Instantaneous strain recovery elasticity and endothermic heat change in nylon-6 monofilaments and silicone rubbers

The instantaneous elastic moduli for a nylon-6 monofilament were derived on strain recoveries right after creep, stress relaxation, and rapid elongation,E _c ,E _s andE _e , respectively. It was found that during strain recoveryE _s (>E _e ) andE _e increase monotonically with increasing load,m ₁, on the sample. The extrapolated value of E_s atm ₁=0 g is almost equal to Young's modulus, 4.06 GPa. The value ofE _c also increased with increasingm ₁, and atm ₁=600 g (1.93 t cm^–2) reached about 14 GPa. The endothermic heat change right after creep, stress relaxation or rapid elongation,Q, was negligibly small. For comparison,E _s ,E _c andQ were also investigated for silicone rubber. It was found thatE _s (53.8 M Pa at the draw ratioD=1.2) decreased abruptly atD=1.3. In the range ofD=1.4–1.9,E _s was only 22.6 MPa. In the case of stress relaxation,Q increased with increasingD from 4 J mol^–1 (atD=1.2) to 56 J mol^–1 (atD=1.9). FurthermoreE _c (5.58 MPa atm ₁=133.8 g (429.4 kg cm^–2)) increased gradually with increasing m₁ and attained 16.6 MPa atm ₁=548.4 g (1.76 t cm^–2). In the case of creep,Q was in the range of 0–11.5 J mol^–1 and larger when larger loads,m ₂ were removed during the later stages of creep.Dedicated to Professor Bernhard Wunderlich on the occasion of his 65th birthdayThe author wishes to thank Mr. Keizi Igarashi and Mr. Tetsuya Yasui for helping in the experiments.     

Rheology of polystyrene solutions around the coil overlapping concentration: A phenomenological description of stresses in simple shear flow

Linear viscoelasticity behavior is described with the sum of two terms for polystyrene solutions in tricresyl phosphate around the coil overlapping concentration (K. Osaki, T. Inoue, & T. Uematsu, J Polym Sci Part B: Polym Phys 2001, 39, 211). One is a Rouse–Zimm (RZ) term represented by the Zimm theory with arbitrarily chosen values of the hydrodynamic interaction parameter and the longest relaxation time (τ_RZ). The other (the L term) consists of a relaxation mode with a single relaxation time (τ_L > τ_RZ) and a high‐frequency limiting modulus proportional to the square of the concentration. In this study, we describe the viscosity (η) and first normal stress coefficient (Ψ₁) in steady shear with simple formulas. The stress due to the L term is assumed to be given by a Kaye, Bernstein, Kearsley, and Zapas (K‐BKZ) equation with the damping function h(γ) = (1 + 0.2γ²)^?1/2, where γ is the magnitude of shear. Contributions to η and Ψ₁ from the RZ term are derived from the RZ model, in which the relaxation time in steady flow is given by τ_st = τ + (τ_RZ ? τ)/(1 + 0.35τ_RZ γ˙) instead of τ_RZ. Here, γ˙ is the rate of shear, and τ is the τ_RZ value at the infinite dilution limit. η and Ψ₁ at various concentrations for two polystyrene samples (with molecular weights of 2890 and 8420 kg mol^?1) are well described with parameters derived from dynamic viscoelasticity. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 1038–1045, 2002     

Momentum transfer in an agitated vessel with off-centred impellers

Momentum transfer was investigated in an unbaffled agitated vessel of inner diameter 0.3 m equipped with different off-centred impellers. The distribution of the shear rate on the tank wall as a function of the impeller type and Reynolds number was studied in the turbulent regime of the Newtonian liquid flow. The dependences of the averaged dimensionless shear rate, friction coefficient, and dissipated energy on the Reynolds number and eccentricity ratio were approximated using four-parameter equations. Presented at the 33rd International Conference of the Slovak Society of Chemical Engineering, Tatranské Matliare, 22–26 May 2006.     

