A survey of surface tension,molar volume and density for Sn–Ag–Cu–Bi–Sb quinary alloys as lead-free solders

ABSTRACT

By applying the geometric models and the theoretical equation, the surface tension, the molar volume and the density were studied. The empirical calculations were carried out in temperature range 623?K?≤?T?≤?1123?K. Only few thermophysical properties were estimated for eight quinary alloys: Sn3.55Ag0.5Cu3Bi3Sb, Sn3.48Ag0.5Cu3Bi5Sb, Sn3.48 Ag0.5Cu5Bi3Sb, Sn3.40 Ag0.5Cu5Bi5Sb, Sn3.53Ag1Cu3Bi3Sb, Sn3.46Ag1Cu3Bi5Sb, Sn3.46Ag1Cu5Bi3Sb, Sn3.38Ag1Cu5Bi5Sb. The results show that surface tension and density have a linear appearance for all temperatures. We have also studied the influence of the composition and temperature in the studied alloys. The obtained theoretical results are compared with the experimental ones and with the conventional Pb–Sn welds.     

Conversion ofn-hexane over Pt?Sn/γ-Al2O3 catalyst

Conversion ofn-hexane has been applied as a test reaction to study differences between the series of Pt−Sn/γ-Al₂O₃ catalysts obtainedvia different methods of preparation. Preliminary results of catalytic experiments have been compared with some changes occurring on the catalysts surfaces as the results of the preparation technique applied. It has been found that catalysts with the second metal (Sn) introduced to the support by the coprecipitation technique were much more stable in comparison to the catalysts where the tin component has been added by the impregnation method, however, we have not observed large differences in catalytic activity.     

镀液中Ce^3＋离子对锡镀层结构缺陷和可焊性的影响

应用荧光分析法、X光电子能谱法(XPS)及正电子湮没寿命谱法(PALS)等研究了从含硫酸铈添加剂的酸性光亮锡镀液获得的锡镀层结构缺陷与可焊性的关系。结果表明,电镀时Ce与Sn不发生共沉积,Ce~(3+)的主要作用是阻化Sn~(2+)的水解和氧化使镀液稳定,因而使锡镀层纯度提高、结构致密、表层氧含量减少,有利于提高镀层的可焊性。当Ce~(3+)浓度控制在3.5g/L左右时,可使镀层结构缺陷较少,可焊性较佳,说明结构缺陷是影响锡镀层可焊性的直接原因。     

Performance of Pt/SnO2 catalyst in the gas phase hydrogenation of crotonaldehyde

Selective hydrogenation of crotonaldehyde was performed on 5% Pt/SnO₂ catalysts, in gaseous phase, at atmospheric pressure, at 353 K. Two types of catalyst were prepared using H₂PtCl₆ and Pt(NH₃)₄(NO₃)₂ as metallic precursors. Their performances were compared as a function of the reduction temperature and both catalysts were characterised by X-ray diffraction after different reduction treatments. Using the ex-chloride catalyst, the selectivity values to the unsaturated alcohol (UOL) resulted into a maximum of 45% while a selectivity as high as 70–77%, in 0–25% conversion range, was achieved by using ex-nitrate catalyst reduced at 443 K. The formation of Pt–Sn alloy on the metal particles of platinum was thought to be necessary to improve the activity and the selectivity on these catalysts. In the contrast, a presence of PtSn₂ formed at a reduction temperature higher than 473 K led to a decrease of activity and selectivity.     

New diorganotin(IV) derivatives of 7-hydroxycoumarin (umbelliferone) and their adducts with 1,10-phenanthroline

New diorganotin(IV) derivatives of the general formula R2Sn(Umb)2 (where R = n-Bu, n-Oct and Ph; Umb = umbelliferone anion) have been synthesized either by the reaction of R2SnO with umbelliferone under azeotropic removal of water or by the reaction of R2SnCl2 with sodium salt of umbelliferone. Further, the adducts of the general formula R2Sn(Umb)2.phen (where R = n-Bu and n-Oct; phen = 1,10-phenanthroline) have also been synthesized by the interaction of R2Sn(Umb)2 with 1,10-phenanthroline. The bonding and coordination behavior in these derivatives are discussed on the basis of IR and 119Sn M?ssbauer spectroscopic studies in solid state. Their coordination behavior in solution is discussed by the multinuclear (1H, 13C and 119Sn) NMR spectral studies. The M?ssbauer and IR studies indicate that umbelliferone acts as a monoanionic bidentate ligand in R2Sn(Umb)2 coordinating through O(7) and O(1). A distorted octahedral geometry around tin has been proposed for R2Sn(Umb)2 as well as for R2Sn(Umb)2.phen in solid state. The newly synthesized derivatives have been tested for their anti-inflammatory and cardiovascular activities. The average LD50 value >1000 mg kg(-1) of these compounds indicates their safety margin.     

