Characterization of plant oils on a monolithic silica column by high-performance liquid chromatography-atmospheric pressure chemical lonization-mass spectrometry

Summary Five plant oils (peanut, pumpkin seed, sesame seed, soybean, and wheat germ) have been analyzed by high-performance liquid chromatography-atmospheric pressure chemical ionization-mass spectrometry (HPLC-APCI-MS). Gradient elution was performed with acetone-acetonitrile mobile phases on a short monolithic silica column (SilicaROD, RP-18e, 50 mm×4.6 mm). Identification of plant oil triacylglycerols (TAG) was based on the pseudomolecular ion [M+H]⁺ and the diacylglycerol [M−RCO₂]⁺ fragments. Positional isomers of triacylglycerols were identified from the relative intensities of the [M-RCO₂]⁺ fragments. Principal-component analysis, used to find similarities and differences between the different oils, indicated that the different plant oils could be clearly differentiated according to their triacylglycerol composition. Presented at Balaton Symposium '01 on High-Performance Separation Methods, Siófok, Hungary, September 2–4, 2001     

The application of dielectric analysis to drying latex films

Measurements of real and imaginary capacitance (C andC) have been made during the drying of a film-forming latex. In one experiment dielectric measurements at frequencies between 1 Hz and 100 kHz were made simultaneously with gravimetric measurements on a microbalance. It was found that both the rate of water evaporation and the a.c. conductance decrease sharply at high polymer volume fraction. These results are discussed qualitatively in terms of a model for the film-forming process. In another experimentC andC were recorded at 10 Hz along with automatic measurements of the build-up of the scratch resistance of the film. It was found that the mechanical response to film-formation appears significantly earlier than the dielectric response. This is also discussed qualitatively in terms of the model.The authors would like to thank Dr. I. Abrahams, Dr. S. Bell, and Dr. M. Reading for useful discussions regarding this work and M. Bahra for his help with the TFA measurements.     

Influence of surface structure on surface analytical statements

The influence of surface structure of technical materials on results and statements of surface analytical methods has been investigated. Especially surface roughness as a typical property of rolled products has been observed. For this purpose samples of steel (technical surface, roughness up to 5 m) and silicon wafers (polished surface) have been analyzed by SNMS and GDOS in order to get information about changes of the surface roughness as function of the sputtering time and their influence on the statements about the depth profiles obtained.     

2-Polyfluoroalkylchromones. 9. Synthesis and structures of 5-(2-hydroxyaryl)-7-polyfluoroalkyl-1,4,8-triazabicyclo[5.3.0]dec-4-enes

2-Polyfluoroalkylchromones reacted with diethylenetriamine at 20 °C to form the corresponding 1,4,8-triazabicyclo[5.3.0]dec-4-ene derivatives. The crystal structures of 5-(2-hydroxyphenyl)-7-trifluoromethyl-1,4,8-triazabicyclo[5.3.0]dec-4-ene and 1-(2-aminoethyl)-7-(2-hydroxy-5-methoxyphenyl)-5-(1,1,2,2-tetrafluoroethyl)-2,3-dihydro-1H-1,4-diazepine were established by X-ray diffraction analysis.     

Qualitative evaluation of aromatic herbs by direct headspace GC analysis. Applications of the method and comparison with the traditional analysis of essential oils

GC headspace analyses of various aromatizing herbs have been compared with those relating to the essential oils, obtained by steam distillation, of the same plants. In this way it was possible to establish the most significant differences between the composition of a herb flavor and that of its essential oil. In particular, we observed some very volatile compounds in the headspace samples which were absent from the essential oil; these components may make an important contribution to the herb flavor. The identification of these substances is still in progress.     

