Burst event detection in wall turbulence by WVITA method

Wavelet Variable Interval Time Average (WVITA) is introduced as a method incorporating burst event detection in wall turbulence. Wavelet transform is performed to unfold the longitudinal fluctuating velocity time series measured in the near wall region of a turbulent boundary layer using hot-film anemometer. This unfolding is both in time and in space simultaneously. The splitted kinetic of the longitudinal fluctuating velocity time series among different scales is obtained by integrating the square of wavelet coefficient modulus over temporal space. The time scale that related to burst events in wall turbulence passing through the fixed probe is ascertained by maximum criterion of the kinetic energy evolution across scales. Wavelet transformed localized variance of the fluctuating velocity time series at the maximum kinetic scale is put forward instead of localized short time average variance in Variable Interval Time Average (VITA) scheme. The burst event detection result shows that WVITA scheme can avoid erroneous judgement and solve the grouping problem more effectively which is caused by VITA scheme itself and can not be avoided by adjusting the threshold level or changing the short time average interval. The project supported by the National Natural Science Foundation of China (19732005) and the National Climbing Project of China     

Head-on quenching of laminar premixed methane flames diluted with hot combustion products

Transient head-on quenching of laminar premixed methane flames diluted with hot combustion products is analyzed using full-chemistry 1D DNS. The impact of the dilution level, pressure and wall temperature on carbon monoxide (CO) emissions is investigated. Increasing dilution level and pressure reduce peak average near-wall CO concentrations, and reduce the near-wall CO reduction rate. However, the peak average near-wall CO and near-wall CO reduction rate increase with increasing wall temperature. Analysis of the species transport budget for CO near the wall before, during and after quenching indicates that there are conditions where diffusion is the dominant transport term. As a consequence, it may be possible to model the near-wall CO using only the integrated diffusion term within certain spatial regions. Dilution increases the size of these regions, whereas increasing pressure reduces this size.     

Numerical Analysis of Unsteady Magneto-Biphase Williamson Fluid Flow with Time Dependent Magnetic Field

Numerical investigation of the dusty Williamson fluid with the dependency of time has been done in current disquisition. The flow of multiphase liquid/particle suspension saturating the medium is caused by stretching of porous surface. The influence of magnetic field and heat generation/absorption is observed. It is assumed that particle has a spherical shape and distributed uniformly in fluid matrix. The unsteady two-dimensional problems are modeled for both fluid and particle phase using conservation of mass, momentum and heat transfer. The finalized model generates the non-dimensioned parameters, namely Weissenberg number, unsteadiness parameter, magnetic parameter,heat generation/absorption parameter, Prandtl number, fluid particle interaction parameter, and mass concentration parameters. The numerical solution is obtained. Locality of skin friction and Nusselt number is deliberately focused to help of tables and graphs. While inferencing the current article it is clearly observed that increment of Williamson parameter, unsteadiness parameter, magnetic parameter, volume fraction parameter, and mass concentration parameter reduces the velocity profile of fluid and solid particles as well. And increment of Prandtl number, unsteadiness parameter,volume fraction parameter, and mass concentration parameter reduces the temperature profile of fluid and solid particles as well.     

退火对钛/铜热等静压扩散连接界面的影响

钛/铜(Ti/Cu)作为ITER 第一壁Be/CuCrZr 热等静压连接中间过渡层,形成了多层中间金属相结构,容易在Ti/Cu 金属相之间产生裂纹等缺陷。采用CuCrZr 代替Be,经过与Be/CuCrZr 相同的热等静压工艺,制作了多个CuCrZr/Ti/Cu/CuCrZr 连接件,对Ti/Cu 连接接头进行深入分析。对连接件分别进行未退火、400℃和500℃ 退火处理,去应力退火后对接头强度和缺陷分布的影响进行了研究。研究结果表明,中间钛层的两侧都形成了三层Ti/Cu 扩散层,分别为Cu₄Ti、CuTi 和CuTi₂。纯铜侧的Cu₄Ti 厚度比CuCrZr 侧的厚,使得裂纹几乎全部分布于铜侧的Cu₄Ti 与CuTi 交界处,拉伸样品极易在此处发生脆性断裂。随着退火温度升高,裂纹的产生和扩展减少。     

Dripping retardation with corrugated ceiling

The instabilities of a pendent viscous thin film underneath two corrugated ceilings are studied numerically and theoretically in comparison with the case of a flat wall. With the same initial interface perturbations, it is shown numerically that both the supercritical instability and the subcritical instability can be retarded by the in-phase corrugated ceilings. The lubrication approximation is used to explain the retardation effect of the corrugated ceiling on the supercritical instability of the pendant film, where the linear growth rate is revealed to be power three of the initial film thickness.     