Determination of tin in soil by continuous hydride generation and inductively coupled plasma mass spectrometry

A method was investigated for the determination of Sn in soil samples by KOH fusion followed by continuous hydride generation coupled with inductively coupled plasma mass spectrometry (HG-ICP-MS). Sample solutions in 3.0 M HCl were mixed in line with a solution of 2.4% NaBH₄ and 0.25 M KOH to generate stannane gas. The mixture was delivered continuously to a gas/liquid separator and the stannane gas was introduced into a Perkin-Elmer Sciex Elan 6000 ICP-MS for concentration measurements. A method detection limit of 0.45 mg/kg was sufficient for Sn levels commonly found in soil samples. Sn concentrations as low as 2.5 mg/kg were reproducibly measured in soil samples. Sample results by HG-ICP-MS agreed within ±17% relative difference to results by instrumental neutron activation analysis (INAA) and within ±6% relative difference to results by KOH fusion followed by inductively coupled plasma optical emission spectroscopy (ICP-OES).     

Simplified synthesis, H, C, N, Sn NMR spectra and X-ray structures of diorganotin(IV) complexes containing the 4-phenyl-2,4-butanedionebenzoylhydrazone(2−) ligand

Two diorganotin(IV) complexes of the general formula R₂Sn[Ph(O)CCH-C(Me)N-NC(O)Ph] (R=Ph, 1; R=Me, 2) have been synthesised from the corresponding diorganotin(IV) dichloride and the ligand 4-phenyl-2,4-butanedionebenzoylhydrazone(2−) (H₂L), derived from benzoyl acetone and benzoyl hydrazide in methanol at room temperature in presence of triethylamine. The syntheses were performed under very mild conditions, at room temperature and without exclusion of air or moisture from the reaction vessel. Previously, rigorous conditions have been considered necessary for these species. The two compounds have been characterised by elemental analysis, IR and ¹H, ¹³C, ¹⁵N, ¹¹⁹Sn NMR spectra, and their structures have been confirmed single crystal X-ray structure analysis. The central tin atom of both complexes adopts a distorted trigonal bipyramidal coordination with two ligand oxygen atoms in axial positions, the nitrogen atom of the ligand and two organic groups on tin occupying equatorial sites. 2 has crystallised with two crystallographically independent molecules in the asymmetric unit. The δ(¹¹⁹Sn) values for the complexes 1 and 2 are −151.5 and −146.8 ppm, respectively, thus indicating penta-coordinated tin centres.     

Sn Mössbauer spectroscopy of Gd0.8L0.2Mn6Sn6 and Tb0.8L0.2Mn6Sn6 compounds (L=Sc,Y, Lu)

The HfFe₆Ge₆-type compounds Gd_0.8L_0.2Mn₆Sn₆ and Tb_0.8L_0.2Mn₆Sn₆ (L = Sc, Y, Lu) have been studied by ¹¹⁹Sn Mössbauer spectroscopy. The values of the apparent quadrupolar splitting clearly evidence the easy plane magnetization of the gadolinium compounds and the easy axis one in the terbium compounds. The three tin sites behave differently with the nature and size of the substituting L element. For a given series, the hyperfine field of the Sn_2d site is almost unchanged whatever the size of the L element. The hyperfine field of the Sn_2e site strongly varies with the L size in relation with atomic displacements. The hyperfine field of the Sn_2c site exhibits a more complicated behavior. The field difference in the easy plane and easy axis compounds confirms the angle-dependent anisotropic contribution of the Mn moment to the hyperfine field. The analysis of the results also suggests the play of angle-dependent contributions arising from the rare earth moment.