多条形电极束流能散度探测器的张角优化

 采用Surperfish对北京正负电子对撞机的多条形电极束流能散度探测器进行了电磁场模拟计算。在带模拟束流的情况下,计算分析了探测器对束流位置和能散度的分辨能力与电极张角之间的关系,首次计算了条形电极间的电容耦合综合强度。电极张角优化结果表明：在不考虑噪声水平的情况下,电极张角为20°时,探测器的灵敏度和分辨率达到最优。而当噪声影响很大时,可以适当增加电极张角,同时考虑减小噪声的措施。     

残余奥氏体含量对马氏体高强钢滑动磨损性能的影响

对3种不同残奥(RA)含量的马氏体高强钢进行干滑动摩擦磨损试验, 研究RA含量对其磨损性能的影响. 利用扫描电镜、透射电镜、X射线衍射仪等对试验后的磨损表面及横截面显微组织进行表征. 结果表明, RA含量越高, 磨损表面越光滑, 摩擦系数和磨损率越小, 也即马氏体高强钢的耐磨性越好. 磨损引起的大应变使RA发生应变诱导马氏体相变, 导致硬度和硬化层厚度显著增大. RA含量最高的HT3试样的硬度提高了18.3%, 硬化层厚度达70μm. 相比RA含量低的试样, HT3试样表现出很好的耐磨性. 这是因为马氏体相变使硬度逐步增加, 抗裂纹萌生能力提高; 同时由于亚表面良好的韧性, 可延缓和阻止裂纹扩展, 使得点蚀和剥落不易形成. 因此, 要提高马氏体高强钢的耐磨性, 除了硬度要求外, 还需要考虑其亚表面韧性.     

基于MATLAB的静电场模拟

在静电场中引入电位和电场强度后,通过等电位线图和场强分布图可以具体的描述静电场这种抽象的物质场。传统的静电场模拟实验直观地展现出了静电场的分布从而形象地描述了静电场,由于这种方法属于类比模拟,所以存在一定的缺陷(比如不直接,不能描述立体规律等等)。随着计算机技术的发展,利用计算机技术来模拟静电场等物质场逐渐成为趋势。通过借鉴大量资料简要地介绍了如何利用计算机模拟静电场,如何利用MATLAB软件模拟静电场的问题。     

Dynamics and formation of vortices collapsed from ring dark solitons in a two-dimensional spin–orbit coupled Bose–Einstein condensate

We consider the dynamics and formation of vortices from ring dark solitons in a two-dimensional Bose–Einstein condensate with the Rashba spin–orbit coupling based on the time-dependent coupled Gross–Pitaevskii equation. Compared with previous results, the system exhibits complex dynamical behaviors in the presence of the spin–orbit coupling. With the modulation of the spin–orbit coupling, not only the lifetime of ring dark solitons is greatly prolonged, but also their attenuation kinetics is significantly affected. For two shallow ring dark solitons with the equal strength of the spin–orbit coupling, the radius of ring dark solitons increases to a maximum value over time and then shrinks into a minimum value. Due to the effect of the snake instability, ring dark solitons split into a series of ring-like clusters of vortex pairs, which perform complex oscillations. This indicates that the system is strongly dependent on the presence of the spin–orbit coupling. Furthermore, the effect of different initial modulation depths on the dynamics of ring dark solitons is investigated.     

38≤Z≤42类钴离子n =3、Δn=0跃迁的理论计算

用多组态自洽场方法,结合作者提出的半经验拟合公式,首先对38≤Z≤42类钴离子3p63d9,3p53d10,3p63d84p组态的能级进行计算,然后根据能级值算出相应的电偶极跃迁的谱线波长,并给出各谱线的HFR振子强度。     

低雷诺数反齐默曼机翼的气动特性

通过PISO方法求解非定常不可压N-S方程,研究小展弦比反齐默曼机翼在低雷诺数下的流场特征,并分析其对气动特性的影响.结果显示前缘分离涡在反齐默曼机翼上表面形成一对集中涡.分析表明这对集中涡是影响反齐默曼机翼气动特性的主要因素,给机翼提供了较大的非线性升力和较大的失速攻角,前缘涡之间的相互影响使得机翼出现非定常现象和大攻角的非对称现象.与矩形翼相比,反齐默曼机翼有较好的稳定性.     

基于布拉格光栅的边坡监测实验研究

提出了一种基于分布式光纤光栅的边坡监测与报警系统.根据强度折减法,利用ANSYS软件分析出边坡的软弱面及滑体所在的具体位置,从而在该处安装经过特殊封装的拉线式光纤光栅位移传感器.滑体的位移通过拉线转换为作用在光栅上的应力,而光纤光栅反射波长与应变具有良好的线性关系,因此通过检测光栅反射光的中心波长的偏移量,就可以解调出...     

