银纳米微粒荧光猝灭法测定水中痕量ClO2

在pH 9.1的NH4Cl-NH3·H2O缓冲溶液中,银纳米微粒在470 nm处产生一个荧光峰;它能被ClO2氧化导致体系的荧光发生猝灭.ClO2浓度在0.001 1～0.185μg·mL-1范围内与荧光猝灭强度成良好的线性关系,检测限为0.004 7μg·mL-1 ClO2.据此建立了测定ClO2的荧光分析新方法,用于饮用水中ClO2的测定,结果满意.     

Determination of Trace Mercury by Solid Substrate-Room Temperature Phosphorimetry Quenching Method Based on Catalytic Effect of Hg2+on Formation of the Ion Association Complex [Sn(XO)6]4+·[(Fin)4]

A new method for the determination of trace mercury by solid substrate-room temperature phosphorimetry (SS-RTP) quenching method has been established. In glycine-HCl buffer solution, xylenol orange (XO) can react with Sn⁴⁺ to form the complex [Sn(XO)₆]⁴⁺. [Sn(XO)₆]⁴⁺ can interact with Fin⁻ (fluorescein anion) to form the ion associate [Sn(XO)₆]⁴⁺·[(Fin)₄]⁻, which can emit strong and stable room temperature phosphorescence (RTP) on polyamide membrane (PAM). Hg²⁺ can catalyze H₂O₂ oxidizing the ion association complex [Sn(XO)₆]⁴⁺·[(Fin)₄]⁻, which causes the RTP to quench. The ΔIp value is directly proportional to the concentration of Hg²⁺ in the range of 0.016–1.6 fg spot⁻¹ (corresponding concentration: 0.040–4.0 pg ml⁻¹, 0.40 μl spot⁻¹), and the regression equation of working cure is ΔIp=10.03+83.15 m Hg²⁺ (fg spot⁻¹), (r=0.9987, n=6) and the detection limit (LD) is 3.6 ag spot⁻¹(corresponding concentration: 9.0×10^–15 g ml⁻¹, the sample volume: 0.4 μl). This simple, rapid, accurate method is of high selectivity and good repeatability, and it has been successfully applied to the determination of trace mercury in real samples. The reaction mechanism for catalyzing H₂O₂ oxidizing the ion association complex ([Sn(XO)₆]⁴⁺·[(Fin)₄]⁻) SS-RTP quenching method to determine trace mercury is also discussed.     

SIMPLE TECHNIQUES FOR DETERMINING THE SMALL-SIGNAL EQUIVALENT CIRCUIT OF MESFET’s

Simple techniques for determining the broadband small signal equivalent circuit (SSEC) of MESFETs are presented in this paper. The intrinsic elements are calculated using two-dimensional method from the Y parameters, which are obtained from the Fourier analysis of the device transient response to voltage-step perturbations at the drain and gate electrodes. Whereas, the parasitic external elements are determined by simple approximations used in transmission line modeling. In addition, a new technique is also proposed to determine the source and drain series resistances. A comparison of the SSEC of three different MESFETs technologies shows that the MESFETs on GaN and 4H-SiC are suitable for high power applications. The method used to determine the intrinsic elements is validated with simulated data obtained by Monte Carlo method.     

57Fe Mössbauer spectroscopic study of (25−x)MnO–xZnO–15Fe2O3–60B2O3 glasses

The ⁵⁷Fe Mössbauer technique has been used to investigate the effect of zinc oxide substitution in (25???x)MnO–xZnO–15Fe₂O₃–60B₂O₃ glass system (x?=?0, 5, 10, 15 and 20 mol% of ZnO ). Mössbauer absorption spectra for all the samples recorded at room temperature suggest the existence of the two paramagnetic quadrupole doublets. The observed variations in hyperfine parameters have been explained on the basis of cations distribution and exchange interaction at the lattice sites and it is concluded that B–B interaction increases while the metal–metal interaction decreases due to replacement of manganese oxide by zinc oxide. These results suggest that the present glass system exhibits a paramagnetic behaviour that changes towards the weak paramagnetic when manganese oxide was replaced with zinc oxide.     

