聚乙烯塑料在连续超临界水反应器中的油化研究

在连续超临界水（SCW）反应器中考察了反应温度、停留时间和反应压力对聚乙烯（PE）降解油化的影响。实验结果表明，在120s、25MPa下，从500℃提高到550℃，液体收率呈现先升后降的趋势，在530℃达到最大值（79%）；在520℃、25MPa下，随停留时间的延长，PE裂解程度加深，产物轻质化程度提高，导致液体收率降低，停留240s时，气体收率达到43%；反应压力对产物收率的影响较小，气、液产物中烯/烷比随反应压力的增加而增大。     

A novel method of the separation/preconcentration and determination of trace molybdenum(VI) in water samples using microcrystalline triphenylmethane loaded with salicyl fluorone

It is the first time that triphenylmethane was used as an adsorbent to preconcentrate and separate trace amount of molybdenum in water samples. The effects of different parameters, such as acidity, stirring time and various metal ions, the amounts of triphenylmethane and salicyl fluorine, etc. on the enrichment yield of molybdenum have been studied to optimize the experimental conditions. Under the optimum conditions, molybdenum can be adsorbed on the surface of microcrystalline triphenylmethane loaded with salicyl fluorone by the intermolecular action strength. The possible reaction mechanism for the enrichment of molybdenum was discussed in detail in this paper. Mo(VI) can be completely separated from Pb(II), Co(II), Cu(II), Cr(III), Ni(II), Hg(II), Zn(II), Cd(II), Fe(III) and Al(III) in the solution. The proposed method was successfully applied to the determination of trace amount of molybdenum in various water samples by spectrophotometry after preconcentration using microcrystalline triphenylmethane. The preconcentration factor is from 83 (500 ml water sample was enriched to 6.0 ml) to 166 (1000 ml water sample was enriched to 6.0 ml). The detection limit is 1.3 × 10⁻⁵ mg l⁻¹ and the linearity is maintained in the concentration range 3.8 × 10⁻³ to 0.36 mg l⁻¹ with a correlation coefficient of 0.9998. The recoveries are in the range of 93.5-104%. The relative standard deviation is 1.8-2.9%. Analytical results obtained with this novel method are very satisfactory.     

Density functional study of HO(H2O)n (n = 1–3) clusters

The hydrogen bonding complexes HO(H₂O)_n (n = 1–3) were completely investigated in the present study using DFT and MP2 methods at varied basis set levels from 6‐31++G(d,p) to 6‐311++G(2d,2p). For n = 1 two, for n = 2 two, and for n = 3 five reasonable geometries are considered. The optimized geometric parameters and interaction energies for various complexes at different levels are estimated. The infrared spectrum frequencies and IR intensities of the most stable structures are reported. Finally, thermochemistry studies are also carried out. The results indicate that the formation and the number of hydrogen bonding have played an important role in the structures and relative stabilities of different complexes. © 2004 Wiley Periodicals, Inc. Int J Quantum Chem, 2005     

Spectral Studies on Some Pyrimidine Derivatives in Different Solvents

The electronic absorption spectra of 2-aminopyrimidine (compound I), 2-amino-4-methylpyrimidine (compound II), 2-amino-4,6-dimethylpyrimidine (compound III), 2-amino-4,6-dimethoxypyrimidine (compound IV), 4-amino-2,6-dimethylpyrimidine (compound V), and 4,5-diamopyrimidine (compound VI) have been measured in water and in a series of different organic solvents. The solvent effects on the spectra are discussed and the solvent induced spectral shifts are analyzed in terms of different solute–solvent interaction mechanisms, using the multiple linear regression technique.     