Electric field‐induced birefringence,optical rotatory power and conoscopic measurements of a chiral antiferroelectric smectic liquid crystal

Using a photoelastic modulator‐based novel set‐up, the electric field‐induced in‐plane birefringence and the optical rotatory power (ORP) were measured of an antiferroelectric liquid crystalline compound (12OF1M7) in its various phases using 30 µm homeotropic cells. Some specific signatures of the in‐plane birefringence and of the ORP for the various phases are being established. A relatively small threshold field is needed for the unwinding process of the antiferroelectric phase with a unit cell of four layers [SmC_A*(1/2)] compared with that for two layers [SmC_A*(0)]. On application of the electric field on the high temperature side of the SmC_A*(1/2) phase (80.1–81.5°C), a field‐induced phase transition is shown to occur directly to the SmC* phase, whereas on the lower temperature side (79.4–80.1°C) the transition takes place to SmC* via the SmC_A*(1/3) phase. The in‐plane birefringence exhibits a critical power law dependence for the SmC*–SmA transition. The ORP changes sign within the temperature range of the phase with a unit cell of three layers, reflecting a change in the handedness during this phase. Using tilted conoscopy, the results for the biaxiality and the apparent tilt angle for a smectic liquid crystal with a tilt angle greater than 18° in the ferroelectric phase are reported. The biaxiality implies the difference in the refractive indices between the two minor axes of the refractive index ellipsoid. The optical transmittance at visible and IR wavelengths for free‐standing films reveal characteristic reflection bands for these phases. The modulated structures of the reflected bands appear just above the SmC_A* phase and below SmC_A*(1/3); these are possibly due to an easy deformation of the phase by the surfaces.     

Photosensitivity,substituent and solvent-induced shifts in UV-visible absorption bands of naphthyl-ester liquid crystals: a comparative theoretical approach

The substituent- and solvent-induced shifts in UV-visible absorption bands of naphthyl-ester nematic liquid crystals, viz., 4-octylphenyl-6-octyloxy-2-naphthoate (NAPHE1) and 6-octyloxy-2-naphthylyl-4-octyloxybenzoate (NAPHE2), have been investigated using the DFT, CNDO/S and INDO/S methods. A correlation has been made between molecular charge distribution and phase stability based on Mulliken, Loewdin, AM1, PM3, MNDO, CNDO/S and INDO/S methods. The observed π→π* and n→π* electronic transitions have been reported. The substituent- and solvent-induced shifts in absorption bands, transition energies and energy gaps have been discussed. The photosensitivity of the molecules has been analysed based on these shifts. It has been observed that the substituent has a dominant role on both absorption maxima and energy band gap, whereas the solvent has a dominant role only on absorption maxima, and no effect has been observed on the energy gap. These shifts may provide beneficial consequences in determining the end use of compounds.     

Enhanced chemical reworkability of DGEBA thermosets cured with rare earth triflates using aromatic hyperbranched polyesters (HBP) and multiarm star HBP‐b‐poly(ε‐caprolactone) as modifiers

A hyperbranched aromatic polyester (HBPOH) has been synthesized, and poly(ε‐caprolactone) arms have been grown on some of its end hydroxyl groups (HBPCL). These modifiers have been used in cationic diglycidyl ether of bisphenol A formulations cured with ytterbium triflate as cationic initiator. The effect of HBPOH and HBPCL on the curing kinetics has been studied using differential scanning calorimetry (DSC). The obtained materials have been characterized by dynamomechanical analysis, DSC, thermogravimetric analysis and mechanical tests. The modifiers are incorporated into the thermosetting network because of the participation of the end hydroxyl groups in the cationic curing of epoxides by the activated monomer mechanism. Homogeneous thermosets have been obtained with a remarkable increase in impact strength without sacrificing elastic modulus or hardness. A compromise between the rigid structure of the aromatic hyperbranched core and the flexibilizing effect of the poly(ε‐caprolactone) arms is believed to be responsible for the overall thermal and mechanical properties of the materials. The use of these polymeric modifiers increases the thermal stability of the resulting materials because of the low degradability of the aromatic ester groups in the hyperbranched core and the incorporation of the modifier into the network structure. However, the presence of such ester groups makes them reworkable by hydrolysis or alcoholysis in an alkaline medium, thus opening a way for recovery of valuable substrates. Copyright © 2013 John Wiley & Sons, Ltd.