Asymptotic Methods Applied to Contact Problems

Asymptotic methods for contact problems are expounded. Some typical integral equations are considered     

数码相机原理与系统设计研究

介绍了数码相机的工作原理 ,分析了数码相机的系统结构 ,提出了设计数码相机的处理流程。典型的数码相机系统有镜头、闪光灯、光学取景器、LCD显示屏、图像数据存储扩展设备接口、图像数据传输接口、供电系统以及核心处理器等八个主要模块。数码相机的数据流向从图像传感器开始 ,止于图像数据的存储和传输。数据流的处理主要包括模数转换、光学黑电平钳位、针对镜头的边缘畸变的运算修正、坏像素处理、白平衡处理、伽马校正、色彩合成处理、边缘检测 (锐度检测 )和伪彩色检测 (伪彩色抑制 )、JPEG压缩和图像存储器等模块     

Zeeman transitions in deuterium atoms induced by ultra-relativistic electrons

We present data showing hyperfine transitions in an atomic deuterium beam induced by the (476 MHz) radio-frequency field of a 704 MeV electron beam in a storage ring. A polarized deuterium beam, produced in an atomic beam source, was crossed with a stored electron beam and analyzed with a Breit--Rabi polarimeter. Electron-beam induced transitions were singled out by injecting different combinations of hyperfine states. Transition probabilities as high as 70% were measured at large currents (~ 100 mA). All possible deuterium transitions for a radio-frequency of 476 MHz were observed. In addition, a 1--6 transition resulting from the first harmonic (952 MHz) was observed. The effects of these transitions are of general importance for the polarized internal target technique applied in nuclear and particle physics experiments. The data are reasonably described by numerical estimates. The observed mechanism can be exploited to create nuclear polarized atoms when injecting electron polarized atoms with no net nuclear polarization into a storage cell. However, when nuclear polarized atoms are injected, care should be taken to avoid this mechanism, since it would result in depolarization of the atoms. The studies enabled us to choose the magnetic guide field during our spin-dependent electron--deuteron scattering experiments, such that electron-beam induced depolarizing effects were avoided. This revised version was published online in July 2006 with corrections to the Cover Date.     

转动喇曼散射截面的群论计算

本文利用群链U(4)U(3)O(3)描述双原子分子N_2和O_2振转谱的对称性质,并利用群论方法计算了N_2和O_2分子转动喇曼散射的跃迁矩阵元,给出了它们的转动喇曼散射的截面。结果与实验较好地符合。     

Quantitative evaluation of two-dimensional dynamic deformations using digital holography

An optical system for the parallel evaluation of in- and out-of-plane dynamical deformations will be described. A double pulse laser with pulse separation in the microsecond range is used for the investigations. Two separate interferograms of an object under test, in its undeformed and deformed state, are recorded in a few microseconds. The object is illuminated from two different directions and imaged onto a CCD sensor. This produces two sensitivity vectors. The reference beams have different directions in order to produce two directional spatial carriers. The Fourier method is used for quantitative evaluation, and the measurements along different sensitivity vectors are separated in the Fourier domain. The phases of the two interferograms are obtained from the complex amplitudes and the two dimensional deformation is calculated from the phases. Experimental results are presented.     

Trefftz,collocation, and other boundary methods—A comparison

In this article we survey the Trefftz method (TM), the collocation method (CM), and the collocation Trefftz method (CTM). We also review the coupling techniques for the interzonal conditions, which include the indirect Trefftz method, the original Trefftz method, the penalty plus hybrid Trefftz method, and the direct Trefftz method. Other boundary methods are also briefly described. Key issues in these algorithms, including the error analysis, are addressed. New numerical results are reported. Comparisons among TMs and other numerical methods are made. It is concluded that the CTM is the simplest algorithm and provides the most accurate solution with the best numerical stability. © 2006 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq, 2007     

A nodal coupling of finite and boundary elements

This article presents and analyzes a simple method for the exterior Laplace equation through the coupling of finite and boundary element methods. The main novelty is the use of a smooth parametric artificial boundary where boundary elements fit without effort together with a straight approximate triangulation in the bounded area, with the coupling done only in nodes. A numerically integrated version of the algorithm is also analyzed. Finally, an isoparametric variant with higher order is proposed. © 2003 Wiley Periodicals, Inc. Numer Methods Partial Differential Eq 19: 555–570, 2003     

高能闪光照相对电子束参数的要求

对高能闪光机光源性能用Monte-Carlo方法模拟研究发现：并非击靶电子束半径越小、发射度越低, 闪光机的照相性能就会越好. 研究结果表明：为了使闪光照相图像视面上照射量分布比较均匀, 对束半径与电子束归一发射度有一个联合限制, 对于20MeV闪光机, 如果击靶电子束有效半径是0.12cm, 那么仅当束归一发射度≥550cm.mrad时,在2°内的照射量不均匀性才小于5%.     

Sparse generalized Fourier transforms

Block-diagonalization of sparse equivariant discretization matrices is studied. Such matrices typically arise when partial differential equations that evolve in symmetric geometries are discretized via the finite element method or via finite differences. By considering sparse equivariant matrices as equivariant graphs, we identify a condition for when block-diagonalization via a sparse variant of a generalized Fourier transform (GFT) becomes particularly simple and fast. Characterizations for finite element triangulations of a symmetric domain are given, and formulas for assembling the block-diagonalized matrix directly are presented. It is emphasized that the GFT preserves symmetric (Hermitian) properties of an equivariant matrix. By simulating the heat equation at the surface of a sphere discretized by an icosahedral grid, it is demonstrated that the block-diagonalization is beneficial. The gain is significant for a direct method, and modest for an iterative method. A comparison with a block-diagonalization approach based upon the continuous formulation is made. It is found that the sparse GFT method is an appropriate way to discretize the resulting continuous subsystems, since the spectrum and the symmetry are preserved. AMS subject classification (2000)  43A30, 65T99, 20B25     

Slow positron beam study of corrosion-related defects in pure iron

Corrosion-related defects of pure iron were investigated by measuring Doppler broadening energy spectra (DBES) of positron annihilation and positron annihilation lifetime (PAL). Defect profiles of the S-parameter from DBES as a function of positron incident energy up to 30 keV (i.e. ∼1 μm depth) were analyzed. The DBES data show that S-parameter increases as a function of positron incident energy (mean depth) after corrosion, and the increase in the S-parameter is larger near the surface than in the bulk due to corrosion. Furthermore, information on defect size from PAL data as a function of positron incident energy up to 10 keV (i.e. ∼0.2 μm depth) was analyzed. In the two-state trapping model, the lifetime τ₂ = 500 ps is ascribed to annihilation of positrons in voids with a size of the order of nanometer. τ₁, which decreases with depth from the surface to the bulk, is ascribed to the annihilation of positrons in dislocations and three-dimensional vacancy clusters. The corroded samples show a significant increase in τ₁ and the intensity I₂, and near the surface the corroded iron introduces both voids and large-size three-dimensional vacancy clusters. The size of vacancy clusters decreases with depth.