Dynamik linearer Molekülanionen in den Hydrogensulfiden von Natrium,Kalium und Rubidium: Differential-Scanning-Kalorimetrie,Röntgen- und Neutronenbeugung

Dynamical Behaviour of Linear Molecular Anions in the Hydrogensulfides of Sodium, Potassium and Rubidium: Differential Scanning Calorimetry, X-ray and Neutron Diffraction Hydrogensulfides of the alkali metals M ? Na, K, Rb were prepared in autoclaves by the reaction of the corresponding metals with H₂S and D₂S, respectively, in the temperature range from 50°C to 150°C. Differential scanning calorimetry, X-ray and neutron diffraction methods reveal that both, the HS^?-and DS^?-compounds occur in three crystalline modifications with HT ? high-, MT ? medium- and LT ? low-temperature form: The temperatures and enthalpies for the changes of modifications of the H- and D-compounds are given and the atomic arrangements revealed mainly by neutron diffraction data are discussed, in relation to, for example, size of cations.     

Total luminescence intensity (TLI) offers superior early oxidation detection in unstabilised polyethylene but is no better than FT-IR for stabilised polyolefins

In an earlier study, we have shown that chemiluminescence (CL) and the total luminescence intensity (TLI) method are highly sensitive to oxidation in degradable PE. In this study, stabilised PE and PP were characterised with CL in an inert (TLI) and in an oxygen atmosphere (CL-OIT) and the results were compared to those obtained by the commonly used techniques, FT-IR (carbonyl index (CI)) and thermal analysis (DSC-OIT). PE was aged at a low temperature (80 °C) and PP was aged at temperatures between 60 and 120 °C. Non-Arrhenius behaviour was observed in the oxidation of PP. This showed the importance of aging at a low temperature to obtain realistic results. TLI and CI of stabilised PP and most of the stabilised PE gave comparable results with the same sensitivity for oxidation detection. This was in contrast to our previous results for degradable PE. However, TLI of unstabilised PE showed earlier oxidation detection than CI, which agreed with our earlier results. TLI of PE had a higher sensitivity than CL-OIT, and both TLI and CI of PP were sufficiently sensitive to detect the effect of aging at different temperatures, whereas DSC-OIT was not.     

Copper passivity and its breakdown in sodium bicarbonate solutions: A scanning electron microscopy and x-ray photoelectron and auger spectroscopy study

Effect of bicarbonate ions on the copper passivity and its local breakdown is studied by cyclic voltammetry, Auger spectroscopy, x-ray photoelectron spectroscopy, and scanning electron microscopy. Comparing data for solutions with various sodium bicarbonate concentrations shows copper to undergo pitting in 0.02 M NaHCO₃, whereas it remains stably passive in 0.10 M NaHCO₃. Independent studies suggest that carbonates play a protective role in stabilization of the oxide-hydroxide passive film on copper.     

Hemocompatibility of poly(acrylonitrile-co-N-vinyl-2-pyrrolidone)s: swelling behavior and water states

Hemocompatibility is an essential aspect of blood contacting polymers. Knowledge of the relationship between polymer structure and hemocompatibility is important in designing such polymers. In this work, the effect of swelling behavior and states of water on the hemocompatibility of poly(acrylonitrile-co-N-vinyl-2-pyrrolidone) (PANCNVP) films was studied. Platelet adhesion and plasma recalcification time tests were used to evaluate the hemocompatibility of the films. Considering the importance of surface properties on the hemocompatibility of polymers, static water contact angles were measured by both sessile drop and captive bubble methods. It was found that, on the film surface of PANCNVP with a higher NVP content, adhered platelets were remarkably suppressed and the recalcification time was longer. The total water content adsorbed on the PANCNVP film was determined through swelling experiments performed at temperatures of interest. Differential scanning calorimetry and thermogravimetric analysis were used to probe the states of water in the films. Based on the results from these experiments, it was hypothesized that the better hemocompatibility of PANCNVP films with higher NVP contents was due to their higher free water content, because water molecule exchange at the polymer/liquid interface, facilitated by a high free water content, is unfavorable for the formation of surface bound water, which causes poor hemocompatibility. [diagram in text].     

冻干保护剂溶液低温退火特性的研究

利用差示扫描量热仪(DSC)研究了10%叔丁醇/10%蔗糖/水溶液的冻结特性, 退火温度及退火时间, 分析了溶液的退火行为. 实验结果表明, 溶液降温时, 蔗糖的存在阻碍了叔丁醇析出, 最大冻结浓缩溶液玻璃化转变温度Tg′由－32.5 ℃降低到－42.0 ℃, 升温时在－30 ℃叔丁醇发生反玻璃化. 在反玻璃化峰附近的温度进行退火可使叔丁醇充分析出, Tg′由－42.0 ℃上升到－34.9 ℃. 所需的退火时间与退火温度有关, 退火温度越接近Tg′, 所需的退火时间越长. 在－37 ℃时, 退火20 min可完全消除反玻璃化.     

