Laser spectroscopic investigation of a new precursor-type polyparaphenylenevinylene

Optical, structural and morphological properties of thin films of polyparaphenylenevinylene (PPV) formed by an alkyl sulfinyl precursor route have been studied. Thin films were fabricated on an optical glass and on quartz glass either by spin-coating of the precursor solution or by layer-by-layer deposition using Langmuir–Blodgett technique. PPV precursor films were also spin-coated on gold-coated glass in order to study thin-film optical parameters by surface plasmon spectroscopy. We have been successful in forming about 40 precursor mono layers on quartz glass by Langmuir–Blodgett technique using optimized surface pressure and dipping conditions. After thermal conversion of the precursor layers good quality fluorescent PPV films of yellow colour have been obtained. Optical characterization of the films was carried out by linear absorption and emission spectroscopy, ellipsometry, and surface plasmon spectroscopy. Structural and morphological studies on the thin films were carried out by using X-ray scattering and atomic force microscopy. Wave-guided travelling-wave laser action has been achieved in a PPV film on quartz glass. The sample was transversally pumped with picosecond laser pulses (wavelength 347.15 nm, duration 35 ps). Laser emission occurred at 550 nm for pump pulse energy densities above .     

An optical fibre pH sensor based on dye doped mesostructured silica

This paper describes the synthesis and optical pH sensing properties of a pH indicator dye activated mesostructured silica coated optical fibre. The pH-sensitive dye bromothymol blue was incorporated into the mesostructure sol precursor and thin films/coatings were used for pH-sensing applications without prior removal of the surfactant. The pH sensitivity range and operating wavelength were analysed by absorption measurements on layer dip-coated on glass slides. The pH sensing properties of coated optical fibre were tested by evanescent wave method. Experiments were carried out by using a series of solutions of known pH. No leaching was observed (except at very high pH) and an excellent reversibility was obtained between pH=2 and 5.     

双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

利用模式的对称性研究光子晶体光纤的色散

由光子晶体光纤的对称性可以得到模式分布的对称性，根据模式的对称性选择适当的展开函数，可以使计算量大大减少。计算了六角结构光子晶体光纤的色散特性，得到了波长在1．55pm处色散为零时，光子晶体光纤的结构参量所满足的方程。     

The Study of MMW and MW Attenuation Considering Multiple Scattering Effect in Sand and Dust Storms at Slant Paths

The influence of sand and dust storms on modern MMW and satellite communication systems reliability have been paid more attention to. The attenuations induced by sand and dust storms are estimated by means of Mie-theory and Rayleigh approximation, in the case of the tenuous distribution of particles. With the particle density increasing, however, these method become inadequate, the multiple scattering effects then become dominant for attenuation estimation. The attenuations considering multiple scattering effects are estimated by Monte-Carlo and four fluxes method at horizontal paths. At slant paths, based on multi-layer media model, the attenuations considering multiple scattering effects are calculated by layered Monte-Carlo method at 100, 37, 24, and 14GHz. It is shown that the multiple scattering effects should be considered at the attenuation prediction in the sand and dust storm, which the visibility is about 0.5km and smaller than 0.5km and frequency is about 20GHz. Above 30GHz, the multiple scattering effects due to sand and dust particles should be considered, as visibility is about 1km and smaller than 1km at slant paths.     

低进汽压力下超音速两相流升压特性实验研究

本文采用实验方法研究了进汽压力为0.2 MPa以下时,由蒸汽喷嘴、混合腔及相应的阀门和管道组成超音速汽液两相流升压加热装置的运行特性。实验表明在进汽压力为0.1 MPa-0.2 MPa时,超音速汽液两相流升压加热装置都可稳定可靠地运行,且升压效果明显,可满足电力、供暖、轻工等许多行业蒸汽加热的要求。     

单壁碳纳米管的SERS研究

本文通过改进实验方法,将单壁碳纳米管的乙醇溶液与金胶混合并制作成固体薄膜,使单壁碳纳米管夹裹在金纳米粒子之间,保证了吸附的紧密性,获得了高质量的单壁碳纳米管SERS光谱。不但观测到文献中报道的径向呼吸振动模(RBM)和C-C正切拉伸模(GM)的增强,还在1100-1500cm-1区域观测到一组新峰,其峰形完整并有相当的强度。这些峰在现有的文献中几乎没有报导。文章对这组新峰的出现进行了初步的分析。     

High-Q whispering gallery modes in a spherical shell dielectric resonator: Characterization at microwave frequencies

We present a numerical and experimental characterization of high-Q whispering gallery resonant modes excited in a fused quartz spherical shell operated in the 18-26.5 GHz band; easy coupling and selection of modes is a most advantageous feature of the proposed structure with respect to ordinary bulk resonators. The numerical results, based on a finite element algorithm, well match experimental data, which also show the capability of our device to perform gaseous spectroscopy measurements. Received 25 October 2002 Published online 4 February 2003     

神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

用横波推导简谐波的能量

本文提出用横波推导简谐波能量的方法，并就此进行了具体时推导。