ESCA: Electron Spectroscopy for Chemical Analysis

A substance on which X-rays fall emits photoelectrons and Auger electrons. The energy spectra of the electrons emitted provide information about the electronic structure in the specimen, ranging from the innermost atomic levels and their dependence on the chemical environment to the molecular orbitals of the valence electrons and the band structure in solids. Electron spectra of this nature can now be recorded with high-resolution instruments; their analysis offers new aspects for investigation of chemical composition. The method of electron spectroscopy developed for this purpose, which has now been developed to a high degree of perfection, will be referred to in the following discussion as ESCA (Electron Spectroscopy for Chemical Analysis).     

Fast solid-phase extraction-gas chromatography-mass spectrometry procedure for oil fingerprinting. Application to the Prestige oil spill

A rapid and simple fractionation procedure using solid-phase extraction (SPE) cartridges was developed for an accurate determination of aliphatic and polycyclic aromatic hydrocarbons in petroleum residues and further application in chemical fingerprinting of oil spills by gas chromatography-mass spectrometry (GC-MS). Among the adsorbents evaluated, SiO2/C3-CN exhibited the best selectivity, providing, by elution with n-hexane (4 ml) and n-hexane-CH2Cl2 (1:1) (5 ml), two well-resolved aliphatic and aromatic hydrocarbon fractions, with recoveries of 97 +/- 7.2 and 99.7 +/- 13.9%, respectively. The SPE fractionation procedure was compared with the conventional silica-alumina adsorption chromatography showing similar results but practical advantages in terms of reproducibility, analysis time, solvent reduction and cost. Moreover, is particularly suitable for routine analysis with a high sample throughput. The developed methodology was tested in the characterization of fuel-oil samples collected along the Spanish north-west coast, after the Prestige oil spill accident.     

Element-selective detection using capillary gas chromatography with atomic emission detection

Capillary GC coupled to an atomic emission detector (AED) provides a powerful new hyphenated technique for the separation and characterization of complex mixtures and compounds. The AED provides simultaneous and truly specific multi-element detection. The specificity of detection reduces the need for the complex sample pretreatment procedures which are necessary to reduce the interference from co-eluted substances which is experienced with detectors such as the FID and the ECD. A range of environmentally significant problems has been studied, including PCB analysis, the characterization of the reaction products of a novel waste treatment process, and the profiling of sulfur-containing species formed by the pyrolysis of various types of coal.     

Significance of Non-isothermal Kinetic Data. A statistical study

Arrhenius parameters values, in non-isothermal kinetic vaporisation processes for a series of compounds with related structures, have been calculated. This was made using a method of calculation that allows to find the most probable vaporisation mechanisms. According to this method DTG curves were compared with some theoretical ones reported in literature, whose shape results to be only a function of the mechanisms. In this way the choice of the mathematical functions which can be inserted in the kinetic equations, was influenced by the shape of the DTG plots and other thermal analysis signals thus allowing to choose the most probable mechanisms. The kinetic parameters derived from these mechanisms were compared, using statistical analysis, with those obtained from another method of calculation based on ‘a priori’ vaporisation mechanism chosen for the investigated liquid–gas transition. The standard deviations of the slope and of the intercept, together with the standard deviation and the square correlation coefficient (r ²) of the linear regression equations related to the mechanisms of the two methods were calculated. Student t-test, Fisher F-test, confidence intervals (c.i.) and residuals valueswere also given. Statistical analysis shows that the mechanisms obtained with the former method (diffusive and geometrical models) and the related Arrhenius parameters result to be more significant (in terms of probability) than the corresponding quantities of the latter for which a first-order model was chosen. This revised version was published online in August 2006 with corrections to the Cover Date.     

Capillary Zone Electrophoresis of some organic acids in milk whey

This paper describes a method for analysing some acids of milk whey by Capillary Zone Electrophoresis. After eliminating the whey proteins by ultrafiltration, the whey underwent electrophoretic separation in the presence of anodic electroosmotic flow. The following analytes were detected: citric, orotic, uric, and hippuric acids. A procedure is described for sample preparation and the operating conditions for electrophoretic capillary separation established. Finally, orotic acid is quantitatively determined.