深空光通信中的图像信标捕获技术

为实现深空光通信链路建立过程中精确的对准,提出了一种深空光通信系统扩展信标的捕获方案。该方案以可视地球图像作为信标,在航天器上存储一幅信标图像作为参考图像,采用天线扫描的方式在各点对所瞄准的区域成像,利用像素扫描的方式,使参考图像和实际探测图像进行相关,在天线扫描完成以后,找出相关性最大的位置,即可认为在该点捕获到地球图像。在计算两图像相关系数的过程中,由于傅里叶梅林变换幅度谱具有伸缩及旋转不变性,因此利用傅里叶梅林变换即可消除两图像相关系数因为旋转和伸缩的影响。利用蒙特卡罗方法随机产生1000个视场,仿真结果表明,3σ内正确捕获到信标图像的概率为99.6%,表明这是一种可行的方法。     

一维亚波长周期结构物成像的光子学研究

当用波长为λ的单色平行光垂直照射到光栅常数d<λ的亚波长周期结构衍射物时,会产生隐失波。由于快速衰减,这种亚波长周期物是不能成像的。但是,通过对亚波长周期结构物进行适当的编码后可得到均匀波,使这种携带了隐失波信息的均匀波通过经特别设计的光学系统并被放大到CCD所能识别的像素大小后,再进行必要的解码以滤掉编码波,即可得到原亚波长周期结构衍射物的像,最终达到超分辨的目的。基于这种新颖的成像技术,用常规仪器就实现了对亚波长周期结构物的成像。在运用光子学方法对实验和成像过程进行较为详尽的理论分析的同时,对编码器、解码器的位置以及它们相对物光栅的取向给出了设计性研究,对滤波器的选择给予了必要的说明。实验结果验证了该设计理论的正确性。     

一维光子晶体缺陷模激光器的放大特性

光子晶体中引入缺陷后将形成缺陷模,这些缺陷模在增益介质中将被放大形成激光。基于麦克斯韦方程和速率方程相结合的模型,用时域有限差分法(FDTD)计算和分析了一维单缺陷光子晶体激光器中缺陷模的空间分布和频谱特性,以及这些缺陷模的放大特性,主要研究了缺陷层的厚度、晶体层数对缺陷模放大特性的影响。模拟结果显示,类似于传统激光腔的腔模,这些缺陷模能够被放大,形成激光。调整缺陷层的厚度、晶体层数等结构参量,将改变缺陷模的谐振,激射频率以及空间分布,这将直接影响激射阈值和饱和特性。增加晶体的层数,激光器的阈值将降低,饱和值将增加,但晶体层数增加到一定限度时,这种增减趋势变弱。模拟结果证明了有效层数的存在。     

论浮力的计算

通过讨论物体下表面不与液体接触时浮力的计算,总结浮力计算的一般方法.     

方形自聚焦透镜的研制

经过方形玻璃丝的加工、离子交换及成品的精密加工等过程,成功制出了方形自聚焦透镜.并采用聚焦成像和雅明干涉等方法对其光学特性进行测试,得出了方形自聚焦透镜本身所具有的一些特性：中心部分畸变较小,成像性能好;四个棱角内的球差较大,像质较差;折射率分布不具有旋转对称性,而是与方向和半径有关.     

转移矩阵法在负折射率介质材料平板波导中的应用研究

利用严格电磁理论,推导出了适用于负折射率介质材料光波导的转移矩阵,分析讨论了转移矩阵的性质和应用.利用转移矩阵方法,推导出导波层为负折射率介质材料、覆盖层和衬底为右手材料的三层对称介质光波导的本征色散方程.用图解法研究了负折射率介质波导中TE波的异常色散特性.在负折射材料介质波导中没有零阶模,最低阶为1阶模,并且有截止频率,只有波导参量满足一定条件的时候才会存在,导模的横向波数可以为实数和纯虚数,而正折射率介质波导导模的横向波数只能为实数.