考虑摆振的裂纹转子运动及阵发性混沌

在考虑含裂纹转子盘的摆振运动的情况 ,建立了盘的运动方程并进行数值求解。在裂纹很小时 ,横向振动是与转速相同的同频振动 ,而盘的摆振包含多种倍频成分。当裂纹较大时 ,横向振动会出现阵发性混沌。当摆振的幅值随时间不断增大到一定极限时 ,横向振动的稳定的周期或拟周期运动被打破 ,出现阵发性混沌。同时还出现通过拟周期进入混沌的现象。当裂纹很深时 ,会出现多个新的共振区 ,在此区域振幅迅速发散。盘的偏心距U的增大 ,会抑制混沌 ,使混沌运动锁定到周期运动     

叶片型线对离心油泵性能的影响

以65Y60型离心油泵为研究对象，研究了液体不同粘度下叶片型线对泵性能的影响。首先，利用本课题组独立开发的准三元叶片设计程序以反问题方式设计了两种型线。这两种型线叶片前半部分与原一元叶轮叶片的型线不同、后半部分与一元叶轮相同。然后在不同粘度下将三个叶轮进行性能对比实验。研究表明，叶片进口附近的型线的改变对泵性能有较大影响；适当增大叶轮后盖板流面上的叶片流体动力负荷有助于提高离心油泵输送粘油时的水力性能。     

Rigorous entropy-energy arguments

We present a method for making rigorous various arguments which predict that certain situations are unstable because of a balance of energy vs. entropy. As applications, we give yet another proof that the two-dimensional plane rotor has no spontaneous magnetization and we make rigorous Thouless' arguments on the one-dimensional Ising model with couplingJ/n ².on leave from Departments of Mathematics and Physics, Princeton University. Research partially supported by U.S.N.S.F. under grant No. MCS-78-01885.Danforth Fellow. Research partially supported by U.S.N.S.F. under grant No. PHY 78-23952.     

Third‐order Cartesian overset mesh adaptation method for solving steady compressible flows

A third‐order mesh generation and adaptation method is presented for solving the steady compressible Euler equations. For interior points, a third‐order scheme is used on Cartesian and curvilinear meshes. Concerning the mesh adaptation, the method of Meakin is also extended to third order. The accuracy of the new overset mesh adaptation method is demonstrated by a grid convergence study for 2‐D inviscid model problems and results are compared with a second‐order method. Finally, the method is applied to the computation of an inviscid 3‐D flow around a hovering blade of the ONERA 7A helicopter rotor exhibiting an improvement in the wake capture. With a 7 million point mesh, the tip vortex can be followed for more than three rotor revolutions with the third‐order method. The CPU time needed for this calculation is only 3% higher than with a conventional second‐order method. Copyright © 2007 John Wiley & Sons, Ltd.     

Quantitative methodology for stability analysis of nonlinear rotor systems

IntroductionRotor-bearings systems applied widely in industry are nonlinear dynamic systems of multi-degree-of-freedom.Synchronous vibration is its typical motion under unavoidable unbalance.Subharmonic,quasi-periodic and chaotic vibrations,caused by the …     

用机电耦合模型研究转子系统的非平稳过程

建立恰当的转子系统模型,对非平稳过程进行正确完备的描述是进行转子系统设计、实施状态监测和故障诊断的关键。通过考虑驱动电机的影响,建立了异步电机-受驱转子系统的机电耦合数学模型,并利用该模型对机电转子系统由串联补偿电容和负载波动引起的两种机电耦合非平稳过程进行了数值研究。研究结果表明：建立的机电耦合模型可以多方位地研究转子系统在非平衡过程中的机电耦合动力学规律。     

Single rub-impacting periodic motions of a rigid constrained rotor system

This paper discusses the existence of single rub-impacting period-n motions for a kind of rotor systems with rigid constraints. The ranges of parameters for period-2 motions are also given. An example of this method is given.     

立式水轮发电机通风系统及转子温度场研究

本文采用有限元软件对某梯级电站立式水轮发电机通风系统进行数值模拟,在此基础上计算转子磁极各表面的散热系数,结合电机热耗,得到转子磁极温度分布.研究表明:采用CFD能较准确地模拟发电机通风系统的流场,为电机通风系统设计和优化提供有效的依据;转子磁轭端部加装弧形风扇后产生的冷却流量满足实际运行过程中电机冷却的需要;转子温度在其设计的绝缘容许温度范围内,且有足够裕度,可长期安全运行.     

一种改进的诱导因子计算方法

本文利用开发的程序,对BEM计算模型中诱导因子的计算方法进行研究.比较分析了已有几种计算方法的优劣,在此基础上提出一种改进的计算方法,并以美国可再生能源实验室(NREL)直径为10 m水平轴风力机叶片气动试验数据为依据,验证了本文算法的准确性和优越性.     

叶片数及分流叶片位置对压气机性能的影响

应用三维粘性计算程序对存在叶顶间隙泄漏时带分流叶片的离心压气机内部流动进行了数值模拟,重点分析了叶片数及分流叶片处于不同位置对压气机级内三维粘性流场及级性能的影响。计算中采用中心差分格式结合B-L代数模型使用时间推进法求解雷诺平均N—S方程。计算结果表明:叶片数增加,叶轮进口阻塞增加,压气机性能下降,但可有效降低叶轮单个叶片的载荷。分流叶片位于不同位置时,应用IBSA叶轮的压气机效率最高,压气机性能最好。