低进汽压力下超音速两相流升压特性实验研究

本文采用实验方法研究了进汽压力为0.2 MPa以下时,由蒸汽喷嘴、混合腔及相应的阀门和管道组成超音速汽液两相流升压加热装置的运行特性。实验表明在进汽压力为0.1 MPa-0.2 MPa时,超音速汽液两相流升压加热装置都可稳定可靠地运行,且升压效果明显,可满足电力、供暖、轻工等许多行业蒸汽加热的要求。     

某轴流压气机叶尖间隙效应实验研究

本文对某低速轴流压气机叶尖间隙尺度对性能的影响进行了实验研究,并通过不同的机匣结构情况研究一种叶尖漏流不敏感机匣。实验表明,不同的间隙尺度对叶轮机总体性能存在十分明显的影响。对绝大部分运行状态,小间隙下的压升和效率均明显高于大间隙的情况。另外,所采用的毛刷式和篦齿式的机匣实验结果表明,不论毛刷式还是篦齿式机匣,在大流量负攻角情况下对性能的影响不大,但毛刷式机匣并不能达到提高失速裕度的目的,而篦齿式机匣在小流量情况下对压升有所提高,但对效率影响不大。     

On the Second Law of Thermodynamics and the Piston Problem

The piston problem is investigated in the case where the length of the cylinder is infinite (on both sides) and the ratio m/M is a very small parameter, where m is the mass of one particle of the gaz and M is the mass of the piston. Introducing initial conditions such that the stochastic motion of the piston remains in the average at the origin (no drift), it is shown that the time evolution of the fluids, analytically derived from Liouville equation in a previous work, agrees with the Second Law of thermodynamics. We thus have a non equilibrium microscopical model whose evolution can be explicitly shown to obey the two laws of thermodynamics.     

溃坝问题的间断有限元方法

本文研究90年代初提出的Runge-Kutta间断Galerkin有限元方法，给出该方法的精度分析，通过经典算例验证该方法处理间断问题、捕捉锐利波形的能力，并将其推广到求解浅水问题．针对坝底无摩擦，无坡度的理想情形进行讨论，给出方溃坝和圆溃坝问题的数值模拟结果．     

Hierarchical structures in a turbulent pipe flow

A hierarchical structure (HS) analysis (β-test and γ-test) is applied to a fully developed turbulent pipe flow. Velocity signals are measured at two cross sections in the pipe and at a series of radial locations from the pipe wall. Particular attention is paid to the variation of turbulent statistics at wall units 10<y⁺<3000. It is shown that at all locations the velocity fluctuations satisfy the She–Leveque hierarchical symmetry (Phys. Rev. Lett. 72 (1994) 336). The measured HS parameters, β and γ, are interpreted in terms of the variation of fluid structures. Intense anisotropic fluid structures generated near the wall appear to be more singular than the most intermittent structures in isotropic turbulence and appear to be more outstanding compared to the background fluctuations; this yields a more intermittent velocity signal with smaller γ and β. As turbulence migrates into the logarithmic region, small-scale motions are generated by an energy cascade and large-scale organized structures emerge which are also less singular than the most intermittent structures of isotropic turbulence. At the center, turbulence is nearly isotropic, and β and γ are close to the 1994 She–Leveque predictions. A transition is observed from the logarithmic region to the center in which γ drops and the large-scale organized structures break down. We speculate that it is due to the growing eddy viscosity effects of widely spread turbulent fluctuations in a similar way as in the breakdown of the Taylor vortices in a turbulent Couette–Taylor flow at high Reynolds numbers.     

偏滤器靶板磁预鞘层边界的离子流

利用流体力学模型研究了偏滤器等离子体条件下磁预鞘层边界离子流和预鞘层宽度之间的关系，并分析了粒子碰撞对预鞘层边界离子流的影响。由于粒子碰撞对离子的驱动效益，预鞘层边界离子流速度随着预鞘层宽度的增加而减少；只有当预鞘层宽度趋于零时，边界离子流沿磁力线的速度才趋近于离子声速。在固定预鞘层宽度的条件下，计算了预鞘层边界离子流速度与碰撞频率之间的函数关系。     

Load-Carrying Capacity of Circular Plates Made of a Fiber-Reinforced Composite

The load-carrying capacity of circular plates made of a fiber-reinforced composite and loaded with axisymmetric transverse forces under axisymmetric boundary conditions is investigated. The plates can be freely supported or clamped along their contour. To the known yield condition used, in the plane of main bending moments, there correspond irregular hexagons, which depend on the mechanical properties of composite constituents and some characteristic geometrical parameters. It is shown that, depending on the ratio of ultimate radial and circumferential bending moments, in the plastic state, the circular plates (the central part of the clamped plates) take the form of a cone or a frustum of cone. For each of the cases, the limit load is found, which is a function of the above-mentioned mechanical parameters. The statically allowable fields of bending moments and the corresponding allowable fields of deflection rates are determined. The solutions found are exact. Special cases for the freely supported plates are analyzed, and the results obtained are presented in the form of graphs.__________Translated from Mekhanika Kompozitnykh Materialov, Vol. 41, No. 2, pp. 177–192, March–April, 2005.     

Internal standardization for the determination of cadmium,cobalt, chromium and manganese in saline produced water from petroleum industry by inductively coupled plasma optical emission spectrometry after cloud point extraction

In the present paper a procedure is proposed for the determination of traces of Cd, Co, Mn and Cr in petroleum industry produced water by inductively coupled plasma optical emission spectrometry. The procedure is based on cloud point extraction of these metals, as their dithizonate complexes, into the surfactant-rich phase of octylphenoxypolyethoxyethanol surfactant (Triton X-114). Extractions were carried out in solutions with salinities between 10‰ and 70‰. Since residual salinity in the surfactant-rich phase caused differences in its transport to the plasma, yttrium was used as an internal standard to correct for this effect. The simultaneous metal extraction procedure was optimized by response surface methodology using a Doehlert design and desirability function. Enhancement factors of 21, 21, 9 and 19, along with limits of quantification of 0.093, 0.20, 0.73 and 1.2 μg L^− 1, and precision expressed as relative standard deviation (n = 8, 20.0 μg L^− 1) of 5.8, 1.2, 1.7 and 5.7% were obtained for Cd, Co, Mn and Cr, respectively. The accuracy was evaluated by spike recovery tests on the high salinity water samples with salinity of 40 and 63‰.     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

多排叶片内部流动以及叶片排与排气系统相互作用研究

本文采用高分辨率格式和多块多网格方法求解雷诺平均Navier-Stokes方程,数值模拟多排叶片内的三维粘性流动;使用数值激盘模拟叶片排的存在,研究叶片排与非轴对称排气部件之间的相互作用以及复杂的内部流动。文中描述了数值方法,给出了NASA透平导叶和单级透平内部流场的数值结果及其与相应实验结果的对比,也给出了多级透平内部流场的数值结果,以及透平与排气部件之间的耦合流场的结果。