高密度聚乙烯/全同立构聚丙烯共混物超拉伸纤维的热行为与力学行为

用热拉法制备了高密度聚乙烯(HDPE)/全同立构聚丙烯(iPP)共混物超拉伸纤维,研究了拉伸比对其热行为及力学行为的影响,随拉伸比增加,纤维中HDPE与iPP的结晶度增大,熔融温度升高、熔程变宽;纤维中HDPE与iPP的结晶度低于其纯组分,熔融湿度与熔程基本不受组分比的影响,随拉伸比增加,纤维的模量增高,以HDPE为主的纤维的拉伸强度增大,以iPP为主的纤维拉伸强度增至一定值后,不再随拉伸比增加而增大,并有下降趋势。     

尼龙6,6(PA_(6,6)及其共混物结晶性能的研究

<正> 尼龙6,6(PA_(6,6))是一种典型的结晶性工程塑料,被广泛应用于纺织、机械制造等行业,但其加工温度范围较窄,耐热性差。聚醚砜(PES)具有较高的玻璃化转变温度,是非晶聚合物,可以诱发某些结晶聚合物结晶。PES与PA_(6,6)共混体系的研究报道较少,本文用熔融法将PES与PA_(6,6)制成共混物,企图改善PA_(6,6)的结晶性,以提高其耐热性,取得了较理想的结果。     

聚氧化乙烯(PEO)/聚双酚A羟基醚(PBHE)共混体系的非等温结晶动力学

本文联系Avrami方程和Ozawa方程,得出一个适合于非等温结晶动力学过程的新的基本方程,由这个方程可获得描述非等温结晶动力学过程的某些参数,并用DSC方法,对PEO/PBHE共混体系的非等温结晶动力学进行了研究,对实验结果进行了讨论.     

新型聚芳醚酮与热致性液晶高聚物共混物流变性能和力学性能的研究

本文研究了新型聚芳醚酮与热致性液晶高聚物(PEK-C/LCP)共混物的流变性能及力学性能。结果表明:由于LCP的加入,PEK-C的熔体粘度降低;随着剪切速率的增加,共混物熔体流动活化能从223.5KJ/mol降为102.2KJ/mol。共混物的玻璃化转变温度从纯PEK-C的218℃降为199℃;除模量增加外,其它力学性能均有所下降。同时利用SEM观察了共混物冲击断面形貌,未发现有LCP微纤维生成。     

环氧树脂/聚碳酸酯固化共混物的结构及性能

相结构;酯交换反应;力学性能;环氧树脂/聚碳酸酯固化共混物的结构及性能     

壳-核结构增韧剂超高增韧非晶共聚酯的形貌和形态

研究了马来酸酐接枝的壳核结构增韧剂 (TPEg)对非晶热塑共聚酯 (PETG)的增韧和增强效果 ,并与马来酸酐接枝的纯橡胶类增韧剂 (POEg)作了对比 .TPEg对PETG具有显著的增韧效果 ,当TPEg含量由 5%增加到 1 0 %时 ,共混物就可以发生由脆性到超高韧性的快速转变 .而POEg虽然也可以使PETG发生由脆性到韧性的快速转变 ,但转变是在较高的增韧剂含量下发生的 ,这意味着共混物的抗张强度和模量损失更多 .利用扫描电镜观察、分析了随增韧剂含量的增加 ,共混物的形貌、形态的演化过程 .共混物的缺口冲击韧性与其形貌、形态之间存在很好的对应关系 .     

Preparation and Characterization of Polyborosiloxanesand Their Blends with Phenolic Resin as ShapeableCeramic Precursors简

Two polyborosiloxanes(PBSis) with char yield up to 74.13% at 800 °C were synthesized by the direct polycondensation of boric acid with phenyltrimethoxysilane in diglyme. The PBSis were characterized by gel permeation chromatography, IR spectroscopy as well as1H-,29Si- and11B-NMR. PBSi modified phenol-formaldehyde resins(PBSi/PFs) were prepared at different PBSi/PF mass ratios and were cured at 150 °C. The PBSi/PFs were characterized by IR spectroscopy, scanning electron microscopy, thermogravimetric analysis and tensile test. The results revealed that the cured PBSi/PFs had sea-island morphology and higher char yield than the common PF. PBSi/PF blend with PBSi/PF mass ratio of 0.4:1 had char yield up to 70.83% at 800 °C. The PBSi/PFs had tensile strength similar to PF. The ceramization of PBSi/PFs was also studied. The silicon boron oxycarbide(SiBOC) ceramics formed were characterized by IR spectroscopy and elemental analysis. This method provided a valuable way to prepare easily shapeable polymer blends as ceramic precursors.     

A hierarchical porous carbon membrane from polyacrylonitrile/polyvinylpyrrolidone blending membranes:Preparation,characterization and electrochemical capacitive performance

Novel hierarchical porous carbon membranes were fabricated through a simple carbonization procedure of well-defined blending polymer membrane precursors containing the source of carbon polyacrylonitrile （PAN） and an additive of polyvinylpyrrolidone （PVP）, which was prepared using phase inversion method. The as-fabricated materials were further used as the active electrode materials for supercapacitors. The effects of PVP concentration in the casting solution on structure feature and electrochemical capacitive performance of the as-prepared carbon membranes were also studied in detail. As the electrode material for supercapacitor, a high specific capacitance of 278.0 F/g could be attained at a current of 5 mA/cm2 and about 92.90% capacity retention could be maintained after 2000 charge/discharge cycles in 2 mol/L KOH solution with a PVP concentration of 0.3 wt% in the casting solution. The facile hierarchical pore structure preparation method and the good electrochemical capacitive performance make the prepared carbon membrane particularly promising for use in supercapacitor.     

聚左旋乳酸/聚消旋乳酸共混物的结晶行为

非晶态聚消旋乳酸(PDLLA)对PLLA的结晶行为有较大的影响。本文利用差示扫描量热仪(DSC)和偏光显微镜(POM)对不同分子量PLLA、PDLLA按不同比例制得的共混物结晶进行了系统研究。结果表明随PDLLA含量的增大PLLA冷结晶温度升高,且越接近熔融温度。PDLLA分子量较小时PLLA球晶特征被明显破坏,PDLLA分子量较大时PLLA更易形保持球晶特征且易形成环带球晶形貌,这与结晶速率与非晶组分的扩散速率匹配程度有关。低分子量的PDLLA使PLLA的最大生长速率对应的温度出现在较低温度。     

聚己内酯在聚己内酯/聚乙烯基甲基醚共混体系中的结晶研究

通过示差扫描量热(DSC)、广角X射线衍射(WAXD)、小角X射线散射(SAXS)研究了聚己内酯(PCL)/聚乙烯基甲基醚(PVME)共混体系中PCL的结晶行为.研究结果表明,共混聚合物中PCL的结晶度几乎不随体系的组成而发生变化.共混物中PVME的存在没有改变PCL的晶体结构,但是随着PVME含量的增加,片晶之间的距离则大,这主要是由于非晶层增厚引起的.