Effect of take-up speed on physical properties and permeation performance of cellulose acetate hollow fibers

Cellulose acetate (CA) ultrafiltration hollow fibers were spun via the dry-jet wet spinning technique. The effect of the take-up speed on the mechanical properties, morphology, thermal properties, pure water permeation, retention, and surface characterization of hollow fiber membranes were investigated. Both the inner and outer diameters of the hollow fiber decreased with the increase of take-up speed. Macrovoids were observed on the inner surface of the drawn hollow fibers. The d-space decreased with the increase of the take-up speed. The ultimate tensile stress (UTS) increased and the breaking elongation decreased with the increase of take-up speed. The permeation performance was measured. The hydraulic permeability increased and the retention decreased slightly with the increase of the take-up speed. The surface roughness increased with the increase of the take-up speed. The thermal analysis results showed that the endothermic peak shifts to the higher temperature region and coefficient of thermal expansion (CTE) decrease for a higher take-up speed.     

On the self-association of the normal alcohols and the glass transition in alcohol-alcohol solutions

The glass-transition temperature (T_g) in mutual binary mixtures of the primary alkanols from methanol throughn-octanol has been measured as a function of composition. For mixtures of the alkanols heavier than ethanol,T _g is found to be a linear function of the number-average molecular length. Methanol and ethanol mixtures show higherT _g values than indicated by this relation. These results are found to be consistent with association of the heavier alkanols into chains of very great length in the supercooled liquid, while ethanol and methanol must form networks with a moderate degree of crosslinking between chains.     

Emission characteristics of high-powered microwave induced plasma optical emission spectrometry by using nitrogen–oxygen mixture gas

A high-powered, microwave-induced nitrogen–oxygen plasma (N₂–O₂–MIP) generated by using an Okamoto cavity at atmospheric pressure was investigated when the observation height, the flow rate of carrier gas, and the oxygen content were varied as the experimental parameters. The emission characteristics of the plasma were evaluated with regard to the excitation temperature and the intensity ratio of atomic line to ionic line. The excitation temperature of the N₂–O₂–MIP was in the range of 5100–5700 K when the oxygen content was varied from 0 to 30% at the observation height of 7 mm and the carrier gas flow rate of 0.6 l/min. The intensity ratio of atomic line to ionic line was elevated with an increase in the oxygen content.     

Dipolar relaxations in an epoxy-amine system

Dipolar relaxations in a reactive epoxy-amine system based on diglycidyl ether of bisphenol A with 4,4^′-diaminodiphenylsulfone were studied with the Havriliak-Negami function. The system was cured isothermally at 140 °C using simultaneous kinetic and microdielectric studies.The relaxation time was calculated from the frequency f_max of the peak of the loss factor ε^′′ versus frequency f. A linear relation exists between the logarithm of the relaxation time τ and the glass transition temperature T_g. Then, logτ follows the Di Benedetto equation revisited by Pascault and Williams allowing the prediction of the relaxation time τ during cure.The unrelaxed permittivity at high frequency ε_u, the relaxed or static permittivity ε_s and the skewness parameter β were found independent on the conversion or the curing time. The distribution parameter α decreases as curing time t increases. The difficulty of orientation of dipoles in the electric field due to vitrification is responsible of these behaviours.     

Perfluoro-1,3,5-tris(p-oligophenyl)benzenes: Amorphous Electron-Transport Materials with High-Glass-Transition Temperature and High Electron Mobility

Perfluoro-1,3,5-tris(p-quaterphenyl)benzene (PF-13Y) and perfluoro-1,3,5-tris(p-quinquephenyl)benzene (PF-16Y) have been synthesized and characterized. They showed higher glass transition temperatures compared with perfluoro-1,3,5-tris(p-terphenyl)benzene (PF-10Y). Organic light-emitting diodes were fabricated using these materials as the electron-transport layers. PF-13Y and -16Y are better electron transporters than PF-10Y. The electron mobilities of PF-10Y and Alq₃ were measured by the time-of-flight technique. PF-10Y showed higher electron mobilities (10⁻⁴ cm²/V s) and weaker electric field dependence compared with Alq₃.     