Interaction of sodium cholate with dioctadecyldimethylammonium chloride vesicles in aqueous dispersion

Mixtures of dioctadecyldimethylammonium chloride (DODAC) cationic vesicle dispersions with aqueous micelle solutions of the anionic sodium cholate (NaC) were investigated by differential scanning calorimetry, DSC, turbidity and light scattering. Within the concentration range investigated (constant 1.0 mM DODAC and varying NaC concentration up to 4 mM), vesicle → micelle → aggregate transitions were observed. The turbidity of DODAC/NaC/water depends on time and NaC/DODAB molar concentration ratio R. At equilibrium, turbidity initially decreases smoothly with R to a low value (owing to the vesicle–micelle transition) when R = 0.5–0.8 and then increases steeply to a high value (owing to the micelle–aggregate transition) when R = 0.9–1.0. DSC thermograms exhibit a single and sharp endothermic peak at T_m ≈ 49 °C, characteristic of the melting temperature of neat DODAC vesicles in water. Upon addition of NaC, T_m initially decreases to vanish around R = 0.5, and the main transition peak broadens as R increases. For R > 1.0 two new (endo- and exothermic) peaks appear at lower temperatures indicating the formation of large aggregates since the dispersion is turbid. All samples are non-birefringent. Dynamic light scattering (DLS) data indicate that both DODAC and DODAC/NaC dispersions are highly polydisperse, and that the mean size of the aggregates tends to decrease as R increases.     

利用AFM和SNOM对淋巴细胞膜表面超微结构及其光学性质的初步研究

利用原子力显微镜(Atomic Force Microscopy，AFM)对淋巴细胞表面形貌进行了形态学的初步研究，观察到了其膜表面其他显微技术所不能发现的超微结构．同时也运用扫描近场光学显微镜(Scanning Near field Optical Microscopy，SNOM)对淋巴细胞进行成像，观察了其对光的透射、吸收等光学性质，并对两种成像方法进行了比较．研究发现：淋巴细胞膜表面凹凸不平，分布着大量直径几十到几百纳米不等的小颗粒；淋巴细胞中央部位有自发荧光现象．结果表明，AFM和SNOM可作为进一步探讨淋巴细胞的结构与功能关系的有力工具．     

端羟基芳香酯二醇扩链的聚氨酯－酯的DSC研究

端羟基芳香酯二醇扩链的聚氨酯－酯的ＤＳＣ研究陈静，余学海，杨昌正（南京化工学院应化系南京２１０００９）（南京大学化学系南京２１００９３）关键词嵌段聚醚聚氨酯－酯，结晶性，微观相结构，差示扫描量热法，形态结构众所周知，聚氨酯嵌段共聚物是一类结构特殊、用...     

Surface structures of adsorption layers of sodium hyaluronate and bovine serum albumin complexes on poly(γ-methyl-l-glutamate) film and their surface properties

Two-dimensional structures and characteristics of the complexes between sodium hyaluronate (NaHA) and bovine serum albumin (BSA) were studied by using a quartz crystal microbalance method and an atomic force microscope (AFM). NaHA did not adsorb on poly(-methyl-l-glutamate) (PMLG) film. On the other hand, the complexes adsorbed on it and the adsorption behaviors were found to be Langmuir types. With increasing weight ratio of BSA to NaHA, W _BSA, the adsorption constants K decreased and the saturated adsorption masses increased. The adsorbed complexes were spherical particles and at saturated adsorption states they covered compactly on the PMLG film. The mean diameters d _AFM estimated from the topographic images decreased from 70 to 54 nm with increasing W _BSA. The adhesion force F _ad and the frictional force F _f between the complex layers and the AFM tip were obtained by using the contact mode of the AFM. With increasing W _BSA, the values of F _ad decreased and the values of F _f increased. Compared with the frictional coefficient of the NaHA adsorption layer on the BSA monolayer, the values for the NaHA–BSA complex layer were found to be much higher.     

Photoinitiators with functional groups. V. New water‐soluble photoinitiators containing carbohydrate residues and copolymerizable derivatives thereof

The synthesis of new water‐soluble photoinitiators (PIs) based on hydroxyalkylphenones, benzophenones, and thioxanthones with carbohydrate residues such as glucose, cellobiose, and 1‐amino‐1‐deoxy‐D ‐glucitol (glucamine) is described. In addition, selected initiators were reacted with methacryloyl chloride to obtain copolymerizable initiators with improved migration stability. Results from photo differential scanning calorimetry and gel‐content measurements in commercially available water‐thinnable and emulsion‐type resins as well as 2‐hydroxyethyl acrylate are included. Glucose‐modified PIs gave the best results with respect to compatibility with the resin, reactivity, and gel content. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 40: 1504–1518, 2002