��ʪ�Լ��ų���Һ̬�������ɱ���Ĥ������״̬��Ӱ��

通过数值模拟及实验研究了润湿性及磁场对液态金属膜流流动状态的影响.首先,通过数值模拟研究了润湿性对膜流流动状态的影响.结果表明,当润湿性不好时,液态金属膜流容易发展为溪状流而不能完全覆盖底壁,入口膜厚较薄时更易发展为溪状流;在入口膜厚及其它情况相同时,密度越小越易发展为溪状流.其次,研究了磁场对膜流流动状态的影响.结果表明,槽道与流体润湿性不好时,有磁场情况下液态金属膜流覆盖底壁的区域较无磁场时增加,强磁场对膜流的湍流有抑制作用.最后,液态金属膜流实验结果表明,润湿性不好时,镓铟锡合金膜流容易收缩发展为溪状流,这与数值模拟的结果是一致的.上述研究结果对磁约束聚变堆液态第一壁的设计具有指导意义.     

HL-2A偏滤器沉积测量系统的研制

为了检测HL-2A偏滤器靶板的背后沉积层的沉积情况和深入了解其等离子体与第一壁的相互作用过程,国内首次研制了用于托卡马克装置的偏滤器沉积测量系统,其中包括石英晶体、测量探头、频率测量以及控制系统等。经过初步检测,该沉积系统平均采样速率为13~14s^-1;测量的石英晶体共振频率分辨率为0.01Hz;石英晶体共振频率的变化正比于沉积在石英晶体表面的质量的变化,这与Sauerbrey方程的线性关系吻合;实验室检测过程中该沉积系统的平均沉积率约为2.0ng•s^-1,显示该沉积系统具有纳克级质量检测能力,表明了该偏滤器沉积系统的测量性能和有效性。     

Vortex shedding around a near-wall circular cylinder induced by a solitary wave

This study developed a two-dimensional generalized vortex method to analyze the shedding of vortices and the hydrodynamic forces resulting from a solitary wave passing over a submerged circular cylinder placed near a flat seabed. Numerical results for validation are compared with other numerical and experimental results, and satisfactory agreement is found. A series of simulations were performed to study the effects of gap-to-diameter ratio and incident wave height on vorticity pattern as well as the forces exerted on the cylinder. The range of the heights of incident waves is from 0.3h to 0.7h, where h is the still water depth. The range of the gap-to-diameter ratios is from 0.1 to 0.8. The results indicate that the flow pattern and the pressure distribution change significantly because of the close proximity of the seabed where the vorticity flux on the seabed-side surface of the cylinder is suppressed. Placing the cylinder nearer the seabed increases the drag and the positive lift on the cylinder. When the gap-to-diameter ratio increases, the pattern of vortices changes because of the interaction between the main recirculation zone and the shear layers separated from the gap. The maxima of drag, lift and total force increase linearly with the height of the incident wave.     

边孔弧形闸门水流脉动压力特性研究

弧形泄水闸是水利枢纽工程中常见的挡水、泄水建筑物,其在关闭或开启过程中或者局部开启运行时,在水流脉动压力作用下会产生振动,容易引起闸门结构破坏。本文针对边孔闸门与中孔闸门不同的水流边界条件特点,制作了带导流墙与无导流墙两个弧形闸门模型。在实验室内开展了不同库水位、不同闸门开度下的物理模型试验,并对两个模型上大量测点的水流脉动压力数据进行比较分析。试验表明,导流墙的存在对脉动压力主频的影响较小,但对脉动压力均方根值影响较大;在较高库水位下相对开度位于0.2至0.3区间内时,导流墙的存在不但不会改善闸门的受力状况,反而还会导致受力增强。     

15×10~4m~3超大型油罐应力测试与数值模拟分析

兰州原油末站大型油罐群,是我国首次在饱和黄土地基修建的大型储油设施。依托其中一座15×104 m3超大型非锚固油罐,开展了现场充水测试罐壁静态应力的试验研究。通过粘贴在油罐罐壁的应变计,测试充水过程中罐壁应力的变化规律,并采用有限元对15×104 m3超大型油罐进行应力分析。测试结果表明:罐壁的环向应力随充水水位的增加基本呈线性关系。数值模拟计算表明,罐壁环向应力最大值发生在第二圈罐壁和第三圈罐壁相连接的位置。由于罐壁上部设置了抗风圈和加强圈,有效地控制了罐壁的径向位移,使罐壁环向应力和竖向轴向应力在加强圈和抗风圈附近发生波动。将有限元数值模拟计算的罐壁环向应力分布情况与实测应力进行比较,两者总体吻合较好。上述研究结果可为超大型储罐在黄土地基的设计和建造提供技术依据和设计参数验证。