Fractionation and purification of antioxidant peptides from Chinese sturgeon (Acipenser sinensis) protein hydrolysates prepared using papain and alcalase 2.4L

Protein hydrolysates have the potential to be natural and safer sources of bioactive peptides. In this study, two proteases were used to hydrolyze Chinese sturgeon (Acipenser sinensis) protein, and the hydrolysates were then purified to yield antioxidant peptides. The degree of hydrolysis of 23.56 % and 18.14 % was obtained using papain and alcalase 2.4L, respectivly, and hydrolysates had 96.80 % and 87.24 % total amino acid content, respectivly. The papain hydrolysate (PH) and alcalase 2.4L hydrolysate (AH) showed good antioxidant activity against DPPH^? (IC₅₀ of 3.64 and 3.15 mg/mL) and ABTS^?+ (IC₅₀ of 1.92 and 1.58 mg/mL), respectively. The low-molecular-weight (<1000 Da) fraction of both hydrolysates demonstrated the highest antiradical activity (IC₅₀ of 2.59 and 2.31 mg/mL, DPPH) and (IC₅₀ of 1.54 and 1.36 mg/mL, ABTS), respectively. Nine peptides were separated from both hydrolysates using reverse phase high performance liquid chromatography (RP-HPLC). The IC₅₀ for ABTS^?+ scavenging activity of peptide P5 with valine, glycine and asparagine (MW of 282.13 Da) from PH, and peptide P3 with histidine, glycine and alanine (MW of 302.74 Da) from AH was 0.89 and 0.72 mg/mL, respectively. The fractions and purified peptides obtained from Chinese sturgeon hydrolysates could be utilized as natural antioxidant substitutes in pharmaceuticals and food products.     

Use of 1-alkyl-3-methylimidazolium hexafluorophosphate room temperature ionic liquids as chelate extraction solvent with 4,4,4-trifluoro-1-(2-thienyl)-1,3-butanedione

Possible use of room temperature ionic liquids (RTILs) as chelate extraction solvent was evaluated by using 1-butyl-3-methylimidazolium hexafluorophosphate ([bmim][PF₆]), 1-hexyl-3-methylimidazolium hexafluorophosphate ([hmim][PF₆]) and 1-octyl-3-methylimidazolium hexafluorophosphate ([omim][PF₆]). These RTILs showed high extraction performance for divalent metal cations with 4,4,4-trifluoro-1-(2-thienyl)-1,3-butanedione (Htta). The extracted metals were back-extracted into 1 mol dm⁻³ nitric acid quantitatively. Furthermore, the extracted species were estimated as neutral hydrated complexes M(tta)₂(H₂O)_n (n= 1 or 2) for M = Ni, Cu and Pb and anionic complexes M(tta)₃⁻ for M = Mn, Co, Zn and Cd.     

Preparation and characterization of dendrimer-star PNIPAAM using dithiobenzoate-terminated PPI dendrimer via RAFT polymerization

Two dendritic reversible addition-fragmentation transfer (RAFT) agents with 8 and 16 terminal dithiobenzoate (DTB) groups on the surface of poly(propylene imine) (PPI) dendrimers (generation 2.0 and 3.0, respectively) were successively prepared, and they were used in the RAFT polymerization of N-isopropylacrylamide (NIPAAM). The polymerization kinetics was confirmed to pseudo-first-order behavior. The ¹H NMR and GPC analyses show that the dendrimer-star den (NIPAAM)_x (x = 8 or 16) prepared by RAFT method has well-defined structure, controlled molecular weight and low polydispersities (PDI < 1.3). The aqueous solution prepared from dendrimer-star PNIPAAM showed reversible changes in optical properties: transparent below a lower critical solution temperature (LCST) and opaque above the LCST.     

全自动高温水解-离子色谱法测定氧化镧铈中氟、氯

为探究稀土氧化物中氟(F)和氯(Cl)元素含量的快速检测方法,通过全自动高温水解仪对氧化镧铈样品进行前处理,并利用氢氧根体系离子色谱仪检测吸收液中F-、Cl-离子的含量,建立了基于全自动高温水解-离子色谱法测定氧化镧铈中的F、Cl元素含量的快速检测方法,该方法有效避免了传统前处理方法过程复杂、分析时间慢、极易受人为干扰的问题。称取0.3g氧化镧铈样品,在氧气流量为300 mL/min,1100 ℃高温下水解燃烧20 min,吸收定容为体积20mL的吸收液,以NAOH(15mmol/L)作为淋洗液,经色谱柱分离,测得F-与Cl-在质量浓度为1.00 mg/L-15.00 mg/L范围内,质量浓度与离子色谱峰面积呈线性关系,相关系数均为0.9999。检出限分别为0.003mg/L和0.12mg/L。全自动高温水解仪联用离子色谱仪检测系统对氧化镧铈中F-的平均加标回收率测定结果为98.4%,标准偏差RSD为0.94%;对Cl-的加标回收率测定结果为97.8%,RSD为2.86%。说明该方法较高准确度及精密度,测试结果准确可靠满足企业和检测机构的测试需求,为稀土氧化中氟、氯元素含量的研究及相关产品的开发提供了理论基础。