考虑壁面滑移的Z-W流变模型及其应用

总结了聚合物熔体在剪切溶场壁面滑移研究的成果，提出了Z－W模型的物理概念。该模型考虑了界面分子链和固体壁面间解吸－吸附而发生的滑移。界面分子链和内部分子链间解缠－重新缠结而发生的表观滑移以及变形摩擦滑移。在稳态简单剪切流运过程，模型可以化简为应力和应变的二次微分方程，说明了壁面滑移来源于Cohesive滑移和Adhesive滑移两部分，对于自激振荡相关的多重内振荡和多重外振荡进行了归纳，应用统一模型定性地解释了毛细管实验中剪切应力的非线性，瞬态自激振荡、滑－粘转换和鲨鱼皮等现象，在聚合物熔体振动剪切流动（LAOS）中，统一模型可以简化为杜芬方程，通过模拟发现，该模型可解释小应变振幅下振动剪切时的线性流变行为和在大振幅振动流动中的复杂非线性行为。非线性行为与熔体粘弹性以及近壁面界面层的性质有关，统一模型在特殊情况下还可以简化Joshi模型，结构网络模型，Hatzikiriakos或等效的Graham模型，可见，Z－W模型内内涵比较丰富，适用面较广，也从一个侧面说明该模型具有相当的合理性。     

Determinations of combustion and formation enthalpies of C60 and C70

By using a micro-bomb calorimeter, the standard enthalpies of combustion of C₆₀ and C₇₀ have been determined to be - (25 947.1±8.5) and - (29 956.1 ± 8.9) kJ/mol respectively. A g. 1. c. analysis indicated that the amounts of residual organic solvents in the samples were very small, and their effects on the final results were negligible. The energy of combustion ofC60 determined in this work is in agreement in the uncertainty interval with that determined by means of traditional calorimeter using macro amount of sample. The enthalpies of formation of these two substances have been derived. The strain energies in the molecules of C₆₀ and C₇₀ were estimated by a bond energy scheme and by using corannulene as the model compound, the results estimated from different methods are very close. Project supported by the National Natural Science Foundation of China (Grant No. 29473143)     

Structural evolution of (Ca0.35Sr0.65)TiO3 perovskite at high pressures

Lattice parameters of a synthetic powder sample of Ca_0.35Sr_0.65TiO₃ perovskite have been determined by the method of Le Bail refinement, using synchrotron X-ray diffraction patterns collected at pressures up to 15.5 GPa with a membrane-driven diamond anvil cell. At ambient conditions, diffraction data were consistent with the I4/mcm structure reported previously in the literature for the same composition. Diffraction data collected at high pressures were consistent with tetragonal (or, at least, pseudo-tetragonal) lattice geometry, and no evidence was found for the development of any of the orthorhombic structures identified in other studies of (Ca, Sr)TiO₃ perovskites. Additional weak reflections, which could not be accounted for by the normal I4/mcm perovskite structure, were detected in diffraction patterns collected at pressures of 0.9-2.5 GPa, and above ∼13.5 GPa, however. Small anomalies in the evolution of unit cell volume and tetragonal strain were observed near 3 GPa, coinciding approximately with breaks in slope with increasing pressure of bulk and shear moduli for a sample with the same composition which had previously been reported. The anomalies could be due either to new tetragonal↔tetragonal/pseudo-tetragonal phase transitions or to subtle changes in compression mechanism of the tetragonal perovskite structure.     

