低速二维流动的粒子仿真研究

本文运用信息保存法对低速二维的流动现象进行模拟，考察了低速条件下的有限平板绕流以及微槽道气体流动问题。研究表明：在对低速流动的模拟过程中，运用IP法在能够获得较好的结果的同时，具有比DSMC方法更高的计算效率。     

In‐line monitoring of UV photopolymerization with a quartz crystal resonator

An in‐line monitoring device using a quartz crystal resonator for thin film polymerization was proposed, and its performance has been evaluated by implementing in the UV polymerization of 2‐hydroxyethyl methacrylate with a photoinitiator of 1‐chloroanthraquinone. Because the variation of resonant resistance of the resonator is proportional to the square root of viscosity change that is closely related to the polymerization degree, the resistance can be used as a measure of the polymerization degree. The resistance measurements were compared with the outcome of instrumental analyses of polymerization degree using an FTIR spectrometer and a gel permeation chromatograph. The experimental results showed that the resistance measurements were consistent with the experimental outcome of the instrumental analyses, and this indicates the effectiveness of the proposed device. Owing to the simplicity and availability of the resonator system, its wide utilization in the monitoring of a variety of film polymerization processes, including photoresistor application, is expected. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2428–2439, 2006     

Differential AC-chip calorimeter for glass transition measurements in ultrathin films

A differential AC-chip calorimeter capable of measuring the step in heat capacity at the glass transition in nanometer-thin films is described. Because of the differential setup, pJ/K sensitivity is achieved. Heat capacity can be measured for sample masses below 1 ng in broad temperature range as needed for the study of the glass transition in nanometer-thin polymeric films. Relative accuracy is sufficient to investigate the changes in heat capacity as the step at the glass transition of polystyrene. The step is about 25% of the total heat capacity of polystyrene. The calorimeter allows for the frequency dependent measurement of complex heat capacity in the frequency range from 1 Hz to 1 kHz. The glass transition in thin polystyrene films (50–4 nm) was determined at well-defined experimental time scales. No thickness dependency of the glass transition temperature was observed within the error limits (±3 K)—neither at constant frequency (40 Hz) nor for the trace in the activation diagram (1 Hz–1 kHz). © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 2996–3005, 2006     

Preparation and characterization of mesoporous silica thin films from polyethoxysiloxanes

Tetraethoxysilane (TEOS) and polyethoxysiloxanes (PEOSs; prepared by the acid‐catalyzed hydrolytic polycondensation of TEOS) were subjected to the sol–gel process in the presence of cetyltrimethylammonium bromide (CTAB), respectively. The PEOSs with M_w 700–26,000, as prepared by sol–gel coating of TEOS and PEOS under various conditions, were used. Uniform and crack‐free thin films of thickness 276–613 nm were prepared by spin‐coating of a PEOS solution containing CTAB. When the coating films were sintered at 400 °C, the combustion of ethoxy groups and CTAB took place to provide porous silica thin films. The structure of the thin films was found to be dependent on the molecular weight of PEOS and the molar ratio of CTAB/Si: lamellar or hexagonal phase was observed for M_w less than 15,000 and for CTAB/Si molar ratios greater than 0.10. Honeycomb structures were observed for M_w less than 5000 and for CTAB/Si molar ratios of 0.15. The honeycomb structure was also observed by atomic force microscopy and transmission electron microscope. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 2542–2550, 2006     

四元缔合物体系薄层树脂相分离与光度法联用测定痕量钴

提出了在酸性条件下 (pH=5.0),利用阳离子交换树脂-丁二酮肟-碘-钴四元体系,通过薄层树脂相光度法测定钴的新方法。本法灵敏度高 (e454=1.7105L/molcm),比水相光度法提高14倍,精密度理想 (测定2.0礸/ml Co(II) 6次,RSD=1.3%),选择性好。实测药品VB12及天然水中钴,线性范围0.024~2.0礸/ml (定容50ml),检出限10.4ng/ml。     

Matrix-isolation-FTIR spectroscopy with an integrating sphere

The use of an integrating sphere for the measurement of absorption spectra of thin films is described. The thin film (for example a rare gas matrix) is grown directly on the inside surface of the sphere. Multiple reflections inside the integrating sphere lead to significant enhancement of weak absorptions of the film, increasing the sensitivity of such measurements.     

Thermoanalytical methods in the study of inorganic thin films

Thermoanalytical (TA) methods are relatively seldom applied for assessing the physical and chemical proeprties of thin films, but they can be used in studies of composition, phase transitions and film—substrate interactions. In the present paper the possibilities of TA methods in thin film studies are reviewed. The thermoanalytical methods considered are the classical TG and DTA/DSC methods but some complementary methods will also be briefly mentioned. The main emphasis is given to true thin films. Details of sample preparation are also given. An important application of TA methods is characterization of precursors for the CVD growth of thin films, and this is also discussed.     

Surfactant in the gaseous phase II. Influence on stability of foams and thin liquid films

The influence of the vapors ofn-amyl orn-decyl alcohol on the stability of single thin liquid films, single bubbles, and foam columns was determined. It was found that the presence of surfactant vapors lowered the stability of foams and single foam films. The mechanism of the destabilizing action of the surfactant vapors on wet, dynamic foams under dynamic conditions is discussed. It is shown that the destabilizing action of the surfactant vapors is a further indication that surface elasticity forces are the main factor determining stability of wet, dynamic foams.     

Sol-Gel Synthesis of Humidity-Sensitive P2O5-SiO2 Amorphous Films

The sol-gel synthesis of silicophosphate gels using phosphoryl chloride and tetraethoxysilane as molecular precursors is reported and discussed. Gel-derived glasses and films having the molar compositions 10P₂O₅ · 90SiO₂ and 30P₂O₅ · 70SiO₂ have been obtained. The structure of the dried gels as well as the structural modifications that occurs during the transformations in gel-derived glasses are analyzed by Fourier transform infrared spectroscopy (FTIR). It has been found that the evidence of the P—O—Si linkages begins to appear only on the FTIR spectra of the bulk gels heat treated up to 400°C while they are well resolved on the FTIR spectra of the bulk gel samples heated up to 1000°C indicating that at this temperature the transformation in the corresponding gel-derived glasses occurs. The humidity sensitive properties of the gel-films have been evaluated by electrochemical impedance spectroscopy (EIS). The phosphorous content as well as the temperature of the heat treatments strongly affect the sensitivity to RH of the gel-derived films.