－２含量在００１～０２ｍｇ／Ｌ范围内存在线性关系，检出限为０００４ｍｇ／Ｌ。方法已用于水样中ＮＯ－２测定，结果满意