Real-time onboard wind and windshear determination,part 2: Detection

This paper is concerned with windshear detection in connection with real-time wind identification (Ref. 1). It presents a comparative evaluation of two techniques, one based on the shear/downdraft factor and one based on the wind difference index. The comparison is done with reference to a particular microburst, that which caused the 1985 crash of Flight Delta 191 at Dallas-Fort Worth International Airport.The shear/downdraft factor has the merit of combining the effects of the shear and the downdraft into a single entity. However, its effectiveness is hampered by the fact that, in a real situation, the windshear is accompanied by free-stream turbulence, which tends to blur the resulting signal. In turn, this results in undesirable nuisance warnings if the magnitude of the shear factor due to free-stream turbulence is temporarily larger than that due to true windshear. Therefore, proper filtering is necessary prior to using the shear/downdraft factor in detection and guidance. One effective way for achieving this goal is to average the shear/downdraft factor over a specified time interval . The effect of on the average shear/downdraft factor is studied.     

STUDY ON THE DUCTILE DEFORMATION DOMAIN OF THE SIMPLE SHEAR IN ROCKS——TAKING BRITTLE FAULTS OF THE COVERING STRATA IN THE SOUTHERN JIANGSU AREA AS AN EXAMPLE

A study on the ductile deformation domain of the brittle fault in the shallow level ofthe crust is a new probe field for the modern structural geology. Taking the southern Jiang-su Province area as an example the orientation measurement of quartz crystals, the com-positional texture observation of three pressure sensitive minerals and the rheological param-eter determination of dislocation densities, etc. have been demonstrated and analysed basedon typical samples in the present paper. In addition, their generation mechanisms arealso discussed from the cataclastic rheology, the dynamic differentiation and the simpleshearing, specially, from the Ode strength theory. Finally, a generative relationship betweenthe ductile deformation domain of the brittle fault system, in the regional layer--slip andthe formation of the stratabound ore deposit is shown as well.     

Theoretical study of structure and stability of fullerene derivative: C50O

A total of eight possible isomers of C₅₀O, an oxide of fullerene C₅₀ (D_5h), have been investigated by B3LYP/3‐21G calculations. The isomer, which has an annulene‐like structure with oxygen bridging across a [5,6] type C? C bond at the site between the pole and the equatorial belt, is found being the ground state of C₅₀O. Four isomers are relatively more stable and the energy differences between them are not large. This result indicates that more than one C₅₀O isomer will coexist once C₅₀O is synthesized. The relative stabilities of the C₅₀O isomers may be determined mainly by the strain release and by the formation of the cyclic phenylene substructure at the equatorial belt of the cage. The calculated nucleus independent chemical shifts (NICS) of the C₅₀O isomers will be useful because from them one can expect outstanding NMR properties that can lead to their identification and characterization. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2005     

Norvancomycin-capped silver nanoparticles: Synthesis and antibacterial activities against E. coli

The synthesis of norvancomycin (NVan)-capped silver nanoparticles (Ag@NVan) and their notable in vitro antibacterial activities against E. coli, a Gram-negative bacterial strain (GNB), are reported here. Mercaptoacetic acid-stabilized spherical silver nanoparticles with a diameter of 16±4 nm are prepared by a simple chemical reaction. The formation process of the silver nanoparticles is investigated by UV-visible (UV-vis) spectroscopy and transmission electron microscopy (TEM). NVan is then grafted to the terminal carboxyl of the mercaptoacetic acid in the presence of N-(3-Dimethylaminopropyl)-N′-ethylcarbodiimide hydrochloride (EDAC). The TEM images of single bacteria treated with Ag@NVan show that plenty of Ag@NVan aggregate in the cell wall of E. coli. A possible antibacterial mechanism is proposed that silver nanoparticles may help destroy the stability of the outer membrane of E. coli, which makes NVan easier to bind to the nether part of the peptidoglycan structure. The antibacterial activities of silver nanoparticles on their own, together with the rigid polyvalent interaction between Ag@NVan and cell wall, enables Ag@NVan to be an effective inhibitor of GNB. This kind of bionanocomposites might be used as novel bactericidal materials and we also provide an effective synthesis method for preparing functional bioconjugated nanoparticles here. Supported by the National Natural Science Foundation of China (Grant No. 50373036) and Fok Ying Tung Education Foundation (Grant No. J20040212)