低温太阳热能与化学链燃烧相结合控制CO2分离动力系统

本文探索并提出控制CO2分离的低温太阳热能与清洁合成燃料甲醇-三氧化二铁化学链燃烧相结合的新颖能源动力系统。基于图象(?)分析方法,明确地指出甲醇化学链燃烧能量释放过程燃烧堋损失减小和低温太阳热能品位提升的机理。从能源有效利用和环境相容出发,研究和揭示化学链燃烧与太阳能有机整合共同减小CO2分离能耗的特性规律。相比不分离常规联合循环,新系统(?)效率提高约6．2个百分点;与分离CO2的联合循环相比,新系统媚效率提高约14．2个百分点。同时,低温太阳热能热转功效率可达到22．5％。     

Nusselt number correlations for heat transfer to small spheres in thermal plasma flows

Seven different equations predicting heat transfer rates to small spheres in plasma flows are examined considering argon and nitrogan as plasma gases from 300 to 21,000 K at 1 atm. For argon there is a general consensus up to 9000 K, beyond which wide deviations in behavior occur. For nitrogen, the seven correlations are in good agreement up to 4000 K, but show substantial deviations beyond this value. Comparisons with the sparsely available experimental data are made for argon from 300 to 17,000 K and for nitrogen up to 5500 K. Disagreement between the various correlations and experiment can exceed one order of magnitude.     

Evaluation of PLE exhaustiveness for the extraction of PCBs from sediments and the influence of sediment characteristics

Pressurized liquid extractions were performed on eight sediments in order to investigate if a modified US EPA method (100 °C, 100 bar, n-heptane/acetone (1:1), 2 × 5 min) provided exhaustive extractions of polychlorinated biphenyls (PCBs) from sediment, and to study if the extractability of PCBs from the different sediments was affected by characteristics of the sediment. The recovery from the eight native sediments, contaminated in nature, was between 96.4% and 98.9%, as an average of the recoveries from 10 PCB congeners. Hundred percent recovery was defined as the sum of two consecutive extractions (2 × 5 min each) at the stated conditions. The recoveries of the individual congeners were above 94%, except for one congener in one sediment, which had a recovery of 92%. When the recoveries and different characteristics of the sediments were compared, no correlation appeared between recoveries and sediment PCB concentration, total organic carbon (TOC), soot carbon (SC) or amorphous carbon (AC). The fact that carbon did not influence the extractions was somewhat surprising, since previous experiments have indicated a connection. Instead, statistically significant (p < 0.05) correlations were observed for water content and carbon/nitrogen (C/N) ratio. The decrease in recoveries with decreased water content was attributed to less access of the solvent to the analytes due to less matrix swelling. The lowered recoveries with increased C/N ratio can indicate that a difference in structure of the organic matter exists, which influences the binding strength between the analytes and the matrix. The difference in structure can possibly be explained by different origin of the organic matter or by aging effects. Overall the method was found to be exhaustive and the excellent recoveries show that sediment characteristics do not influence the extractions markedly.     

超稳定TO-8型压力传感器在气体导热系数测定实验中的应用

介绍了TO-8型压力传感器的性能及电源电路.以气体导热系数测定实验为例,用TO-8型压力传感器制成的测压装置代替旋转式麦氏真空计,利用可调针孔式放气阀对真空气压进行连续调节,实现了对测试系统真空度的实时监测.     

Elastic and Thermophysical Properties of Poly(Vinyl Chloride) and Chlorinated Polyethylene Blends

The results of experimental and theoretical investigations of elastic and thermophysical properties of poly(vinyl chloride) (PVC) and chlorinated polyethylene (CPE) blends are presented. Eight types of specimens with different ratios of weight contents of PVC and CPE (PVC/CPE = 100/0, 90/10, 80/20, 60/40, 40/60, 20/80, 10/90, and 0/100) were tested. The effect of blend composition on the elastic constants (tensile and shear modulus) is discussed. The data on the thermal conductivity, thermal diffusivity, and heat capacity of the blends investigated are also presented.     

Assessment of thermal expansion coefficient of methylsilsesquioxane thin film

For the methylsilsesquioxane film whose optical birefringence is almost zero, it was recently reported that its vertical thermal expansion coefficient (CTE) was approximately one order of magnitude larger than the lateral CTE. Though the birefringence is not an absolute predictor of anisotropic behavior, the discrepancy in both the CTEs was so remarkable that it was essential to investigate whether the anisotropy was intrinsic property or not. If the effect of Poisson's ratio is considered in the calculation of the vertical CTE and when elastic modulus measured by surface acoustic wave spectroscopy is used in the assessment of the lateral CTE, both the CTEs are coincident with each other. Therefore, it can be concluded that the discrepancy in the CTEs can be attributed to a higher in‐plane polymer chain orientation but it can also arise from the misleadingly assumed modulus and Poisson's ratio. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3109–3120, 2006     

The transition of spontaneous polymerization of acrylamide to “explosive” regime

Experimental results related to the transition of spontaneous polymerization of acrylamide complexes with metal nitrates to the “explosive” regime at room temperature are presented. It is suggested that the “explosion” has a thermal nature. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 859–861, April, 1997.     

Alloy formation in mechanically activated mixtures

The physical mixtures of hydroxocarbonates of Cu and Ni with aluminium were activated using a laboratory planetary mill. The chemical reactions and alloy formations as the effects of grinding were followed by the phase analysis of solid products based on the thermogravimetry and X-ray diffractometry. Experimental evidence indicates that the nature of reactions and products of mechanical activation was dependent on the amount of aluminium and time of grinding. This revised version was published online in July 2006 with corrections to the Cover Date.     

Dehydration and dehydroxylation of reduced charge montmorillonite

Reduced charge montmorillonites (RCM) were prepared by the thermal treatment of lithiumsaturated montmorillonite. Samples prepared by mild thermal treatment with lithium contained more water sorbed than the original montmorrilonite. When RCMs were prepared, part of the lithium cations reacted with hydroxyl groups in the octahedral sheet and released protons, which reacted with the structure. Acid treatment probably enhanced the surface area. which was reflected in the amount of water sorbed. Deprotonation of hydroxyl groups was proved by the measurements of the ignition loss. The heating of lithium saturated montmorillonite at higher temperatures brough about the collapse of the interlayers and a decrease in the amount of water sorbed.     

Parameter determination of a thermal desorption model

A new method for the analysis of thermal desorption spectra is presented, based on the experimental peak maximum functions for temperatureT _m(β) and pressureP _m(β) and a rigorous mathematical treatment. The resonant heating rate β_r is determined, satisfyingT _m(β_r)=T _r, whereT _r is the resonant temperature defined byA exp(−E _d/(RT _r))=1. Desorption energyE _d and frequency factorA can be determined simultaneously with relatively high robustness towards statistical experimental errors as demonstrated by computer-simulated thermal desorption spectra.