液-液萃取电感耦合等离子体质谱法测定天然水中痕量稀土元素

建立了以单、二（2－乙基己基）磷酸酯混合螯合剂的庚烷溶液作为萃取剂，6.0mol/L HCl反萃取预分离富集，In和Rh做内,ICP-MS测定天然水中15种稀土元素的分析方法。方法的富集倍数为200倍，各元素的检出限范围在0.01-1.8ng/L之间，相对标准偏差RSD＜5％，萃取回收率＞93％。     

Simultaneous hydrogen and peroxide production by photocatalytic water splitting

Photocatalytic oxidation of water is a promising method to realize large-scale H₂O₂ production without a hazardous and energy-intensive process. In this study, we introduce a Pt/TiO₂(anatase) photocatalyst to construct a simple and environmentally friendly system to achieve simultaneous H₂ and H₂O₂ production. Both H₂ and H₂O₂ are high-value chemicals, and their separation is automatic. Even without the assistance of a sacrificial agent, the system can reach an efficiency of 7410 and 5096 μmol g^–1 h^–1 (first 1 h) for H₂ and H₂O₂, respectively, which is much higher than that of a commercial Pt/TiO₂(anatase) system that has a similar morphology. This exceptional activity is attributed to the more favorable two-electron oxidation of water to H₂O₂, compared with the four-electron oxidation of water to O₂.     

Preparation and characterization of functional group gradient surfaces

Functional group gradient surfaces where the density of functional groups changes gradually along the sample length were prepared. The functional group (? COOH, ? CONH₂, and ? OH group) gradient surfaces were produced by the treatment of low-density PE sheets using a corona with gradually increasing power, followed by the graft copolymerization of acrylic acid and subsequent substitution reaction of carboxylic acid groups to amide or hydroxyl groups. The prepared gradient surfaces were characterized by the measurement of water contact angle, FTIR-ATR, and ESCA. The gradient surfaces prepared can be used to systematically investigate the interactions of biological or other species in terms of the surface functional groups and their density of polymeric materials. © 1994 John Wiley & Sons, Inc.     

ADSORPTION OF 4-METHYLANILINE IN AQUEOUS SOLUTION BY BENZOYL-CONTAINING POLYMERIC ADSORBENTS

New polymeric adsorbents (ZH-02, ZH-03) containing benzoyl group for adsorbing and removing 4-methylaniline from its aqueous solutions were prepared. Studies on the isotherms and the comparison of desorption conditions evidenced through the adsorption of 4-methylaniline in water onto ZH-02 and ZH-03, namely that there are chemisorption‘s transitions at a proper higher temperature. Mini-colunm adsorption studies of 4-methylaniline on XAD-4, ZH-02 and ZH-03 at 288 K show that the breakthrough capacities are 2.39, 2.99 and 3.19 mmol/g and the total capacities are 3.45, 3.92 and 4.35 mmol/g, respectively.     

Volumetric properties of H2O, D2O, and methanol in acetonitrile at 278.15—318.15 K

The densities of H₂O, D₂O, and MeOH solutions in acetonitrile with the solute concentrations up to 0.07 molar fractions at 278.15, 288.15, 298.15, 308.15, and 318.15 K were measured using vibrating-tube densimetry with an error 8·10^–6 g cm^–3. The limiting partial molar volumes for the H/D isotopomers of water and IaII in acetonitrile (V^– ₂ ) and the isotope effects in V^– ₂ and in excess molar volumes of acetonitrile—water mixtures were calculated. Molecules of H₂O, D₂O, and IaII form associates with acetonitrile molecules via hydrogen bonds. The associates have the packing volumes close to those in the individual solute. The water and methanol molecules were assumed to be incorporated into the acetonitrile structure without substantial changes in the latter. However, this process results in some compression of the system with a simultaneous increase in its expansibility.     

Metal Oxide Film Anodes in the Electrolysis of Water or Brine

Metal (M) oxide (M: Ir, Os, Pd, Pt, Rh, Ru) together with MaO₂ and MnO₂ alone, were coated on SnO₂ films and the anode behavior was examined in 1.0 N H₂SO₄, 1.0 N NaOH and 1.0, N NaCl aqueous solutions at 25°. The results are compared with those of DSA and of metallic Pt.